Rapid green-synthesis of TiO2 nanoparticles for therapeutic applications

Nanotechnology-based delivery systems to overcome drug resistance in cancer

Cancer nanomedicine is defined as the application of nanotechnology and nanomaterials for the formulation of cancer therapeutics that can overcome the impediments and restrictions of traditional chemotherapeutics. Multidrug resistance (MDR) in cancer cells can be defined as a decrease or abrogation in the efficacy of anticancer drugs that have different molecular structures and mechanisms of action and is one of the primary causes of therapeutic failure. There have been successes in the development of cancer nanomedicine to overcome MDR; however, relatively few of these formulations have been approved by the United States Food and Drug Administration for the treatment of cancer. This is primarily due to the paucity of knowledge about nanotechnology and the fundamental biology of cancer cells. Here, we discuss the advances, types of nanomedicines, and the challenges regarding the translation of in vitro to in vivo results and their relevance to effective therapies.

An emerging expanse: Novel and eco-friendly-biogenic synthesis of E. cardamomum-wrapped TiO2 nanoparticles for environmental and biological applications

The present research is targeted at E. cardamomum-derived TiO2-photocatalyst synthesis, reporting for the first time. The structural properties observed from the XRD pattern reveal that EC:TiO2 has an anatase phase and crystallite size is assessed by Debye-Scherrer's method (3.56 nm), WH-method (3.30 nm), and Modified-Debye-Scherrer's method (3.27 nm). An optical study by the UV-Vis spectrum shows strong absorption at 313 nm, and the corresponding band gap value is 3.28 eV. The topographical and morphological properties revealed by SEM and HRTEM images, elucidate the formation of multi-shaped particles of nano-size. Further, the phytochemicals on the EC:TiO2 NPs' surface are confirmed by the FTIR spectrum. The photocatalytic activity is well studied under UV light towards Congo Red dye, along with an effect of the dose of catalyst. EC:TiO2 (20 mg) has exhibited high photocatalytic efficiency up to 97% for 150 min of exposure due to the morphological, structural, and optical properties. CR degradation reaction exhibits pseudo-first-order kinetics, displaying a rate constant value of 0.01320 min-1. Reusability investigations reveal that after four photocatalysis cycles, EC:TiO2 has an effective efficiency of >85%. Additionally, EC:TiO2 NPs have been assessed for antibacterial activity and show potential against two bacterial species (S. aureus and P. aeruginosa). Therefore, these research outcomes from the eco-friendly and low-cost synthesis, are promising for the use of EC:TiO2 as a talented photocatalyst towards the removal of crystal violet dye as well as an antibacterial agent against bacterial pathogens.

Antimicrobial properties of green synthesized novel TiO2 nanoparticles using Iranian propolis extracts

The oral antimicrobial and cytotoxic properties of green synthesized novel titanium dioxide nanoparticles (TiO2 NPs) using Iranian propolis extracts were investigated on oral bacteria and fibroblast cells. In this study, propolis was sampled, and alcoholic extracts were prepared. The TiO2 NPs were biosynthesized using propolis extracts. The synthesized TiO2 NPs were characterized by scanning electron microscope (SEM), X-ray diffraction analysis, energy-dispersive X-ray (EDX), Fourier transform infrared spectroscopy (FTIR), dynamic light scattering, ultraviolet-visible (UV-Vis), transmission electron microscope, Brunauer-Emmett-Teller, and zeta potential. MTT (3-[4,5-dimethylthiazol-2-yl]-2,5 diphenyl tetrazolium bromide), minimal inhibitory concentration, minimum bactericidal concentration, minimum fungicidal concentration, biofilm formation, and degradation tests were studied to clarify the oral antimicrobial properties of green synthesized TiO2  NPs. According to the FTIR analysis, the propolis extract contained flavonoids and phenolic compounds in addition to TiO2 NPs. Additionally, UV-Vis revealed that intense bands had formed NPs. EDX spectra and SEM images revealed that the stabilizing agent was in perfect quasi-spherical shapes around 21 nm. An EDX spectrum was used to verify the presence of titanium and oxygen. There were no significant cytotoxicity effects. The antibacterial results showed that Pro1TiO2 (Khalkhal sample) had better effects than Pro2TiO2 (Gilan sample) and TiO2 NPs. The present study presents a new process for synthesizing TiO2 NPs from propolis extracts with less toxic effects and user-friendly, eco-friendly, and economical materials. Pro1TiO2 NPs may be considered the best candidate for clinical application.

Effects of Nano-titanium Dioxide on Calcium Homeostasis in Vivo and in Vitro: a Systematic Review and Meta-analysis

With the extensive application of titanium dioxide nanoparticles (TiO₂ NPs), their impacts on calcium homeostasis have aroused extensive attention from scholars. However, there are still some controversies in relevant reports. Therefore, a systematic review was performed followed by a meta-analysis to explore whether TiO₂ NPs could induce the imbalance in calcium homeostasis in vivo and in vitro through Revman5.4 and Stata15.0 in this research. 14 studies were included through detailed database retrieval and literature screening. Results indicated that the calcium levels were significantly increased and the activity of Ca²⁺-ATPase was significantly decreased by TiO₂ NPs in vivo and in vitro. Subgroup analysis of the studies in vivo showed that TiO₂ NPs exposure caused a significant increase in calcium levels in rats, exposure to large-sized TiO₂ NPs (> 10 nm) and long-term (> 30 d) exposure could significantly increase calcium levels, and the activity of Ca²⁺-ATPase showed a concentration-dependent downward trend. Subgroup analysis of the studies in vitro revealed that intracellular calcium levels increased significantly in animal cells, exposure to small-sized TiO₂ NPs (≤ 10 nm) and high concentration (> 10 μg/mL) exposure could induce a significant increase in Ca²⁺ concentration, and the activity of Ca²⁺-ATPase also showed a concentration-dependent downward trend. This research showed that the physicochemical properties of TiO₂ NPs and the experimental scheme could affect calcium homeostasis.

Synthesizing and Optimizing Rutile TiO2 Nanoparticles for Magnetically Guided Drug Delivery

Introduction

Titanium dioxide nanoparticles (TiO₂ NPs) have shown tremendous potential in targeted drug-delivery applications. Among various mechanisms, magnetically guided transport of drugs is one such technique for the said purpose. TiO₂ NPs being diamagnetic or sometimes exhibiting very weak ferromagnetism can be modified by treating them with suitable magnetic materials.

Methods

Rutile TiO₂ NPs were synthesized and doped with Iron Supplement FericipXT and rare-earth metals like cerium, erbium and neodymium via sol–gel technique. FericipXT-coated rutile TiO₂ NPs were synthesized in three different core-shell ratios (1:3, 1:1 and 3:1). The resulting samples were characterized via X-ray Diffraction (XRD), Vibrating Sample Magnetometer (VSM) and High-Resolution Transmission Electron Microscopy (HR-TEM).

Results

XRD of FericipXT-doped TiO₂ NPs showed a rutile phase for 1% and 3% doping; however, only a small fraction of the maghemite phase was obtained for 5% doping. The XRD plots of Ce-doped, Er-doped and Nd-doped TiO₂ NPs showed a variety of phases of TiO₂ NPs (such as anatase/rutile/mixed) along with the oxide phases of the corresponding rare-earth metal. The presence of various iron titanium oxides and iron oxides was found in core-shell NPs. HR-TEM images confirmed the formation of 1:3, 1:1 and 3:1 core-shell TiO₂ NPs. VSM studies showed that the resulting NPs depicted magnetism in the form of superparamagnetism, ferromagnetism and even paramagnetism.

Discussion

The doping to 3% does not affect the original phase of the resulting TiO₂ NPs as depicted from the XRD; however, a doping of 5% and more resulted in extra phases corresponding to the dopant added. FericipXT was loaded over TiO₂ NPs in amorphous form. Among all the samples synthesized, FericipXT-coated TiO₂ NPs demonstrated the best magnetic ability. It was deduced that coating with a magnetic material drastically improves the magnetic character of the host NPs.

Insights into the Design of An Enzyme Free Sustainable Sensing Platform for Efavirenz

In this study, a new hybrid sensor was developed using titanium oxide nanoparticles (TiO2-NPs) and nafion as an anchor agent on a glassy carbon electrode (GCE/TiO2-NPs-nafion) to detect efavirenz (EFV), an anti-HIV medication. TiO2-NPs was synthesized using Eucalyptus globulus leaf extract and characterized using ultraviolet–visible spectroscopy (UV–VIS), scanning electron microscopy (SEM), X-ray diffraction (XRD), and energy-dispersive spectroscopy (EDS). The electrochemical and sensing properties of the developed sensor for EFV were assessed using cyclic voltammetry (CV) and electrochemical impedance spectroscopy (EIS). The current response of GCE/TiO2-NPs-nafion electrode towards the oxidation of EFV was greater compared to the bare GCE and GCE/TiO2-NPs electrodes. A linear dynamic range of 4.5 to 18.7 µM with 0.01 µM limit of detection was recorded on the electrode using differential pulse voltammetry (DPV). The electrochemical sensor demonstrated good selectivity and practicality for detecting EFV in pharmaceuticals (EFV drugs) with excellent recovery rates, ranging from 92.0–103.9%. The reactive sites of EFV have been analyzed using quantum chemical calculations based on density functional theory (DFT). Monte Carlo (MC) simulations revealed a strong electrostatic interaction on the substrate-adsorbate (GCE/TiO2-NPs-nafion-EFV) system. Results show good agreement between the MC computed adsorption energies and the experimental CV results for EFV. The stronger adsorption energy of nafion onto the GCE/TiO2-NPs substrate contributed to the catalytic role in the signal amplification for sensing of EFV. Our results provide an effective way to explore the design of new 2D materials for sensing of EFV, which is highly significant in medicinal and materials chemistry.