Power-dependent photophysical pathways of upconversion in BaTiO3:Er3

Optical Properties and Concentration Quenching Mechanism of Er3+ Heavy Doped Gd2(MoO4)3 Phosphor for Green Light-Emitting Diode

Upconversion materials capable of converting low-energy excitation photons into high-energy emission photons have attracted considerable interest in recent years. However, the low upconversion luminescence seriously hinders the application of upconversion phosphors. Heavy lanthanide doping without concentration quenching represents a direct and effective method to enhance the emission intensity. In this study, Er³⁺ heavy doped Gd₂(MoO₄)₃ phosphor with a monoclinic phase was prepared by a sol-gel process. Under excitation at 976 nm, Gd₂(MoO₄)₃:Er³⁺ phosphor emitted remarkably intense green emission, and Er³⁺ concentration up to 20 mol% did not cause concentration quenching. Here, we discuss the upconversion mechanism and concentration quenching. When the Er³⁺ concentration was in the range of 30-60 mol%, the concentration quenching was governed by the electric dipole-dipole interaction, and when the concentration was greater than 60 mol%, the concentration quenching was controlled by the exchange interactions. The result provides a schematic basis for identifying a phosphor host with heavy lanthanide doping.

Optical Properties and Upconversion Luminescence of BaTiO3 Xerogel Structures Doped with Erbium and Ytterbium

Erbium upconversion (UC) photoluminescence (PL) from sol-gel derived barium titanate (BaTiO₃:Er) xerogel structures fabricated on silicon, glass or fused silica substrates has been studied. Under continuous-wave excitation at 980 nm and nanosecond pulsed excitation at 980 and 1540 nm, the fabricated structures demonstrate room temperature PL with several bands at 410, 523, 546, 658, 800 and 830 nm, corresponding to the ²H_9/2 → ⁴I_15/2, ²H_11/2 → ⁴I_15/2, ⁴S_3/2 → ⁴I_15/2, ⁴F_9/2→ ⁴I_15/2 and ⁴I_9/2→ ⁴I_15/2 transitions of Er³⁺ ions. The intensity of erbium UC PL increases when an additional macroporous layer of strontium titanate is used beneath the BaTiO₃ xerogel layer. It is also enhanced in BaTiO₃ xerogel films codoped with erbium and ytterbium (BaTiO₃:(Er,Yb)). For the latter, a redistribution of the intensity of the PL bands is observed depending on the excitation conditions. A multilayer BaTiO₃:(Er,Yb)/SiO₂ microcavity structure was formed on a fused silica substrate with a cavity mode in the range of 650–680 nm corresponding to one of the UC PL bands of Er³⁺ ions. The obtained cavity structure annealed at 450 °C provides tuning of the cavity mode by 10 nm in the temperature range from 20 °C to 130 °C. Photonic application of BaTiO₃ xerogel structures doped with lanthanides is discussed.