A curcumin-based AIEE-active fluorescent probe for Cu2+ detection in aqueous solution

Curcumin-Assisted Synthesis of MoS2 Nanoparticles as an Electron Transport Material in Perovskite Solar Cells

Recently, two-dimensional (2D) transition metal dichalcogenides (2D TMDs), such as molybdenum sulfide (MoS2) and molybdenum selenide (MoSe2), have been presented as effective materials for extracting the generated holes from perovskite layers. Thus, the work function of MoS2 can be tuned in a wide range from 3.5 to 4.8 eV by adjusting the number of layers, chemical composition, elemental doping, surface functionalization, and surface states, depending on the synthetic approach. In this proposed work, we attempt to synthesize MoS2 nanoparticles (NPs) from bulk MoS2 using two steps: (1) initial exfoliation of bulk MoS2 into few-layer MoS2 by using curcumin-cholesteryl-derived organogels (BCC-ED) and curcumin solution in ethylene diamine (C-ED) under sonication; (2) ultrasonication of the subsequently obtained few-layer MoS2 at 60-80 °C, followed by washing of the above chemicals. The initial treatment with the BCC-ED/C-ED undergoes exfoliation of bulk MoS2 resulted in few-layer MoS2, as evidenced by the morphological analysis using SEM. Further thinning or reduction of the size of the few-layer MoS2 by prolonged ultrasonication at 60-80 °C, followed by repeated washing with DMF, resulted in uniform nanoparticles (MoS2 NPs) with a size of ~10 nm, as evidenced by morphological analysis. Since BCC-ED and C-ED produced similar results, C-ED was utilized for further production of NPs over BCC-ED owing to the ease of removal of curcumin from the MoS2 NPs. Utilization of the above synthesized MoS2 NPs as an ETL layer in the cell structure FTO/ETL/perovskite absorber/spiro-OMeTAD/Ag enhanced the efficiency significantly. The results showed that MoS2 NPs as an ETL exhibited a power conversion efficiency (PEC) of 11.46%, a short-circuit current density of 18.65 mA/cm2, an open-circuit voltage of 1.05 V, and a fill factor of 58.66%, at the relative humidity of 70 ± 10% (open-air conditions) than that of the ED-treated MoS2 devices without curcumin. These results suggest that the synergistic effect of both curcumin and ED plays a critical role in obtaining high-quality MoS2 NPs, beneficial for efficient charge transport, lowering the crystal defect density/trap sites and reducing the charge recombination rate, thus, significantly enhancing the efficiency.

Rational design and comparison of three curcumin-based fluorescent probes for viscosity detection in living cells and zebrafish

Viscosity is a crucial indicator of the cellular microenvironment, which can affect the normal level of cellular metabolism. Aberrant levels of viscosity can result in the emergence of a variety of physiological problems including diabetes, Parkinson's disease, inflammation, etc. Therefore, it is crucial to exploit effective assays that can detect viscosity levels in living cells and organisms. Three new nitrogen-containing heterocyclic fluorescent probes, CNO, CNN and CNNB, were designed and prepared by coupling curcumin with isoxazole, pyrazole, and phenylpyrazole rings, respectively. The fluorescence response properties of these probes to the viscosity level were analyzed in parallel. All the probes, CNO, CNN and CNNB, exhibited a significantly enhanced fluorescence response to viscosity in a broad pH range with excellent photostability, sensitivity and anti-interference ability. The sensing mechanisms of these probes for viscosity were verified by DFT calculations. In addition, these probes were successfully employed for detecting viscosity levels in living HeLa cells and zebrafish. This research compares the viscosity-responsive capabilities of curcumin-based fluorescent probes containing different nitrogen-containing heterocyclic structures, and provides a new design strategy and guidance for developing curcumin-based fluorescent probes for viscosity analysis.

Theoretical Investigation on the "ON-OFF" Mechanism of a Fluorescent Probe for Thiophenols: Photoinduced Electron Transfer and Intramolecular Charge Transfer

In this study, the sensing mechanism of (2E,4E)-5-(4-(dimethylamino)phenyl)-1-(2-(2,4dinitrophenoxy)phenyl)penta-2,4-dien-1-one (DAPH-DNP) towards thiophenols was investigated by density functional theory (DFT) and time-dependent DFT (TD-DFT). The DNP group plays an important role in charge transfer excitation. Due to the typical donor-excited photo-induced electron transfer (d-PET) process, DAPH-DNP has fluorescence quenching behavior. After the thiolysis reaction between DAPH-DNP and thiophenol, the hydroxyl group is released, and DAPH is generated with the reaction showing strong fluorescence. The fluorescence enhancement of DAPH is not caused by an excited-state intramolecular proton transfer (ESIPT) process. The potential energy curves (PECs) show that DAPH-keto is less stable than DAPH-enol. The frontier molecular orbitals (FMOs) of DAPH show that the excitation process is accompanied by intramolecular charger transfer (ICT), and the corresponding character of DAPH was further confirmed by hole-electron and interfragment charge transfer (IFCT) analysis methods. Above all, the sensing mechanism of the turn-on type probe DAPH-DNP towards thiophenol is based on the PET mechanism.