Intrinsic photogeneration of long-lived charges in a donor-orthogonal acceptor conjugated polymer

Molecular Control of the Donor/Acceptor Interface Suppresses Charge Recombination Enabling High-Efficiency Single-Component Organic Solar Cells

Single-component organic solar cells based on double cable polymers have achieved remarkable performance, with DCPY2 reaching a high efficiency of over 13%. In this study, DCPY2 is further optimized with an efficiency of 13.85%, maintaining a high fill factor (FF) without compromising the short circuit current. Despite its intermixed morphology, DCPY2 shows a reduced recombination rate compared to their binary counterpart (PBDB-T:Y-O6). This slower recombination in DCPY2 is attributed to the reduced wavefunction overlap of delocalized charges, achieved by spatially separating the donor and acceptor units with an alkyl linker, thereby restricting the recombination pathways. Adding 1,8-diiodooctane (DIO) into DCPY2 further reduced the recombination rate by facilitating acceptor aggregation, allowing free charges to become more delocalized. The DIO-assisted aggregation in DCPY2 (5% DIO) is evidenced by an increased pseudo-pure domain size of Y-O6. Fine molecular control at the donor/acceptor interface in the double-cable polymer achieves reduced non-geminate recombination under efficient charge generation, increased mobility, and charge carrier lifetime, thereby achieving superior performance. Nevertheless, the FF is still limited by relatively low mobility compared to the blend, suggesting the potential for further mobility improvement through enhanced higher-dimensional packing of the double-cable material.

Generating Long-Lived Triplet Excited States in Narrow Bandgap Conjugated Polymers

Narrow bandgap conjugated polymers are a heavily studied class of organic semiconductors, but their excited states usually have a very short lifetime, limiting their scope for applications. One approach to overcome the short lifetime is to populate long-lived triplet states for which relaxation to the ground state is forbidden. However, the triplet lifetime of narrow bandgap polymer films is typically limited to a few microseconds. Here, we investigated the effect of film morphology on triplet dynamics in red-emitting conjugated polymers based on the classic benzodithiophene monomer unit with the solubilizing alkyl side chains C₁₆ and C₂C₆ and then used Pd porphyrin sensitization as a further strategy to change the triplet dynamics. Using transient absorption spectroscopy, we demonstrated a 0.45 ms triplet lifetime for the more crystalline nonsensitized polymer C₂C₆, 2-3 orders of magnitude longer than typically reported, while the amorphous C₁₆ had only a 5 μs lifetime. The increase is partly due to delaying bimolecular electron-hole recombination in the more crystalline C₂C_6, where a higher energy barrier for charge recombination is expected. A triplet lifetime of 0.4 ms was also achieved by covalently incorporating 5% of Pd porphyrin into the C₁₆ polymer, which introduced extra energy transfer steps between the polymer and porphyrin that delayed triplet dynamics and increased the polymer triplet yield by 7.9 times. This work demonstrates two synthetic approaches to generate the longest-lived triplet excited states in narrow bandgap conjugated polymers, which is of necessity in a wide range of fields that range from organic electronics to sensors and bioapplications.