Photo- versus pulsed field-ionization of individual high n (n≲57) Rydberg states: Resolved d,g series of benzene

On the magnetic circular dichroism of benzene. A density-functional study

Spectroscopy of magnetic circular dichroism (MCD) provides enhanced information on molecular structure and a more reliable assignment of spectral bands than absorption alone. Theoretical modeling can significantly enhance the information obtained from experimental spectra. In the present study, the time dependent density functional theory is employed to model the lowest-energy benzene transitions, in particular to investigate the role of the Rydberg states and vibrational interference in spectral intensities. The effect of solvent is explored on model benzene-methane clusters. For the lowest-energy excitation, the vibrational sub-structure of absorption and MCD spectra is modeled within the harmonic approximation, providing a very good agreement with the experiment. The simulations demonstrate that the Rydberg states have a much stronger effect on the MCD intensities than on the absorption, and a very diffuse basis set must be used to obtain reliable results. The modeling also indicates that the Rydberg-like states and associated transitions may persist in solutions. Continuum-like solvent models are thus not suitable for their modeling; solvent-solute clusters appear to be more appropriate, providing they are large enough.

Vibrations and theoretical calculations of p-methylanisole in the first electronically excited S1 and ionic ground D0 states

One-color (1C), two-color (2C) resonant two-photon ionization (R2PI), and mass analyzed threshold ionization (MATI) methods have been applied to study the S(1)<--S(0) transition and threshold ionization of p-methylanisole. The excitation energy of the S(1)<--S(0) transition is determined to be 35,401+/-2 cm(-1), the adiabatic ionization energy of this molecule is measured to be 63,965+/-15 and 63,972+/-5 cm(-1) by the 2C-R2PI and MATI methods. Most of the observed R2PI and MATI bands result from the in-plane ring vibrations. The frequencies of vibrations 9b, 1 and 7a are measured to be 393, 800 and 1168 cm(-1) in the S(1) state, and 412, 811 and 1220 cm(-1) in the D(0) state, respectively. This indicates the molecular structure in the D(0) state is more rigid than that in the S(1) state.

The Jahn–Teller effect in the lower electronic states of benzene cation. III. The ground-state vibrations of C6H6+ and C6D6+

New mass analyzed threshold ionization (MATI) spectra of the molecules C(6)H(6) (+) and C(6)D(6) (+) have been collected using tunable vacuum ultraviolet (VUV) single photon excitation from the neutral ground state and also using two-photon excitation through the 6(1) vibration of the (1)B(2u) S(1) state. Emphasis was placed on obtaining accurate relative intensities of the vibrational lines in order to use this information in the vibronic analysis. The MATI spectra collected from VUV (S(0) originating state), triplet (T(1)), and resonant two photon (S(1)) excitation schemes were compared with Jahn-Teller calculations employing the classical model of Longuet-Higgins and Moffitt to obtain the Jahn-Teller coupling parameters of 3 of the 4 linearly active modes (e(2g) modes 6-9 in Wilson's notation). Franck-Condon factors, including the effects of geometry changes, were calculated from the vibronic wave functions and used to identify the lines in the various spectra. It is found that most of the lines with substantial intensity can be understood using only the modes 1, 6, 8, and 9. Weaker peaks are due to various non-e(2g) modes, but these do not derive intensity through Jahn-Teller coupling. When the effects of geometry change were included, simulations of the spectra from the calculated vibrational energies and intensities were close to the experimental spectra. This verifies the applicability of the model to the understanding of the vibrational structure of this type of molecule, but some variations indicate directions for further improvement of the model.