Fully wood based novel translucent and thermoplastic materials by solvent-free esterification

Understanding the thermoplasticization mechanism of wood via esterification with fatty acids: A comparative study of the reactivity of cellulose, hemicelluloses and lignin

Thermoplastic materials can be obtained through solvent free wood esterification with fatty acid using trifluoroacetic anhydride (TFAA) as promoter. This study aims to investigate the mechanism of wood thermoplasticization mechanism by understanding the role of each wood component in esterification. High accessibility for acylation was found in cellulose indicated by the highest weight percent gain (WPG), followed by lignin and hemicelluloses. However, significant chemical structural changes were recorded for each spruce wood components observed by Fourier-transform infrared spectroscopy (FTIR) and cross-polarization/magic angle spinning solid state nuclear magnetic resonance (CP/MAS 13C NMR), promoting thus the improvement of their thermal properties detected by (thermogravimetric analysis) TGA and (differential scanning calorimeter) DSC. Cellulose as a major component wood played an important role in wood plasticization, indicated by the low softening temperature before degradation recorded by (thermomechanical analysis) TMA. Hemicelluloses presenting lower WPG, showed the same effect as cellulose on thermoplasticization supported by the low softening temperature observed by TMA and (scanning electron microscope) SEM. Acylated lignin did not show thermoplastic properties, but resulted in important hydrophobic aspects of materials.

Wood Esterification by Fatty Acids Using Trifluoroacetic Anhydride as an Impelling Agent and Its Application for the Synthesis of a New Bioplastic

Fatty acids (FA) and their derivatives with long alkyl chain structures are good candidates for wood esterification to confer thermoplastic properties to wood. Nevertheless, they do not react easily with hydroxyl groups of wood. In this study, we investigated the reactivity of wood with various fatty acids of different chain lengths using trifluoroacetic anhydride (TFAA) as the impelling agent in various reaction conditions. Generally, the esterification of fatty acids without solvents resulted in higher Weight Percentage Gain (WPG) and ester content than the reaction in the presence of CH2Cl2. The esterification reaction could be performed effectively at room temperature, though an increased reaction temperature provoked degradation of the esterified wood. WPG of 67% was obtained for the C3 and 253% for the C16 alkyl chain analogs, respectively. Nevertheless, the ester content was fairly uniform, with values between 10.60 and 11.81 mmol ester/gram of wood for all chain lengths. A higher quantity of reagent led to higher ester content, which tended to stabilize after a ratio of 1:4 wood and TFAA/FA. The esterification reaction was performed rapidly, with an ester content between 7.65 and 9.94 mmol ester/gram of wood being achieved only after 15 min of reaction. Fourier transform infrared spectroscopy (FTIR) analysis was performed to confirm the drastic chemical changes of wood before and after esterification. Morphological observation by scanning electron microscope (SEM), softening measurement by thermomechanical analysis (TMA), and contact angle measurements demonstrated the possibility of esterified spruce wood being applied as a new bioplastic.