Highly efficient and selective pressure-assisted photon-induced polymerization of styrene

Mechanistic Insights of Multiplexed Effects of Pressure, Physical States, and Laser on the Polymerization Kinetics of Phenylacetylene Probed by In Situ FTIR Spectroscopy

High-pressure tuned polymerization kinetics have been examined to elucidate the (photon-assisted) polymerization mechanism of phenylacetylene (PA, C₆H₅C≡CH₃) under different stimuli including high-pressure, physical state, and UV radiation effects by using in situ FTIR spectroscopy. The pressure-induced glass-forming and crystalline states of PA are found to be formed at different compression rates. The experimental results suggest that the polymerization is induced in the glass-forming state at a very low pressure in contrast to that in the crystal phase where much higher threshold pressure is required. The measured rate constants were found to strongly depend on the pressure, the physical state, and UV radiation. In particular, the rate constant reduced to different extents either by UV irradiation or upon phase transition. The derived activation volumes from the rate constants allow the direct comparison and elucidation of photoactivation and environmental effects on the polymerization. Finally, the diffusion-controlled 1D polymer growth processes were suggested for the glass-forming state or the crystal state at specific pressures. Overall, the mechanistic insights of this work provide guidance of optimizing the multiplexed reaction conditions for the production of the conducting poly(PA).

Pressure-induced amorphization and reactivity of solid dimethyl acetylene probed by in situ FTIR and Raman spectroscopy

Conjugated polymers are prominent semiconductors that have unique electric conductivity and photoluminescence. Synthesis of conjugated polymers under high pressure is extremely appealing because it does not require a catalyst or solvent used in conventional chemical methods. Transformation of acetylene and many of its derivatives to conjugated polymers using high pressure has been successfully achieved, but not with dimethyl acetylene (DMA). In this work, we present a high-pressure study on solid DMA using a diamond anvil cell up to 24.4 GPa at room temperature characterized by in situ Fourier transform infrared and Raman spectroscopy. Our results show that solid DMA exists in a phase II crystal structure and is stable up to 12 GPa. Above this pressure, amorphization was initiated and the process was completed at 24.4 GPa. The expected polymeric transformation was not evident upon compression, but only observed upon decompression from a threshold compression pressure (e.g. 14.4 GPa). In situ florescence measurements suggest excimer formation via crystal defects, which induces the chemical reactions. The vibrational spectral analysis suggests the products contain the amorphous poly(DMA) and possibly additional amorphous hydrogenated carbon material.

Pressure-selected reactivity between 2-butyne and water induced by two-photon excitation

High-pressure photochemistry between 2-butyne (H3CC≡CCH3) and trace amount of H2O was investigated at room temperature using multiline UV radiation at λ ≈ 350 nm and monitored by FTIR spectroscopy. Instead of the expected polymerization of 2-butyne, the IR spectral analysis suggests the formation of cis- and trans-2-butene, as well as 2-butanone, as the primary products. The possible reaction mechanisms and production pathways of these products were examined, where the dissociation of water molecule as the other reactant is believed as the essential step of the photochemical reaction. We further found that initial loading pressure of the mixture can not only substantially influence the reaction kinetics, but also regulate the accessibilities to some reaction channels, which was evidenced by quantitative analysis of the characteristic IR bands of 2-butene and 2-butanone. The relative abundance of two products is found to be highly dependent on pressure and radiation time. This study provides attractive physical routes in the absence of solvents, catalysts, and radical initiators, to synthesis the relevant products with a great selectivity and feasibility.