1
|
Bill C, Kassumeh S, Hilterhaus C, Tersi N, Speidel AJ, Ohlmann A, Priglinger S, Priglinger C, Wolf A, Wertheimer CM. Conditions for modifying intraocular lenses as drug carriers for methotrexate using poly (lactic-co-glycolic acid). Eur J Ophthalmol 2024:11206721241239717. [PMID: 38494950 DOI: 10.1177/11206721241239717] [Citation(s) in RCA: 0] [Impact Index Per Article: 0] [Reference Citation Analysis] [Abstract] [Key Words] [Track Full Text] [Journal Information] [Subscribe] [Scholar Register] [Indexed: 03/19/2024]
Abstract
INTRODUCTION The intraocular lens (IOL) can be used as a slow-release drug carrier in cataract surgery to alleviate posterior capsular opacification (PCO). The following is a systematic development of an IOL using methotrexate and the solvent casting process with poly (lactic-co-glycolic acid) (PLGA) as a carrier polymer. METHODS Different solvents for PLGA and methotrexate were tested for dissolution properties and possible damage to the IOL. The required biological concentration of methotrexate was determined in human capsular bags implanted with an IOL. To detect fibrosis, α-SMA, f-actin, and fibronectin were labelled by immunofluorescence staining. Cell proliferation and extracellular matrix contraction were observed in a lens epithelial cell line (FHL-124). Finally, the IOL was designed, and an ocular pharmacokinetic model was used to measure drug release. RESULTS Solvent mixtures were found to allow coating of the IOL with drug and PLGA without damaging it. PCO in the capsular bag model was inhibited above 1 μM methotrexate (p = 0.02). Proliferation in FHL-124 was significantly reduced above a concentration of 10 nM (p = 0.04) and matrix contraction at 100 nM (p = 0.02). The release profile showed a steady state within therapeutic range. CONCLUSION After determination of the required physicochemical manufacturing conditions, a drug releasing IOL was designed. A favourable release profile in an ocular pharmacokinetics model could be shown.
Collapse
Affiliation(s)
- Clarissa Bill
- Department of Ophthalmology, University Hospital, LMU Munich, Munich, Germany
| | - Stefan Kassumeh
- Department of Ophthalmology, University Hospital, LMU Munich, Munich, Germany
| | - Christina Hilterhaus
- Department of Ophthalmology, University Hospital, University of Ulm, Ulm, Germany
| | - Natalie Tersi
- Department of Ophthalmology, University Hospital, LMU Munich, Munich, Germany
| | - Arne J Speidel
- Department of Ophthalmology, University Hospital, University of Ulm, Ulm, Germany
| | - Andreas Ohlmann
- Department of Ophthalmology, University Hospital, LMU Munich, Munich, Germany
| | | | - Claudia Priglinger
- Department of Ophthalmology, University Hospital, LMU Munich, Munich, Germany
| | - Armin Wolf
- Department of Ophthalmology, University Hospital, LMU Munich, Munich, Germany
- Department of Ophthalmology, University Hospital, University of Ulm, Ulm, Germany
| | - Christian M Wertheimer
- Department of Ophthalmology, University Hospital, LMU Munich, Munich, Germany
- Department of Ophthalmology, University Hospital, University of Ulm, Ulm, Germany
| |
Collapse
|
2
|
Wu KY, Brister D, Bélanger P, Tran SD. Exploring the Potential of Nanoporous Materials for Advancing Ophthalmic Treatments. Int J Mol Sci 2023; 24:15599. [PMID: 37958583 PMCID: PMC10650608 DOI: 10.3390/ijms242115599] [Citation(s) in RCA: 0] [Impact Index Per Article: 0] [Reference Citation Analysis] [Abstract] [Key Words] [MESH Headings] [Track Full Text] [Journal Information] [Subscribe] [Scholar Register] [Received: 09/28/2023] [Revised: 10/23/2023] [Accepted: 10/23/2023] [Indexed: 11/15/2023] Open
Abstract
The landscape of ophthalmology is undergoing significant transformations, driven by technological advancements and innovations in materials science. One of the advancements in this evolution is the application of nanoporous materials, endowed with unique physicochemical properties ideal for a variety of ophthalmological applications. Characterized by their high surface area, tunable porosity, and functional versatility, these materials have the potential to improve drug delivery systems and ocular devices. This review, anchored by a comprehensive literature focusing on studies published within the last five years, examines the applications of nanoporous materials in ocular drug delivery systems (DDS), contact lenses, and intraocular lenses. By consolidating the most current research, this review aims to serve as a resource for clinicians, researchers, and material scientists engaged in the rapidly evolving field of ophthalmology.
Collapse
Affiliation(s)
- Kevin Y. Wu
- Department of Surgery—Division of Ophthalmology, University of Sherbrooke, Sherbrooke, QC J1G 2E8, Canada; (K.Y.W.)
| | - Danielle Brister
- College of Public Health, National Taiwan University (NTU), Taipei 106319, Taiwan
| | - Paul Bélanger
- Department of Surgery—Division of Ophthalmology, University of Sherbrooke, Sherbrooke, QC J1G 2E8, Canada; (K.Y.W.)
| | - Simon D. Tran
- Faculty of Dental Medicine and Oral Health Sciences, McGill University, Montreal, QC H3A 1G1, Canada
| |
Collapse
|
3
|
Lu D, Han Y, Liu D, Chen S, Qie J, Qu J, Lin Q. Centrifugally concentric ring-patterned drug-loaded polymeric coating as an intraocular lens surface modification for efficient prevention of posterior capsular opacification. Acta Biomater 2022; 138:327-341. [PMID: 34800717 DOI: 10.1016/j.actbio.2021.11.018] [Citation(s) in RCA: 19] [Impact Index Per Article: 9.5] [Reference Citation Analysis] [Abstract] [Key Words] [MESH Headings] [Track Full Text] [Journal Information] [Subscribe] [Scholar Register] [Received: 07/26/2021] [Revised: 10/25/2021] [Accepted: 11/12/2021] [Indexed: 02/06/2023]
Abstract
Posterior capsular opacification (PCO) is the main postoperative complication after intraocular lens (IOL) implantation in cataract surgery, because of the proliferation of the residual lens epithelial cells (LECs) in the lens capsule. Drug-eluting IOLs, aimed to develop an in situ drug delivery device, are the promising concept in recent years. As IOLs are optical devices other than implants, the feasibility and applicability remain a challenge for drug-eluting coatings. In this investigation, a centrifugally concentric ring-patterned drug-loaded poly(lactide-co-glycolic acid) (PLGA) coating was designed and fabricated by the spin coating technique. The concentric ring-patterned morphologies and the drug loading and release properties were carefully investigated, and the spin coating parameters were optimized. A concentric annular coating with a thin center and thick periphery was obtained, which was particularly suitable for the surface modification of IOLs, as the visual pathway of the intraocular light transmission greatly requires good light transmittance of the IOLs. IOLs with the immunosuppressant cyclosporin A (CsA)-loaded coating (CsA @ PLGA) modification were then fabricated for PCO prevention. The in vitro LECs culture results showed that the CsA @ PLGA coating-modified IOLs significantly inhibited cell proliferation and induced cell death. Western blot analysis showed that the efficient cell inhibition behavior of CsA was due to the autophagy-mediated cell death pathway. The in vivo intraocular implantation results confirmed the desired PCO inhibition effect. Thus, the centrifugally concentric ring-patterned drug-loaded PLGA coating obtained by the spin coating technique provides a simple yet effective alternative of IOL modification for PCO prevention. STATEMENT OF SIGNIFICANCE: • Concentric ring-patterned polymer coating, specifically for drug-eluting IOL fabrication, was developed by the spin coating technique. • The immunosuppressant CsA inhibited LEC proliferation through the autophagy-mediated cell death pathway. • Concentric ring-patterned CsA-eluting IOLs exhibited reliable in vivo PCO prevention. • The drug-eluting IOLs fabricated by the simple and economical spin coating technique have a great potential in clinical translation.
Collapse
Affiliation(s)
- Duoduo Lu
- School of Ophthalmology & Optometry, Eye Hospital, Wenzhou Medical University, Wenzhou 325027, PR China
| | - Yuemei Han
- School of Ophthalmology & Optometry, Eye Hospital, Wenzhou Medical University, Wenzhou 325027, PR China
| | - Dong Liu
- School of Ophthalmology & Optometry, Eye Hospital, Wenzhou Medical University, Wenzhou 325027, PR China
| | - Siqi Chen
- School of Ophthalmology & Optometry, Eye Hospital, Wenzhou Medical University, Wenzhou 325027, PR China
| | - Jiqiao Qie
- School of Ophthalmology & Optometry, Eye Hospital, Wenzhou Medical University, Wenzhou 325027, PR China
| | - Jia Qu
- School of Ophthalmology & Optometry, Eye Hospital, Wenzhou Medical University, Wenzhou 325027, PR China.
| | - Quankui Lin
- School of Ophthalmology & Optometry, Eye Hospital, Wenzhou Medical University, Wenzhou 325027, PR China.
| |
Collapse
|
4
|
Karamitsos A, Lamprogiannis L, Karagkiozaki V, Koutsogianni A, Chakim Z, Ziakas NG, Tsinopoulos I, Logothetidis S. Morphological Characteristics of Drug-Eluting Biodegradable Polymeric Thin Films Developed on the Surface of Intraocular Lenses by Three Techniques: A Comparative Study. Cureus 2021; 13:e19674. [PMID: 34976462 PMCID: PMC8683073 DOI: 10.7759/cureus.19674] [Citation(s) in RCA: 0] [Impact Index Per Article: 0] [Reference Citation Analysis] [Abstract] [Track Full Text] [Download PDF] [Figures] [Journal Information] [Subscribe] [Scholar Register] [Accepted: 11/17/2021] [Indexed: 11/22/2022] Open
Abstract
Background Cataract surgery is a very popular operation that requires a postoperative period of frequent instillation of antibiotic and anti-inflammatory eye drops. Modified drug-eluting intraocular lenses (IOLs) may eliminate the need for eye drops after surgery. Aim The purpose of this study is to compare the morphological characteristics of dexamethasone eluting biodegradable polymeric thin films developed on the surface of commercially available IOLs by three different methods. Method This experimental study was conducted between May and August of 2021 in the Lab for Thin Films - Nanobiomaterials - Nanosystems & Nanometrology (LTFN) of the Aristotle University of Thessaloniki. A mixture of two organic polymers [Poly (D, L-lactide-co-glycolide)(PLGA), lactide: glycolide (75:25) and Polycaprolactone (PCL)] and dexamethasone was prepared and then deposited on the surface of three-piece IOLs by spin coating, by spray coating, and by gravure printing. The modified IOLs were sterilized with the use of ultraviolet (UV) radiation and plasma treatment. Their structural properties were studied with the use of atomic force microscopy (AFM). Results Spin coating and gravure printing produced uniform thin films on the surface of the IOLs which were not damaged during the sterilization process. Spray coating led to the partial coating of the surface of the IOLs; the thin films underwent alterations following plasma treatment. Conclusions Thin films developed by spin coating and gravure printing on IOLs demonstrate the desired morphological characteristics that make them suitable candidates for further research.
Collapse
|
5
|
Mylona I, Tsinopoulos I. A Critical Appraisal of New Developments in Intraocular Lens Modifications and Drug Delivery Systems for the Prevention of Cataract Surgery Complications. Pharmaceuticals (Basel) 2020; 13:E448. [PMID: 33302370 PMCID: PMC7762578 DOI: 10.3390/ph13120448] [Citation(s) in RCA: 7] [Impact Index Per Article: 1.8] [Reference Citation Analysis] [Abstract] [Key Words] [Track Full Text] [Download PDF] [Figures] [Journal Information] [Subscribe] [Scholar Register] [Received: 10/14/2020] [Revised: 12/04/2020] [Accepted: 12/05/2020] [Indexed: 12/13/2022] Open
Abstract
Cataract surgery is the commonest ophthalmic surgery worldwide. The replacement of the diseased lens with a synthetic one (intraocular lens-IOL) remains the treatment of choice, despite its potential complications that include infection, inflammation and posterior capsule opacification. The potential for drug delivery via the IOL has been researched extensively over a period of twenty-five years, yet there is very limited progress in transferring the findings from research to everyday practice. The objective of this review is to assess the progress made in the field of IOL lens modifications and drug delivery systems over the past five years. Thirty-six studies that were conducted during the past five years were identified and deemed suitable for inclusion. They were grouped in three broad categories, studies that described new methods for loading a drug onto the IOL, assessment of the effects of drugs that were loaded to the IOL and studies that assessed the effects of non-pharmaceutical modifications of IOLs. While considerable progress is continually being made with regard to methods and materials, there is still little capitalization upon these research studies, with no commercially available IOL-based drug delivery system being available. Close cooperation between researchers in basic sciences (chemistry, physics, materials science and pharmacy), clinical researchers, IOL manufacturers and the pharmaceutical industry is an important prerequisite for further development.
Collapse
Affiliation(s)
- Ioanna Mylona
- 2nd Department of Ophthalmology, Aristotle University of Thessaloniki, 564 29 Thessaloniki, Greece;
| | | |
Collapse
|