Cleavage of the Graft Bonds in PVDF-g-St Films by Boiling Xylene Extraction and the Determination of the Molecular Weight of the Graft Chains

To determine the molecular weight of graft chains in grafted films, the polystyrene graft chains of PVDF-g-St films synthesized by a pre-irradiation graft method are cleaved and separated by boiling xylene extraction. The analysis of the extracted material and the residual films by FTIR, nuclear magnetic resonance (NMR), and gel permeation chromatography (GPC) analyses indicates that most graft chains are removed from the PVDF-g-St films within 72 h of extraction time. Furthermore, the molecular weight of the residual films decreases quickly within 8 h of extraction and then remains virtually unchanged up to 72 h after extraction time. The degradation is due to the cleavage of graft bonds, which is mainly driven by the thermal degradation and the swelling of graft chains in solution. This allows determination of the molecular weight of graft chains by GPC analysis of the extracted material. The results indicate that the PVDF-g-St prepared in this study has the structure where one or two graft chains hang from each PVDF backbone.

Stability and Degradation Mechanisms of Radiation-Grafted Polymer Electrolyte Membranes for Water Electrolysis

Radiation-grafted membranes are a promising alternative to commercial membranes for water electrolyzers, since they exhibit lower hydrogen crossover and area resistance, better mechanical properties, and are of potentially lower cost than perfluoroalkylsulfonic acid membranes, such as Nafion. Stability is an important factor in view of the expected lifetime of 40 000 h or more of an electrolyzer. In this study, combinations of styrene (St), α-methylstyrene (AMS), acrylonitrile (AN), and 1,3-diisopropenylbenzene (DiPB) are cografted into 50 μm preirradiated poly(ethylene-co-tetrafluoroethylene) (ETFE) base film, followed by sulfonation to produce radiation-grafted membranes. The stability of the membranes with different monomer combinations is compared under an accelerated stress test (AST), and the degradation mechanisms are investigated. To mimic the conditions in an electrolyzer, in which the membrane is always in contact with liquid water at elevated temperature, the membranes are immersed in water for 5 days at 90 °C, so-called thermal stress test (TST). In addition to testing in air atmosphere tests are also carried out under argon to investigate the effect of the absence of oxygen. The water is analyzed with UV-vis spectroscopy and ion chromatography. The ion exchange capacity (IEC), swelling degree, and Fourier transform infrared (FTIR) spectra of the membranes are compared before and after the test. Furthermore, energy-dispersive X-ray (EDX) spectroscopic analysis of the membrane cross-section is performed. Finally, the influence of the TST to the membrane area resistance and hydrogen crossover is measured. The stability increases along the sequence St/AN, St/AN/DiPB, AMS/AN, and AMS/AN/DiPB grafted membrane. The degradation at the weak-link, oxygen-induced degradation, and hydrothermal degradation are proposed in addition to the "swelling-induced detachment" reported in the literature. By mitigating the possible paths of degradation, the AMS/AN/DiPB grafted membrane is shown to be the most stable membrane and, therefore, it is a promising candidate for a membrane to be used in a water electrolyzer.