Reliability of the step phase detection using inertial measurement units: pilot study

Development of a Non-Contacting Muscular Activity Measurement System for Evaluating Knee Extensors Training in Real-Time

To give people more specific information on the quality of their daily motion, it is necessary to continuously measure muscular activity during everyday occupations in an easy way. The traditional methods to measure muscle activity using a combination of surface electromyography (sEMG) sensors and optical motion capture system are expensive and not suitable for non-technical users and unstructured environment. For this reason, in our group we are researching methods to estimate leg muscle activity using non-contact wearable sensors, improving ease of movement and system usability. In a previous study, we developed a method to estimate muscle activity via only a single inertial measurement unit (IMU) on the shank. In this study, we describe a method to estimate muscle activity during walking via two IMU sensors, using an original sensing system and specifically developed estimation algorithms based on ANN techniques. The muscle activity estimation results, estimated by the proposed algorithm after optimization, showed a relatively high estimation accuracy with a correlation efficient of R² = 0.48 and a standard deviation STD = 0.10, with a total system average delay of 192 ms. As the average interval between different gait phases in human gait is 250–1000 ms, a 192 ms delay is still acceptable for daily walking requirements. For this reason, compared with the previous study, the newly proposed system presents a higher accuracy and is better suitable for real-time leg muscle activity estimation during walking.

Unrestricted stride detection during stair climbing using IMUs

Stride detection, or the identification of the initial (IC) and terminal contact (TC) of the feet while walking, is important for gait analysis. Automatic stride detection based only on kinematic data is challenging, even when using portable, low-cost, user-friendly Inertial Measurement Units (IMUs). Although there are algorithms for straight walking available, they are often not applicable to other movement patterns. Furthermore, these algorithms are based on the use of different IMUs placed on different locations of the body with different pre-processing filters and rely on analyzing different measurement signals. Therefore, it is difficult to apply existing algorithms for specific study settings. To achieve a new algorithm, thirty-five healthy participants were analyzed during walking and stair climbing while kinematic motion data was measured using the IMU system MyoMotion. Based on the analysis of different published methods for IC and TC detection, a new robust stride detection algorithm was developed and validated in comparison with two different algorithms. From this, it was determined that the newly developed algorithm was successful in automatic stride detection during walking and ascending/ descending stairs with 100% detected gait events, while the other algorithms failed during stair climbing with only 44% and 91% detected gait events.

The effect of a knee brace in dynamic motion-An instrumented gait analysis

Background

Osteoarthritis (OA) is a common problem in the older population. To reduce pain and stress in the affected knee joint compartment, a functional knee brace is often prescribed by physicians to protect it from high loads.

Objectives

An instrumented gait analysis should evaluate how the 4-point knee orthosis for varus or valgus load relief (M.4s OA) changes the kinematics of the knee, especially in the frontal plane.

Methods

17 healthy participants took part and were analyzed with an inertial sensor system (MyoMotion) giving continuous, objective information on the anatomical angles. The measurements were made both without wearing a knee brace and with the brace in different settings.

Results

The results show a significant reduction in the maximum knee abduction and raised knee adduction. The knee brace, with a strong adjustment in varus or valgus orientation, caused a shift of maximum ab-/adduction in the proposed direction in 69% and 75% of the dynamic tests, respectively. The knee motion in the frontal plane shows individual movement patterns.

Conclusion

The use of the brace leads to significant changes in the knee’s movement. Patient-specific movement patterns may explain different effects of functional knee braces on individual persons. Inertial sensors have been shown to be a low-cost, easy-to-use option for individual movement analysis and further personalized therapy.

A Personalized Approach to Improve Walking Detection in Real-Life Settings: Application to Children with Cerebral Palsy

Although many methods have been developed to detect walking by using body-worn inertial sensors, their performances decline when gait patterns become abnormal, as seen in children with cerebral palsy (CP). The aim of this study was to evaluate if fine-tuning an existing walking bouts (WB) detection algorithm by various thresholds, customized at the individual or group level, could improve WB detection in children with CP and typical development (TD). Twenty children (10 CP, 10 TD) wore 4 inertial sensors on their lower limbs during laboratory and out-laboratory assessments. Features extracted from the gyroscope signals recorded in the laboratory were used to tune thresholds of an existing walking detection algorithm for each participant (individual-based personalization: Indiv) or for each group (population-based customization: Pop). Out-of-laboratory recordings were analyzed for WB detection with three versions of the algorithm (i.e., original fixed thresholds and adapted thresholds based on the Indiv and Pop methods), and the results were compared against video reference data. The clinical impact was assessed by quantifying the effect of WB detection error on the estimated walking speed distribution. The two customized Indiv and Pop methods both improved WB detection (higher, sensitivity, accuracy and precision), with the individual-based personalization showing the best results. Comparison of walking speed distribution obtained with the best of the two methods showed a significant difference for 8 out of 20 participants. The personalized Indiv method excluded non-walking activities that were initially wrongly interpreted as extremely slow walking with the initial method using fixed thresholds. Customized methods, particularly individual-based personalization, appear more efficient to detect WB in daily-life settings.