Advances in polymer-based detection of environmental ibuprofen in wastewater

Globally, ibuprofen is the third most consumed drug and its presence in the environment is a concern because little is known about its adverse effects on humans and aquatic life. Environmentalists have made monitoring and the detection of ibuprofen in biological and environmental matrices a priority. For the detection and monitoring of ibuprofen, sensors and biosensors have provided rapid analysis time, sensitivity, high-throughput screening, and real-time analysis. Researchers are increasingly seeking eco-friendly technology, and this has led to an interest in developing biodegradable, bioavailable, and non-toxic sensors, or biosensors. The integration of polymers into sensor systems has proven to significantly improve sensitivity, selectivity, and stability and minimize sample preparation using bioavailable and biodegradable polymers. This review provides a general overview of perspectives and trends of polymer-based sensors and biosensors for the detection of ibuprofen compared to non-polymer-based sensors.

Superhydrophilic polyethersulfone (PES) membranes with high scale inhibition properties obtained through bionic mineralization and RTIPS

Reverse thermally induced separation (RTIPS) was used to obtain a separation membrane with a better internal structure for a higher water flux and a surface that could easily form a hydration layer. In comparison to the traditional modification method, this work focused on the aspect that the internal structure obtained by changing the membrane-making method provided easier adhesion conditions for the dopamine/TiO₂ hybrid nanoparticles (DA/TiO₂ HNPs) obtained by biomimetic mineralization. It provided a basis for exploring the variation in adhesion with the water bath temperature and the amount of titanium added through the study of turbidity point, SEM images, water contact angle, thermogravimetric test, EDX, AFM, XPS, FTIR and other test results. The SEM images proved that the membrane obtained through the RTIPS method had a porous surface and spongy internal structure, furthermore, additional polymers were adsorbed. Use of EDX demonstrated that biomimetic mineralization prevented the production of agglomerated titanium dioxide. XPS and FTIR spectra confirmed the introduction and immobilization of HNP aggregation. Moreover, a decrease in the surface roughness and water contact angle further suggested an improvement in the hydrophilicity of the modified membrane. The introduction of HNP at a higher water bath temperature helped increase the water flux up to ten times, moreover, the oil-water separation efficiency could still reach over 99.50%. Lastly, a cycle test of the modified membrane under the optimal conditions helped confirm that the membrane forming conditions at this time could provide a better environment for the formation of the hydrophilic layer, which was conducive to the recycling of the separation membrane. In summary, more fixed more hydrophilic particles could be obtained through the RTIPS method based on biomimetic mineralization to prevent the accumulation of titanium dioxide, thus helping improve permeability and anti-fouling of the membrane.

Recent Advances in Molecularly Imprinted Membranes for Sample Treatment and Separation

This review describes the recent advances from the past five years concerning the development and applications of molecularly imprinted membranes (MIMs) in the field of sample treatment and separation processes. After a short introduction, where the importance of these materials is highlighted, a description of key aspects of membrane separation followed by the strategies of preparation of these materials is described. The review continues with several analytical applications of these MIMs for sample preparation as well as for separation purposes covering pharmaceutical, food, and environmental areas. Finally, a discussion focused on possible future directions of these materials in extraction and separation field is also given.

Polydopamine Microsphere-Incorporated Electrospun Fibers as Novel Adsorbents for Dual-Responsive Adsorption of Methylene Blue

The usually inconvenient detection and uneasy recycling of polydopamine (PDA) with sphere morphology as an adsorbent restrict its actual applications in wastewater purification. Thus, novel composite fibers were fabricated via the electrospinning technique by integrating polydopamine microspheres (PDA-MPs) with pH/temperature dual-responsive copolymers. The insoluble fraction of the fabricated composite fibers can be maintained to a value above 89% after being immersed in aqueous solutions with different pH values. Also, the regeneration efficiency of the composite fibers can also remain above 80% after undergoing five adsorption-desorption cycles. These results both indicated that the fabricated composite fibers can avoid secondary pollution during the adsorption process effectively. In addition, the presence of abundant N-isopropyl acrylamide (NIPAM) units within the fibers could make it have a relatively higher water swelling ability of 4643%, which could further offer relatively larger inner spaces to accommodate the dye molecules. Meanwhile, by incorporating β-cyclodextrin (β-CD), methacrylic acid (MAA), PDA, and NIPAM components, plentiful active adsorption sites could be supplied to interact with methylene blue (MB) dye. So, the adsorption experiments of the composite fibers showed a maximum adsorption capacity of 1722.1 mg/g at pH 9.0 and a temperature of 55 °C. Furthermore, the pseudo-second-order kinetic model of adsorption suggested that it is a chemisorption process. Moreover, the adsorption experimental data can be better described by Langmuir models, inferring its monolayer adsorption. The adsorption thermodynamic studies revealed that adsorption is a spontaneous and endothermic process. Also, the increase of temperature facilitated the adsorption processes, owing to the increase of adsorbent's hydrophobicity and molecules' reactivity. The present work suggested that the combination of smart-responsive polymers and PDA-MPs could form an unprecedented system to be a promising candidate adsorbent for wastewater treatment.