Ratiometric fluorescent and colorimetric dual-modal sensing strategy for discrimination and detection of D2O from H2O

A near-infrared fluorescent probe for simultaneous detection of pH and viscosity

In this work, we developed a ratiometric fluorescent probe (NT) based on ICT framework in near-infrared (NIR) which could detect pH and viscosity simultaneously. Long emission wavelength in NIR could protect the probe from interference of background fluorescence and improve the accuracy of the test. Due to the presence of thiazole-salt, the probe possessed good water solubility and could respond immediately to pH in water system. The pH values measured by NT in the actual samples were not much different from that measured by the pH meter, therefore, NT could give excellent accuracy. NT realized the reversible detection of pH by protonation and deprotonation. NT was used successfully to detect the pH of actual water samples, human serum and meat, as well as the viscosity variation caused by thickeners. Additionally, NT could monitor the changes of pH and viscosity in living cells. Therefore, the novel probe exhibited potential application in the fields of the environment, human health and food safety evaluation.

A "turn-on" fluorescent sensor based on three-component covalent organic framework for trace water detection

Trace amount of H2O is difficult to eliminate in laboratory environments and chemical industries as impurities. In some chemical reactions, trace amount of H2O can alter final reaction products, yield, and selectivity. So, the detection of trace H2O is very important. Herein, a series of TFPT[X]-BMTH- covalent organic frameworks (COFs) (X = 0, 33, 50, 67, 100 %) with intramolecular charge transfer effect (ICT) and aggregate-induced emission (AIE) characteristics were synthesized by amino-aldehyde condensation reaction between 2,5-bis(2-methoxyethoxy)terephthalohydrazide (BMTH)/ 1,3,5-tris(p-formylphenyl)benzene (TFPB) and 4,4',4''-(1,3,5-triazine-2,4,6-triyl)tribenzaldehyde (TFPT). By changing TFPT' content in TFPT[X]-BMTH-COFs, the ICT and AIE of TFPT[X]-BMTH-COFs can be controlled, and accordingly the response to trace H2O can be adjusted. A H2O sensor based on TFPT[67]-BMTH-COF with a wide linear range from 0 wt% to 0.5 wt% was developed and the detection limit was 0.00007 wt%. In addition, a portable fluorescent test paper based on TFPT[67]-BMTH-COF for visual detection of trace H2O in honey samples and salt was constructed. This work has important guiding significance for the development of fluorescent probes for the visual detection of trace water.

Dual-Color Visual Ratiometric Fluorescence Sensing for H2O and D2O Mixtures Using a Hexanuclear Ln(III) Cluster-Based Metal-Organic Framework

High-purity heavy water (D2O) is a strategic material owing to its important application in the fields of nuclear energy and scientific research. D2O always tends to get contaminated by H2O owing to its strong hygroscopicity. Herein, a bimetallic hexanuclear Ln(III) cluster-based metal-organic framework (Eu0.5Tb0.5-TZB-MOF) has been synthesized for fluorescence sensing of the D2O-H2O binary mixtures. Eu0.5Tb0.5-TZB-MOF can be used to immediately differentiate D2O or H2O via fluorescent color responses that are obvious to the naked eye and allow for quantitative ratiometric analysis using simple spectrophotometry. Fluorescence titration experiments demonstrate that both trace H2O in D2O and trace D2O in H2O can be quantitatively detected. Mechanistic studies demonstrate that the weaker vibrational quenching of the O-D oscillator compared to the O-H oscillator, in addition to the terbium-to-europium energy transfer, triggered the fluorescence signal response.

Deep Eutectic Solvent-Based Highly Sensitive Turn-On Fluorescent Probe for D2O

Owing to the importance of heavy water in spectroscopy, nuclear energy generation, chemical characterization, and biological industry, a design of a robust, cheap, nontoxic, and sensitive D2O sensor is very important. In this work, taking advantage of the singular emission fluorescence of the deep eutectic solvent prepared in our laboratory, we propose a first of its kind highly sensitive turn-on fluorescent sensor to effectively sense D2O at an ultratrace level based on rapid exchange of the labile DES proton with deuterium. This method can be used as a full-range heavy water detection strategy with a limit of detection of 0.079% (v/v) or 870 ppm. The isotopic purity (IP) obtained from DES fluorescence measurements is also in close agreement with that of the conventional FT-IR method. The current DES-based sensor thus allows both sensing and isotopic purity of D2O and can serve as one of the most sensitive monitoring strategies for heavy water analysis.

1O2-Relevant Afterglow Luminescence of Chlorin Nanoparticles for Discriminative Detection and Isotopic Analysis of H2O and D2O

Discriminative detection between D₂O and H₂O is important for diverse fields but challenging due to their high similarity in chemical and physical properties. Current molecular sensors for D₂O detection generally rely on the spectral change of fluorophores with suitable pK_a in response to D₂O and H₂O with slightly different pH acidity. Herein, we report a new and facile D₂O sensor by using singlet oxygen (¹O₂)-relevant afterglow luminescence of chlorin e4 nanoparticles (Ce4-NPs) to achieve distinguishable detection between D₂O and H₂O. As ¹O₂ is a key initiator involved in the afterglow luminescence process, it displays a 22-fold longer lifetime in D₂O relative to H₂O and thereafter generates more dioxetane intermediates after laser irradiation to lead to ultimate afterglow brightness of Ce4-NPs in D₂O. In addition, Ce4-NPs are capable of quantitatively detecting the amount of H₂O in D₂O with a limit of detection (LOD) of 1.45%. Together, this study broadens the utility of afterglow materials and presents a facile strategy for isotopic purity analysis of heavy water.

Modulating Dual Fluorescence Emissions in Imine-Based Probes to Distinguish D2O and H2O

How to distinguish D₂O and H₂O and determine the trace H₂O content in D₂O solvent, by using molecule-based spectral probes, is an intriguing topic in analytical chemistry, yet considerably few examples remain up to now, likely due to the very similar physical/chemical properties between D₂O and H₂O. In this work, we found that both the hydrolysis reactions to release fluorescent amines and aggregation-induced emission (AIE) of imines, functioning as dual fluorescence signals to distinguish D₂O and H₂O, could be modulated by changing the imine structures. The hydrophobicity of imines showed an important contribution to the ability of modulating the hydrolysis reactions and AIE, demonstrating a significant difference on fluorescence signals in D₂O and H₂O solvents. Among all tested imines, probe 3, condensed from 2-naphthylamine and salicylaldehyde, was found to have the potential ability to act as an ideal candidate for probing the H₂O content in D₂O solvent, particularly in a low H₂O content range, using the ratiomeric emission signals.

A water-soluble sensor for distinguishing D2O from H2O by dual-channel absorption/fluorescence ratiometry

A novel D2O optical sensor Cy with integrated great water-solubility, absorption/fluorescence dual-channel ratiometric response and even red-green-blue visual sensing application.