[Axial load in case of press-fit fixation of the ACL graft--a fundamental study]

Re-rupture rate and the post-surgical meniscal injury after anterior cruciate ligament reconstruction with the Press-Fit-Hybrid®-technique in comparison to the interference screw technique: a retrospective analysis of 200 patients with at least 3 years follow-up

BACKGROUND

There is currently no consensus regarding the preferred surgical procedure for the reconstruction of anterior cruciate ligament (ACL). The interference screw technique is widely used, but has been associated with a risk of graft damage. The Press-Fit-Hybrid®-technique is one of the alternatives for biological ACL-reconstruction with minimal implant requirements. The hypothesis of this retrospective analysis is, that the Press-Fit-Hybrid®-technique leads to better results with respect to re-rupture rate and secondary meniscal lesion than the interference-screw-technique.

METHODS

To compare the re-rupture rate of the interference-screw-technique (IF) used until 2015 with the currently used Press-Fit-Hybrid®-technique (PFH), the last 100 patients of the IF-group and the first 100 patients of the PFH-group were retrospectively analyzed. Primary outcomes were re-rupture rate, complications and secondary meniscal injury. Additionally, laxity, Lachman and Pivot-shift and range of motion were evaluated.

RESULTS

A mean follow-up of 4.2 and 5.3 years revealed 4% and 9% re-rupture rates and 1% and 2% complication rates in the PFH- and IF-group, respectively. In the PFH-group there were no re-ruptures in patients older than 23 years. Secondary meniscal injury post-surgery was 6% and 9% for the PFH and IF-group, respectively. Knee stability was similar in both groups. Range of motion was significantly better in the PFH-group, with 136° of flexion, 6 months after surgery.

CONCLUSION

For ACL-reconstruction the Press-Fit-Hybrid®-technique is an alternative new method. Low level of secondary meniscal lesions after surgery and high stability, is known to prevent later arthrosis of the knee. The encouraging observed trend of the reduction of the re-rupture rate in revision surgery and in young patients using the Press-Fit-Hybrid®-technique in comparison to the interference-screw-technique must be confirmed with further studies.

LEVEL OF EVIDENCE

Therapeutic Level III, retrospective cohort study.

Implant-free ACL reconstruction: a review

Implant-free anterior cruciate ligament (ACL) reconstruction is the fixation of ACL grafts without the need for artificial implants. Our aim was to study the evolution of this technique, review the biomechanical evidence and summarise the results. Implant-free graft fixation for bone patella tendon ACL reconstruction was first described in 1987. This concept of implant-free graft fixation was adapted for hamstring and quadriceps tendons as alternative graft sources. Various biomechanical studies have reported that by adhering to certain technical details, this technique provides comparable fixation strength as conventional ACL fixation. The outcome studies of implant-free ACL reconstruction also report clinical results similar to ACL reconstruction with conventional implants.

[Anatomic reconstruction of the anterior cruciate ligament with the autologous quadriceps tendon. Primary and revision surgery]

OBJECTIVE

Restore function of the anterior cruciate ligament (ACL).

INDICATIONS

Chronic functional instability with rupture of the ACL, giving way phenomena, acute rupture of the ACL with concomitant meniscus repair, rerupture of ACL graft with anatomical tunnels.

CONTRAINDICATIONS

Local infection of the skin at the knee joint, local soft tissue damage, after rupture of the quadriceps tendon, enthesopathia of the quadriceps tendon, lack of patient compliance.

SURGICAL TECHNIQUE

Harvest quadriceps tendon graft with a bone block via a 4-5 cm long incision, starting from the middle third of the proximal patella pole without damaging the tendon fibers. Drill the femoral tunnel via a deep anteromedial portal with the knee flexed of more than 110° (tunnel diameter 0.5-1 mm smaller in diameter than bone block). Gentle tunnel preparation using dilators. In absence of an ACL stump the lateral meniscus anterior horn serves as tibial landmark. In case of revision surgery, remove graft material and implants from the tunnel. Graft fixation using press fit method in the femoral tunnel. Tibial graft fixation archieved with a resorbable interference screw and a button.

POSTOPERATIVE MANAGEMENT

Goal of the inflammatory phase (weeks 1-2) is pain and inflammation control (20 kg partial weight bearing). During the proliferative phase (weeks 2-6), load and mobility slowly increased (closed-chain exercises). During the remodeling phase (> 6 weeks), strength and coordination exercises are performed. In revision cases and in case of concomitant injuries, longer partial weight-bearing period might be necessary. Athletes should not return to competitive sports before 6-8 months.

RESULTS

In a prospective study, 33 patients (age 16-48 years) were examined after replacement of the ACL with a quadriceps tendon graft after a minimum follow-up (FU) of 2 years (12 revision; 21 primary surgery). No post- or perioperative complications. Postoperative radiographs showed an anatomical tunnel location and no dislocation of the bone block. After 2 years the difference of a-p translation compared to the other leg was assessed by the use of KT 1000. The revision group improved from an average of 7.2 mm (pre-op) to 2.2 mm (FU). The group with primary surgery improved from 6.4 mm (pre-op) to 1.7 mm (FU). A sliding pivot shift phenomenon was detected in 2 patients in the revision group and 1 patient in the primary surgery group.

Graft-dependent differences in the ligamentization process of anterior cruciate ligament grafts in a sheep trial

PURPOSE

The structural properties of the healing ligament are the determining factor for the stability of the reconstruction before, during, and after osseous integration of anterior cruciate ligament grafts. Over the course of ligamentization, the stability of synovialized grafts seems lower than that of non-synovialized patellar tendon grafts.

METHODS

In an animal study on 42 sheep, 21 non-synovialized grafts (patellar tendon) and 21 synovialized grafts (flexor digitorum superficialis tendon) were performed to replace the anterior cruciate ligament. After 6, 12, and 24 weeks, 7 animals from each group were euthanized and investigated. Anteroposterior stability of the knee was assessed. After removal of all other soft tissues, the ACL was loaded to failure. Histology and histological analysis of the intra-articular graft region was then performed.

RESULTS

There were no significant differences in the translation test comparing synovialized and non-synovialized grafts. After 6, 12, and 24 weeks, all transplants failed in the tensile test due to interligamentous rupture or avulsion. After 6 weeks, transplants did not show significant biomechanical differences. Load to failure and stiffness of the patellar tendon was more than twice those of synovialized tendon (P = 0.002) after 12 weeks. Histology revealed necrosis in patellar tendon specimens after 12 weeks. A significant increase in load to failure was determined in synovialized ligament grafts between 12 and 24 weeks (P = 0.005). Its load capacity then tended to be higher than that of patellar tendon grafts.

CONCLUSION

The stability of synovialized ligament grafts is significantly lower than that of non-synovialized patellar tendon grafts after 12 weeks. This difference is compensated after 24 weeks. The significantly lower load to failure of synovialized compared with non-synovialized grafts after 12 weeks may be clinically relevant for the rehabilitation process of anterior cruciate ligament grafts in humans.

Microporous pure beta-tricalcium phosphate implants for press-fit fixation of anterior cruciate ligament grafts: strength and healing in a sheep model

PURPOSE

A sheep study was conducted to test a press-fit technique using microporous pure beta-tricalcium phosphate (beta-TCP) dowels for fixation of the anterior cruciate ligament (ACL) graft.

METHODS

Microporous (5 mum) cylindrical plugs of beta-TCP (diameter, 7 mm; length, 25 mm) with interconnecting pores were used. The material featured a novel configuration of structure and surface geometry. Implants were tested by use of press-fit fixation of ACL grafts with and without bone blocks in 42 sheep over a period of 24 weeks. Biomechanical, radiologic, histologic, and immunohistochemical evaluations were performed.

RESULTS

In load-to-failure tests at 6, 12, and 24 weeks after surgery, the intra-articular graft always failed, not the fixation. Grafts showed bony fixation in the tunnel at 6 weeks and primary healing at the junction of the tunnel and joint after 24 weeks. Tricalcium phosphate was resorbed and simultaneously replaced by bone. Remodeling was still incomplete at 24 weeks.

CONCLUSIONS

In the sheep model microporous beta-TCP implants used with press-fit fixation of ACL grafts permit early functional rehabilitation. After 6 weeks, the graft is fixed by woven bone or bony integration. Implanted microporous tricalcium phosphate is resorbed and replaced by bone.

CLINICAL RELEVANCE

In a sheep model we showed that primary healing of ACL grafts with resorption and bony replacement of the fixating implant can be achieved by means of press-fit fixation with pure beta-TCP.