Role of H+ in Solvent Extraction of Am(III) and Eu(III) Using a Polydentate Bipyridine N-,O-Donor Ligand: Chemical Equilibrium States and Kinetic Aspects

In this work, the influence of protonation on the kinetics and thermodynamics of extraction of the Am/Eu pair using N-heterocyclic dicarboxylic acid diamide N,N'-diethyl-N,N'-bis(4-ethylphenyl)-[2,2'-bipyridine]-6,6'-dicarboxamide (L) was investigated. The extraction efficiency of the ligand did not decrease, even at a nitric acid concentration 4 times higher than that of the ligand in the organic phase. X-ray diffraction analysis established that protonation leads to the preorganization of the ligand due to the reversal of bipyridyl rings into the binding conformation when both nitrogen atoms are turned to one side. Also, the effect of protonation on the chemical shifts of the functional binding groups (bipyridyl and amide) in solution was demonstrated by NMR spectroscopy. However, the presaturation of the organic phase with nitric acid did not lead to significant changes in the surface activity of the ligand. For extraction kinetics, a mechanism was proposed in which protonation and preorganization of the ligand was the limiting stage.

Progress in phenanthroline-derived extractants for trivalent actinides and lanthanides separation: where to next?

Spent nuclear fuel (SNF) released from reactors possesses significant radioactivity, heat release properties, and high-value radioactive nuclides. Therefore, using chemical methods for reprocessing can enhance economic efficiency and reduce the potential environmental risks of nuclear energy. Due to the presence of relatively diffuse f-electrons, the chemical properties of trivalent lanthanides (Ln(III)) and actinides (An(III)) in SNF solutions are quite similar. Separation methods have several limitations, including poor separation efficiency and the need for multiple stripping agents. The use of novel multi-dental phenanthroline-derived extractants with nitrogen donor atoms to effectively separate An(III) over Ln(III) has been widely accepted. This review first introduces the development history of phenanthroline-derived extractants for extraction and complexation with An(III) over Ln(III). Then, based on structural differences, these extractants are classified into four categories: nitrogen-coordinated, N,O-hybrid coordinated, highly preorganized structure, and unsymmetric structure. Each category's design principles, extraction, and separation performance as well as their advantages and disadvantages are discussed. Finally, we have summarized and compared the unique characteristics of the existing extractants and provided an outlook. This work may offer a reliable reference for the precise identification and selective separation between An(III) and Ln(III), and point the way for future development and exploration.

Kinetic features of solvent extraction by N,O-donor ligands of f-elements: a comparative study of diamides based on 1,10-phenanthroline and 2,2'-bipyridine

A variant of microfluidic setup design for the study of extraction kinetics has been proposed. Mass transfer constants for Am(III) and Eu(III) and observed rate constants were obtained for N-,O-donor ligands featuring phenanthroline and bipyridyl cores. The possibility of determining rate constants for cations independently of each other makes it possible to observe the kinetic effect of separation. The extraction rate was found to be lower for the bipyridyl ligand, compared to phenanthroline. The values of the rotation barriers for the ligands were calculated using the DFT method. The values correlate with the obtained low extraction rate for the bipyridyl ligand. Also, crystallographic data showing anti-conformation for the bipyridyl ligand align with the kinetic data. Surface tension was also determined for the systems with the studied ligands. It is shown that at equal ligand concentrations, the value of surface tension agrees with the extraction rate. Furthermore, it is shown that for the bipyridyl ligand, prior contact of the organic phase with nitric acid significantly affects the surface tension.

Theoretical investigation on the ligands constructed from phenanthroline and five-membered N-heterocyclic rings for bonding and separation properties of Am(III) and Eu(III)

The ligands, derived from the combination of phenanthroline and various five-membered N-heterocyclic rings, were subject to a comprehensive investigation for their potential in the extraction and separation of actinides and lanthanides. This study employed DFT methods to thoroughly explore the properties of both phenanthroline (Ph) and the diverse five-membered N-heterocyclic rings (R1-R8). Additionally, tridentate ligands RlPh (l = 1-8) and tetradentate ligands RlPhRr (l, r = 1-8) were analyzed in detail, encompassing their electrostatic potential (ESP), protonation energy, coordination bonding with the metals Am(III) and Eu(III), and the thermodynamics of extraction separation for Am(III) and Eu(III). The findings highlight that the electrostatic potential (ESP) and binding capabilities of the five-membered N-heterocyclic ring units serve as effective predictors for the properties of intricate tridentate and tetradentate ligands, as well as their coordination bonding affinity with metals. The ligands' binding energy is closely associated with their ESP, and notably, the binding energy of tridentate and tetradentate ligands correlates well with the binding energies of their constituent structural units. The computational results reveal that the R2 unit, along with its corresponding tridentate ligand R2Ph and tetradentate ligands R2PhRr, exhibits the highest ESP, superior binding energies, and the strongest coordination bonding affinity with the metals. The theoretical calculations further identify several promising extractants for the effective separation of Am(III) and Eu(III). The tridentate ligands R1Ph, R7Ph, and R4Ph, and the tetradentate ligands R4PhR4, R6PhR6, R2PhR2, R1PhR5 and R3PhR6 were identified as having excellent separation performance for Am(III) and Eu(III). This study would provide insights for the design of extractants for the separation of Am(III) and Eu(III) by use of five-membered N-heterocyclic rings as structural units.

Why trans and not cis? – Molecular Dynamics and DFT study on selective separation of dihaloethene isomers using perethylated pillar[5]arene

The separation of mixtures of isomers is a daunting task. It is found that perethylated pillar[5]arene can separate trans-dichloroethene from its cis isomer. This work deals with the host-guest interactions...