Rheological behaviour and adsorption phenomenon of a polymer-particle composite based on hydrolysed polyacrylamide/functionalized poly(styrene-acrylic acid) microspheres

Assessment of modified chitosan composite in acidic reservoirs through pilot and field-scale simulation studies

Chemical flooding through biopolymers acquires higher attention, especially in acidic reservoirs. This research focuses on the application of biopolymers in chemical flooding for enhanced oil recovery in acidic reservoirs, with a particular emphasis on modified chitosan. The modification process involved combining chitosan with vinyl/silane monomers via emulsion polymerization, followed by an assessment of its rheological behavior under simulated reservoir conditions, including salinity, temperature, pressure, and medium pH. Laboratory-scale flooding experiments were carried out using both the original and modified chitosan at conditions of 2200 psi, 135,000 ppm salinity, and 196° temperature. The study evaluated the impact of pressure on the rheological properties of both chitosan forms, finding that the modified composite was better suited to acidic environments, showing enhanced resistance to pressure effects with a significant increase in viscosity and an 11% improvement in oil recovery over the 5% achieved with the unmodified chitosan. Advanced modeling and simulation techniques, particularly using the tNavigator Simulator on the Bahariya formations in the Western Desert, were employed to further understand the polymer solution dynamics in reservoir contexts and to predict key petroleum engineering metrics. The simulation results underscored the effectiveness of the chitosan composite in increasing oil recovery rates, with the composite outperforming both its native counterpart and traditional water flooding, achieving a recovery factor of 48%, compared to 39% and 37% for native chitosan and water flooding, thereby demonstrating the potential benefits of chitosan composites in enhancing oil recovery operations.

NMR investigation on the thermogelation of partially hydrolysed polyacrylamide/polyethylenimine mixtures

Since the introduction of polyethylenimine (PEI)/acrylamide-based polymer gel systems in the late 90's, the literature knowledge on the crosslinking mechanisms between the various polymers (PAM, PHPA, and PatBA) and the crosslinker (PEI) was only limited to observations on gelation times and gel strength variations compared to other gel systems. In this paper, classic proton and carbon nuclear magnetic resonance "NMR" experiments and advanced 2D DOSY and NOESY techniques were employed for studying the interactions between the amine groups of PEI and amide or carboxylate groups of partially hydrolysed polyacrylamide (PHPA). Among the many possibilities, we showed that the interaction occurring during thermogelation is mainly due to covalent bonding. The latter results from a transamidification reaction between the polymer amide groups and the primary amines of the crosslinker. The reaction, at high temperatures, was accompanied by some hydrolysis of the polymer amide groups. Consequently, the kinetics of the reaction and hydrolysis were evaluated and fitted using pseudo first-order equations where the hydrolysis kinetics was found to be three times lower than that of the reaction.