Amplifying Flutamide Sensing through the Synergetic Combination of Actinidia-Derived Carbon Particles and WS2 Platelets

The development of electrochemical sensors for flutamide detection is a crucial step in biomedical research and environmental monitoring. In this study, a composite of Actinidia-derived carbon particles (CPs) and tungsten disulfide (WS2) was formed and used as an electrocatalyst for the electrochemical detection of flutamide. The CPs had an average diameter of 500 nm and contained surface hydroxyl and carbonyl groups. These groups may help anchor the CPs onto the WS2 platelets, resulting in the formation of a CPs-WS2 nanocomposite with a high surface area and a conducting network, enabling electron transfer. Using the CPs-WS2 composite supported at a glassy carbon electrode, a linear concentration range extending from 1 nM to 104 μM, a limit of detection of 0.74 nM, and a sensitivity of 26.9 ± 0.7 μA μM-1 cm-2 were obtained in the detection of flutamide in a phosphate buffer. The sensor showed good recovery, ranging from 88.47 to 95.02%, in river water samples, and exhibited very good selectivity in the presence of inorganic ions, including Al3+, Co2+, Cu2+, Fe3+, Zn2+, NO3 -, SO4 2-, CO3 2-, and Cl-.

Self assembled three dimensional β-Cu2V2O7 hierarchical flower decorated porous carbon: An efficient electrocatalyst for flutamide detection in biological and environmental samples

The serious situation mandates the use of anticancer drugs, which protect people all over the world from the growth of prostate cancer. In particular, excessive dosage and erroneous discharge of flutamide concentration cause make environmental pollution on the surface of the wastewater. In this study, the highly sensitive and selective electrochemical approach based on copper vanadium oxide decorated porous carbon (denoted as β-Cu₂V₂O₇/PC) composite modified glassy carbon electrode (GCE) has been developed and it was applied for sensitive detection of anticancer drug flutamide (FTM). Moreover, using the co-precipitation method, the flower-like β-Cu₂V₂O₇ hierarchical microstructure was synthesized, and through the wet chemical process, the β-Cu₂V₂O₇/PC composite was obtained. The resultant product was characterized by XRD, FTIR, RAMAN, XPS and structural morphology established by FESEM analysis. Besides that, the electrochemical characterization and properties were analyzed by cyclic voltammetry (CV) and amperometric (i-t) techniques. The β-Cu₂V₂O₇/PC/RDGCE had two linear ranges at 0.01-2.11 μM and 2.31-30.81 μM. The lower limits of detection and sensitivity were found at 0.62 nM (S/N = 3), and 24.33 μA μM^-1 cm^-2 respectively. The practicability test was applied for the determination of FTM in urine, blood serum and environmental aquatic fluid with satisfactory recovery obtained.