A spectroscopic study of fluorescence from the second excited singlet state of thiophosgene vapor

Symmetry segregation of the vibronic levels within the S1←S0 system of thiophosgene, Cl2CS, by optical-optical double resonance spectroscopy

The first singlet-singlet electronic system, S1<--S0, in thiophosgene has been recorded as a laser induced fluorescence (LIF) excitation and an optical-optical double resonance (OODR) spectrum under jet-cooled conditions. In the OODR process, the sum of the frequencies of the pump and probe lasers must be fixed to the energy difference between a pair of vibronic levels in the S2(v') and S0(v") states. Detection is through the fluorescence from the S2 state. The blocking of a spectrum into its four possible symmetry components is obtained by adjusting the total pump+probe energy such that it matches the energy difference between symmetry selected levels in the S2 and S0 electronic states. In this method the pump laser is used to excite a group of "hot" sequence bands that involve combinations of the nu4 and nu6 antisymmetric vibrations. The additional data that were collected by this method were used to update and refine the analyses of the spectrum. Magnetic dipole transitions are reported for the first time.

Insights into dynamics of the S2 state of thiophosgene from ab initio calculations

The S2 potential energy surface for Cl2CS dissociation has been characterized with a combined complete active space self-consistent field and multireference configuration interaction method. The S3/S2 minimum-energy intersection has been determined with the state-averaged complete active space self-consistent field method. The S2 direct dissociation was found to have a barrier of 6.0 kcal/mol, leading to formation of Cl(X2P)+ClCS(A2A") in the excited electronic state. Dynamics of the S2 state of Cl2CS can be summarized as follows: (1) The S2-S0 fluorescence occurs with high quantum yield at low excess energies; (2) Both the S(2) dissociation and the S2-->S3 internal conversion cause the loss of the S2-S0 fluorescence upon photoexcitation at 235-253 nm; (3) The S2-->S3 internal conversion (IC) followed by the direct IC to the ground electronic state results in the fragments produced in the ground state, while the S2 dissociation leads to formation of the fragments in excited electronic states.

S(1S) production following electron impact on thiophosgene (Cl2CS)

A special xenon matrix detector has been used to study the production of S(1S) following controlled electron impact on thiophosgene (Cl2CS) targets over an electron energy range from threshold to 400 eV. Time-of-flight spectroscopy has been used to measure S(1S) fragment kinetic energies. Fragments with energies in excess of 1 eV have been observed. The absolute cross section for S(1S) production reaches a maximum of [1.05+/-0.35] x 10(-18) cm2 at approximately 125 eV impact energy. Two different fragmentation processes, involving triplet and singlet excited states of the parent Cl2CS molecule, have been identified.