Synthesis of new multivalent metal ion functionalized mesoporous silica and studies of their enhanced antimicrobial and cytotoxicity activities

Function of Brønsted and Lewis acid sites in xylose conversion into furfural

In this work, the xylose conversion and the selectivity to furfural were assessed over mesoporous sulfonic silica SBA-15-(X)SO3H catalysts doped with metal ions (X = Al(iii), Ti(iv) or Zr(iv)). The type and amount of acid sites were analyzed by adsorption of pivalonitrile. The SBA-15-(X)SO3H materials show Lewis acid sites (LAS) and two types of Brønsted acid sites (BAS) with different strengths. Type I (BAS I) belongs to terminal silanol groups, type II (BAS II) is ascribed to hydroxyl groups bonded to sulfur or transition metal, and the LAS is related to M-O bonds. Optimal reaction conditions for the most active catalyst (SBA-15-(Zr)SO3H) were 120 minutes of reaction at 160 °C, 20 wt% of catalyst, and 2.5% of xylose/solvent. Additionally, a kinetic study was carried out to calculate the rate constants, the activation energy, and the pre-exponential factor for the xylose dehydration reaction. It was found that the selectivity to furfural in sulfonic silica SBA-15-(X)SO3H catalysts was directly related to the BAS II fraction. While LAS negatively impacts the selectivity to furfural leading to the undesired reaction between furfural and xylose obtaining humins as secondary products.

Possibility of Advanced Modified-Silica-Based Porous Materials Utilisation in Water Adsorption Processes—A Comparative Study

Due to a high risk of power outages, a heat-driven adsorption chillers are gaining the attention. To increase the efficiency of the chiller, new adsorbents must be produced and examined. In this study, four newly developed silica–based porous materials were tested and compared with silica gel, an adsorber commonly paired with water. Extended sorption tests using mercury intrusion porosimetry, gas adsorption, and dynamic vapor sorption were performed. The morphology of the samples was determined using a scanning electron microscope. The thermal properties were defined using simultaneous thermal analysis and a laser flash method. Metal organic silica (MOS) nanocomposites analysed in this study had thermal properties similar to those of commonly used silica gel. MOS samples have a thermal diffusivity coefficient in the range of 0.17–0.25 mm2/s, whereas silica gel of about 0.2 mm2/s. The highest water adsorption capacity was measured for AFSMo-Cu and equal to 33–35%. For narrow porous silica gel mass uptake was equal about 25%. In the case of water adsorption, it was observed that the pore size of the sorbent is essential, and adsorbents with pore sizes higher than 5 nm, are most recommended in working pairs with water.

Simultaneous photocatalytic reduction of hexavalent chromium and oxidation of p-cresol over AgO decorated on fibrous silica zirconia

The co-existence of heavy metals and organic compounds including Cr(VI) and p-cresol (pC) in water environment becoming a challenge in the treatment processes. Herein, the synchronous photocatalytic reduction of Cr(VI) and oxidation of pC by silver oxide decorated on fibrous silica zirconia (AgO/FSZr) was reported. In this study, the catalysts were successfully developed using microemulsion and electrochemical techniques with various AgO loading (1, 5 and 10 wt%) and presented as 1, 5 and 10-AgO/FSZr. Catalytic activity was tested towards simultaneous photoredox of hexavalent chromium and p-cresol (Cr(VI)/pC) and was ranked as followed: 5-AgO/FSZr (96/78%) > 10-AgO/FSZr (87/61%) > 1-AgO/FSZr (47/24%) > FSZr (34/20%). The highest photocatalytic activity of 5-AgO/FSZr was established due to the strong interaction between FSZr and AgO and the lowest band gap energy, which resulted in less electron-hole recombination and further enhanced the photoredox activity. Cr(VI) ions act as a bridge between the positive charge of catalyst and cationic pC in pH 1 solution which can improve the photocatalytic reduction and oxidation of Cr(VI) and pC, respectively. The scavenger experiments further confirmed that the photogenerated electrons (e^-) act as the main species for Cr(VI) to be reduced to Cr(III) while holes (h⁺) and hydroxyl radicals are domain for photooxidation of pC. The 5-AgO/FSZr was stable after 5 cycles of reaction, suggesting its potential for removal of Cr(VI) and pC simultaneously in the chemical industries.

Hybrid silver-gold nanoparticles suppress drug resistant polymicrobial biofilm formation and intracellular infection

Over decades bacteria have evolved multiple mechanisms to fight antibiotics. Biofilm formation by bacteria is one such mechanism as it forms a barrier and creates an acidic environment that reduces the efficiency of antimicrobials. Bacteria have also developed the ability to persist intracellularly within mammalian cells, causing recurrent infections. Many antibiotics are rendered ineffective due to poor penetration across biofilms and within mammalian cells. In this study, silver-gold hybrid nanoparticles were developed as anti-microbial agents to combat biofilm formation and intracellular infections. Biogenic hybrid silver gold nanoparticles were developed in an organic solvent free single reaction mixture using quercetin, a flavonoid, as the reducing and stabilizing agent. Silver-gold nanoparticles of 40 ± 10 nm diameter were effective against a broad spectrum of bacteria with minimum bactericidal concentrations of 10 μg ml-1 and 20 μg ml-1 for Gram negative and Gram-positive organisms, respectively. These nanoparticles were also effective against mixed infections at 20 μg ml-1. Their mode of action involves generating intracellular oxidative stress in both Gram negative and Gram-positive bacteria, which causes damage to the cell wall. Polymicrobial biofilm formation was suppressed and intracellular infection was reduced by 70% to 90% in fibroblast and monocyte cell lines. These results indicate that hybrid silver gold nanoparticles are promising agents to suppress biofilm formation and tackle intracellular infections.

Carbonic anhydrase inhibition, antioxidant activity against alveolar epithelial cells and antibacterial effect against Klebsiella pneumoniae enabled by synthesized silica nanoparticles through laser ablation technique

Silica (SiO₂) nanoparticles (NPs) were synthesized by laser ablation method and were characterized by TEM and DLS techniques. Afterwards, their inhibition activity against carbonic anhydrase (CA) isoforms (CA I and CA II) was explored by experimental and theoretical analysis. Also, the protective effect of SiO₂ NPs against H₂O₂-induced oxidative stress in alveolar epithelial cells (A549) were assessed by measurement of MTT, ROS level, CAT and SOD activity and GSH content. Finally, the NPs were screened for their antimicrobial activity using the MICs method against the Klebsiella pneumoniae. The result showed that the synthesized NPs have a size of around 40 nm. The inhibition activity by comparing IC50 values with acetazolamide as a positive control revealed that SiO₂ NPs in comparison with acetazolamide served as potent inhibitors against CA isoforms which was also confirmed by docking studies. The cellular assays indicated that the SiO₂ NPs with a concentration of 20 μg/mL stimulated a significant antioxidant activity against H₂O₂-induced oxidative cell damage through activation of CAT and SOD, an increase in the GSH content and reducing the level of ROS. The synthesize NPs also showed a good inhibition effect against Klebsiella pneumoniae as compared to Sulfamethoxazole as a positive control. In conclusion, this data may provide some useful information on the development of some platforms for pneumonia treatment and management.