Illuminating the physics of dynamic friction through laboratory earthquakes on thrust faults

Intermittent lab earthquakes in dynamically weakening fault gouge

Large and destructive earthquakes on mature faults in Earth's crust occur as slip in a layer of a fine granular material-fault gouge-produced by comminution during sliding^1,2. A range of insights into the frictional resistance of faults-one of the main factors controlling earthquake nucleation, dynamic propagation and arrest, and hence the destructive ground shaking of earthquakes^2,3-has been obtained in experiments with spatially uniform slip imposed in small samples^2,4-21. However, how various features of gouge friction combine to determine spontaneous progression of earthquakes is difficult to study in the lab owing to substantial challenges with sample sizes and adequate imaging²². Here, using lab experiments, we show that spontaneously propagating dynamic ruptures navigate a fault region with fine rock gouge through complex, intermittent slip processes with dramatic friction evolution. These include repeated arrest of rupture propagation caused by friction strengthening at lower slip rates and dynamic earthquake re-nucleation enabled by pronounced rapid friction weakening at higher slip rates consistent with flash heating^8,12,23. The spontaneous repeated weakening and strengthening of friction in fine rock gouge highlights the fundamental dependence of friction on slip rate and associated processes, such as shear heating, localization and delocalization of shear, and dilation and compaction of the shear layer^6,7,9-21. Our findings expand experimental support^9,11 of the concept that co-seismic weakening may enable earthquake rupture to break through stable fault regions^24,25, with substantial implications for seismic hazard.

Dynamic rupture initiation and propagation in a fluid-injection laboratory setup with diagnostics across multiple temporal scales

Fluids are known to trigger a broad range of slip events, from slow, creeping transients to dynamic earthquake ruptures. Yet, the detailed mechanics underlying these processes and the conditions leading to different rupture behaviors are not well understood. Here, we use a laboratory earthquake setup, capable of injecting pressurized fluids, to compare the rupture behavior for different rates of fluid injection, slow (megapascals per hour) versus fast (megapascals per second). We find that for the fast injection rates, dynamic ruptures are triggered at lower pressure levels and over spatial scales much smaller than the quasistatic theoretical estimates of nucleation sizes, suggesting that such fast injection rates constitute dynamic loading. In contrast, the relatively slow injection rates result in gradual nucleation processes, with the fluid spreading along the interface and causing stress changes consistent with gradually accelerating slow slip. The resulting dynamic ruptures propagating over wetted interfaces exhibit dynamic stress drops almost twice as large as those over the dry interfaces. These results suggest the need to take into account the rate of the pore-pressure increase when considering nucleation processes and motivate further investigation on how friction properties depend on the presence of fluids.

Evolution of dynamic shear strength of frictional interfaces during rapid normal stress variations

Pressure shear plate impact tests have revealed that when normal stress changes rapidly enough, the frictional shear resistance is no longer proportional to the normal stress but rather evolves with slip gradually. Motivated by these findings, we focus on characterizing the dynamic shear strength of frictional interfaces subject to rapid variations in normal stress. To study this problem, we use laboratory experiments featuring dynamic shear cracks interacting with a free surface and resulting in pronounced and rapid normal stress variations. As dynamic cracks tend to propagate close to the wave speeds of the material, capturing their behavior poses the metrological challenge of resolving displacements on the order of microns over timescales microseconds. Here we present our novel approach to quantify the full-field behavior of dynamic shear ruptures and the evolution of friction during sudden variations in normal stress, based on ultrahighspeed photography (at 1-2 million frames/sec) combined with digital image correlation. Our measurements allow us to capture the evolution of dynamic shear cracks during these short transients and enable us to decode the nature of dynamic friction.