Comparison of Fishing Line for Repair of the Cruciate Deficient Stifle

Comparison of the mechanical characteristics of polymerized caprolactam and monofilament nylon loops constructed in parallel strands or as braided ropes versus cranial cruciate ligaments of cattle

OBJECTIVE

To compare the mechanical characteristics of polymerized caprolactam and monofilament nylon loops with those of the cranial cruciate ligament (CCL) in cattle.

SAMPLE

6 femorotibial joints harvested from 3 cows and suture constructs made from No. 8 polymerized caprolactam, 80-lb test monofilament nylon fishing line, and 450-lb test monofilament nylon fishing line.

PROCEDURES

Joints were cleared of soft tissue structures except the CCL, connected to a load frame, and loaded to failure while measuring force and elongation. Synthetic constructs tested in a similar manner included single-stranded and 3-stranded No. 8 polymerized caprolactam, 3- and 6-stranded 80-lb test monofilament nylon fishing line, and 3- and 6-stranded 450-lb test monofilament nylon fishing line.

RESULTS

The CCL ruptured at a mean ± SD force of 4,541 ± 1,417 N with an elongation of 2.0 ± 0.3 cm. The tensile strength of 3-stranded 450-lb test monofilament nylon fishing line was similar to that of the CCL, rupturing at loads of 5,310 ± 369 N (braided strands) and 6,260 ± 239 N (parallel strands). Elongation was greater for braided constructs.

CONCLUSIONS AND CLINICAL RELEVANCE

The 3-stranded cords of 450-lb test monofilament nylon fishing line most closely approximated the strength of the CCL. Marked increases in elongation occur when large-sized materials are constructed in braided configurations, and this elongation would likely not provide stability in CCL-deficient stifle joints. Additional studies are needed to determine whether any of these materials are suitable CCL replacements in cattle.

In vitro mechanical evaluation and comparison of two crimping devices for securing monofilament nylon and multifilament polyethylene for use in extracapsular stabilization of the canine stifle

OBJECTIVE

To compare the tensile strength and stiffness of non-absorbable suture loops created with two types of crimping devices.

METHODS

Loops of monofilament nylon leader line (MN) of 18 kg, 36 kg, and 45 kg multifilament polyethylene (MP) with a crimp and MP with a crimp and knot were mechanically tested to failure in quasistatic tensile loading after being created with either a wave pattern crimp device or three applications of a single crimp device. Each testing group consisted of five samples. Tensile loading to failure at a rate of 9.5 mm/s was used. Failure was defined as a sudden drop in the recorded force.

RESULTS

All suture materials failed by breaking near the crimp tube with both crimp devices, with exception of the MP without knot, which slipped through the crimp tube using both devices. Sutures secured with the wave pattern crimping device were significantly stronger with a higher load yield, maximum load, displacement yield, failure displacement, and maximum displacement than the single crimp device. Loops of MP suture crimped by either device plus the addition of a surgeon's knot resulted in a significantly stronger construct than unknotted crimped MP constructs. Crimped MP combined with knot were significantly stiffer, but not stronger, than crimped 45 kg MN.

CLINICAL SIGNIFICANCE

Performing extra- capsular repair for ruptured cranial cruciate ligaments with the wave pattern crimp system may result in lower failure rates due to the construct being significantly stronger than the single crimp system.

Mechanical evaluation of hydrogen peroxide gas plasma sterilization of nylon lines used for extra-articular stabilization of the canine stifle joint

OBJECTIVE

To compare the effects of hydrogen peroxide gas plasma (HPGP) and ethylene oxide (EO) sterilizations on the mechanical properties of nylon lines used for stabilization of the canine stifle. Secondarily, to compare the performance of crimped and knotted lines.

STUDY DESIGN

In vitro mechanical evaluation.

SAMPLE POPULATION

Nonsterilized, EO- and HPGP-sterilized specimens of 36.3 kg test nylon leader line (NLL) and 57.8 kg test nylon fishing line (NFL).

METHODS

Single strands and looped specimens of NLL or NFL were positioned on a material testing machine. To create looped specimens, NLL were crimped using the Securos system, and NFL were knotted, as used clinically. Elongation (%) and ultimate load (N) variables were studied.

RESULTS

Elongation and ultimate load of NLL groups were not significantly different between EO and HPGP. For NFL, HPGP sterilization led to slightly greater elongation than EO in loops only. Ultimate load of NFL single strands was not significantly different between EO and HPGP, but was higher after HPGP compared with EO in NFL loops. All NLL groups had less elongation and ultimate load than NFL.

CONCLUSION

The effects of HPGP on NLL compared positively to EO, making HPGP an attractive alternative. As HPGP led to a slightly greater elongation of NFL than EO, the latter could be favored to sterilize NFL. Crimped NLL minimized elongation better than knotted NFL.

CLINICAL RELEVANCE

Sterilization with HPGP seems a good alternative to EO for NLL. EO may be a better choice for NFL; however, it is difficult to judge the clinical relevance of this result. Crimped NLL minimizes elongation and may help reducing the recurrence of stifle instability postoperatively.

Mechanical Evaluation of Two Loop Tensioning Methods for Crimp Clamp Extracapsular Stabilization of the Cranial Cruciate Ligament-Deficient Canine Stifle

OBJECTIVES

To describe a method of tightening nylon loops secured with a crimping system for extracapsular fabello-tibial stabilization of the cranial cruciate ligament-deficient stifle and to compare this with a method using a commercially available tensioning device.

STUDY DESIGN

In vitro mechanical testing.

METHODS

Fourteen standardized nylon loops were tensioned using a tensioning device and secured with crimp clamps. Another 14 loops were tightened by partially securing the crimp clamp, followed by tightening of the loop by hand, before definitively securing the crimp clamp. Loops were loaded to failure in a materials testing machine.

RESULTS

Mean ultimate loads for instrument-tightened and hand-tightened loops were 383.7 and 371.4 N, respectively. Mean stiffness values for instrument-tightened and hand-tightened loops were 59.7 and 59.3 N/mm, respectively. These differences were not significant.

CONCLUSIONS

The hand tightening method does not affect the mechanical properties of the loop.

CLINICAL RELEVANCE

The hand tightening method described is a valuable technique for unassisted surgeons without access to tensioning devices.

Mechanical Evaluation of Two Crimp Clamp Systems for Extracapsular Stabilization of the Cranial Cruciate Ligament-Deficient Canine Stifle

OBJECTIVE

To compare the mechanical properties and interoperator variabilities of 2 crimp clamp systems for extracapsular, fabello-tibial, nylon loop stabilization of the cranial cruciate ligament-deficient stifle in dogs.

STUDY DESIGN

In vitro mechanical testing.

METHODS

Three operators with different grip strengths each secured 20 standardized nylon loops using stainless-steel crimp clamps: 10 using a Veterinary Instrumentation system (45 kg [100 lb] test nylon leader line, 12 mm crimp clamps) and 10 using a Securos system (36 kg [80 lb] test nylon leader line, 36 kg [80 lb] crimp clamps). Loops were tensile loaded to failure in a materials testing machine.

RESULTS

Mean ultimate load and mean stiffness were significantly higher for the Securos (336.9 N, 60.6 N/mm) than for the Veterinary Instrumentation system (113.8 N, 37.0 N/mm). For both systems, ultimate load was subject to interoperator variability.

CONCLUSIONS

The Securos loops were significantly stronger and stiffer than the Veterinary Instrumentation loops for all operators, but significant differences between operators for ultimate load existed for both systems.

CLINICAL RELEVANCE

Securos fabello-tibial sutures will withstand greater loads than Veterinary Instrumentation sutures and this is particularly true for sutures created by surgeons with reduced grip strength. It may be necessary to use more than 1 Veterinary Instrumentation suture to match the ultimate load and stiffness of a Securos suture.

Evaluation of 5 types of fishing material, 2 sterilization methods, and a crimp-clamp system for extra-articular stabilization of the canine stifle joint

OBJECTIVE

To evaluate the mechanical properties of 5 types of fishing material, 2 sterilization methods, and a commercially designed crimp-clamp system for the extra-articular repair of the canine stifle joint.

STUDY DESIGN

Experimental study.

SAMPLE POPULATION

Animals were not used in this study.

METHODS

Two brands of monofilament nylon fishing line and 3 brands of monofilament nylon leader line were used to determine the effect of steam and ethylene oxide sterilization on strength and elongation of the material. A strand of 36-kg test monofilament nylon fishing material was wrapped around 2 rods or knotted to form a loop around 2 rods on a materials-testing machine. Ten trials of each brand of unsterilized, steam-sterilized, and ethylene oxide-sterilized fishing material were tested. A strand of each material was elongated to failure at a constant displacement of 1,000 mm/min to determine strength. A strand of each material was cycled 10 times to a load of 50 N to determine percent elongation. The brand of fishing material with the greatest strength and least elongation was crimped to form a loop around 2 rods on a materials-testing machine and tested as described above. ANOVA was used to determine the effect of sterilization method, brand of material, knot, wrap, and crimp on strength and elongation of the material, and a post-hoc t test was used when significant differences were found. A Student t test was used to compare fixation techniques (wrap, knot, and crimp).

RESULTS

Sterilization by steam or ethylene oxide had no significant effect on the strength of the nylon fishing material. Steam sterilization resulted in significant increases (2- to 4-fold) in elongation of most nylon fishing material when compared with unsterilized material. Ethylene oxide sterilization had minimal effect on elongation of the fishing material. Mason leader line showed no significant change in strength or elongation regardless of sterilization method. Significantly less strength and significantly less elongation were demonstrated in Mason leader line that was crimped as compared with Mason leader line that was knotted.

CONCLUSION

Ethlylene oxide was the preferred method of sterilization to preserve strength and minimize elongation of the fishing material. Of the materials tested, Mason leader line had the least elongation and the greatest preservation of strength when ethylene oxide was used as the sterilization method. Mason leader line and Sufix fishing line were comparable choices when steam was used as the sterilization method. Significantly less elongation was demonstrated in crimped Mason leader line as compared with knotted Mason leader line.

CLINICAL RELEVANCE

Of the materials tested, Mason leader line and Sufix fishing line had the best mechanical properties for extracapsular stabilization of the canine stifle joint. Crimping is an attractive alternative to knotting and results in a reduction in elongation of the nylon fishing material.