High-temperature multipass cell for infrared spectroscopy of heated gases and vapors

Automated broad tuning of difference frequency sources for spectroscopic studies

Transmission spectroscopy over large spectral ranges (>100 cm(-1)) generally requires a reference measurement to be taken separately from the sample scan. The ratio of the two measurements (i.e., the transmittance) is therefore susceptible to baseline changes that occur between the recording of the two spectra. The origins of relatively strong baseline changes (≫1%) of a difference-frequency-generation-based laser spectrometer (tuning range 2900-3144 cm(-1), 150 μW average power) were investigated and a method for minimizing them by improving reproducibility and reducing measurement time is presented. The new method was tested for a gas mixture and the sensitivity for broad absorption features was determined as 5×10(-3) minimum measurable absorbance for a total scan duration of 70 min.

Infrared spectroscopy on smoke produced by cauterization of animal tissue

In view of in vivo surgical smoke studies a difference-frequency-generation (DFG) laser spectrometer (spectral range 2900–3144 cm⁻¹) and a Fourier-transform infrared (FTIR) spectrometer were employed for infrared absorption spectroscopy. The chemical composition of smoke produced in vitro with an electroknife by cauterization of different animal tissues in different atmospheres was investigated. Average concentrations derived are: water vapor (0.87%), methane (20 ppm), ethane (4.8 ppm), ethene (17 ppm), carbon monoxide (190 ppm), nitric oxide (25 ppm), nitrous oxide (40 ppm), ethyne (50 ppm) and hydrogen cyanide (25 ppm). No correlation between smoke composition and the atmosphere or the kind of cauterized tissue was found.

Laser-based human breath analysis: D/H isotope ratio increase following heavy water intake

Following the ingestion of only 5.1 mL of D2O, a mid-infrared laser spectrometer determines the D/H isotope ratio increase in exhaled water vapor for the first time, to the best of our knowledge. This increase is still detectable several weeks after the heavy water intake. Collected breath samples are directly transferred into a high-temperature multipass cell operated at 373 K. No breath sample preparation is required. Aside from the capability to hinder unwanted condensation, measurements at elevated temperatures offer other advantages such as a lower temperature dependence of the delta value or the possibility to vary the intensity of absorption lines. We lay the foundation for many laser-based clinical applications. As an example, we measure a total body water weight of 55.2%+/-1.8% with respect to the total body weight, in agreement with the normal value of the male population.

Improved algorithm for quantitative analyses of infrared spectra of multicomponent gas mixtures with unknown compositions

We present a major improvement of an algorithm based on a spectral library search for the quantitative analysis of multicomponent gas samples with unknown compositions. A quantitative spectral database of infrared spectra is used as a training set to compute regression coefficients. Concentrations are computed in the principal component space via principal component regression (PCR). In addition to previous algorithms, we introduce a rating for each candidate substance depending on the concentration found with PCR and a filter that removes candidates that are predicted with negative concentrations if their rating is below a certain threshold. Negative concentrations arise when the measured spectrum contains components that are not contained in the database. The PCR is recomputed until all candidates have a rating above the threshold. Then an adaptive filter "subtracts" the substance with the highest rating from both the measured spectrum and the library and appends it to a hit list. The iteration of this procedure directly produces a list of substances in order of descending importance (i.e., contribution to the measured absorbance) with their corresponding concentrations. The algorithm is tested on spectra of multicomponent surgical smoke samples. The four main components (water, methane, ethane, and ethene) are identified correctly (within the top 5 of the hit list) for an appropriate choice of the rating threshold. The algorithm describes the composition of the smoke sample correctly despite the presence of features in the spectrum that cannot be explained by the spectrum of any single substance present in the database.

Vapor-phase infrared laser spectroscopy: from gas sensing to forensic urinalysis

Numerous gas-sensing devices are based on infrared laser spectroscopy. In this paper, the technique is further developed and, for the first time, applied to forensic urinalysis. For this purpose, a difference frequency generation laser was coupled to an in-house-built, high-temperature multipass cell (HTMC). The continuous tuning range of the laser was extended to 329 cm(-1) in the fingerprint C-H stretching region between 3 and 4 microm. The HTMC is a long-path absorption cell designed to withstand organic samples in the vapor phase (Bartlome, R.; Baer, M.; Sigrist, M. W. Rev. Sci. Instrum. 2007, 78, 013110). Quantitative measurements were taken on pure ephedrine and pseudoephedrine vapors. Despite featuring similarities, the vapor-phase infrared spectra of these diastereoisomers are clearly distinguishable with respect to a vibrational band centered at 2970.5 and 2980.1 cm(-1), respectively. Ephedrine-positive and pseudoephedrine-positive urine samples were prepared by means of liquid-liquid extraction and directly evaporated in the HTMC without any preliminary chromatographic separation. When 10 or 20 mL of ephedrine-positive human urine is prepared, the detection limit of ephedrine, prohibited in sports as of 10 microg/mL, is 50 or 25 microg/mL, respectively. The laser spectrometer has room for much improvement; its potential is discussed with respect to doping agents detection.

Gas detection by correlation spectroscopy employing a multimode diode laser

A gas sensor based on the gas-correlation technique has been developed using a multimode diode laser (MDL) in a dual-beam detection scheme. Measurement of CO(2) mixed with CO as an interfering gas is successfully demonstrated using a 1570 nm tunable MDL. Despite overlapping absorption spectra and occasional mode hops, the interfering signals can be effectively excluded by a statistical procedure including correlation analysis and outlier identification. The gas concentration is retrieved from several pair-correlated signals by a linear-regression scheme, yielding a reliable and accurate measurement. This demonstrates the utility of the unsophisticated MDLs as novel light sources for gas detection applications.