Pyrolysis mass spectrometry (PyMS) and 16S-23S rDNA spacer region fingerprinting suggests the presence of novel acinetobacters in activated sludge

Identification of Microorganisms from Several Surfaces by MALDI-TOF MS: P. aeruginosa Is Leading in Biofilm Formation

New ecological trends and changes in consumer behavior are known to favor biofilm formation in household appliances, increasing the need for new antimicrobial materials and surfaces. Their development requires laboratory-cultivated biofilms, or biofilm model systems (BMS), which allow for accelerated growth and offer better understanding of the underlying formation mechanisms. Here, we identified bacterial strains in wildtype biofilms from a variety of materials from domestic appliances using matrix-assisted laser desorption/ionization-time of flight mass spectroscopy (MALDI-TOF-MS). Staphylococci and pseudomonads were identified by MALDI-TOF-MS as the main genera in the habitats and were analyzed for biofilm formation using various in vitro methods. Standard quantitative biofilm assays were combined with scanning electron microscopy (SEM) to characterize biofilm formation. While Pseudomonas putida, a published lead germ, was not identified in any of the collected samples, Pseudomonas aeruginosa was found to be the most dominant biofilm producer. Water-born Pseudomonads were dominantly found in compartments with water contact only, such as in detergent compartment and detergent enemata. Furthermore, materials in contact with the washing load are predominantly colonized with bacteria from the human.

Estimation of ribosomal RNA operon (rrn) copy number in Acinetobacter isolates and potential of patterns of rrn operon-containing fragments for typing strains of members of this genus

The copy number of the rrn operon in 70 strains of Acinetobacter including the type strains of almost all the genomic species with validated names was estimated after digestion of their genomic DNA by the restriction enzymes BglII and PstI, and Southern blotting. Copy number estimates varied between and among species, with between 3 and 7 rrn operon copies detected. Copy number estimates obtained from the same strain with the two enzymes sometimes varied. BglII generated RFLP patterns of the rrn containing fragments obtained from Southern blots after agarose gel electrophoresis were examined for their value in identifying Acinetobacter isolates. This method was very reproducible with the same fragment pattern always generated from the same isolate on repeated analysis. Often multiple strains of the same genomic species gave identical or very similar patterns (e.g. Acinetobacter baylyi), clustering closest together on the dendrogram generated after numerical analysis of these patterns. However, with some, like BG5 and BG8, the patterns derived from the different strains, some of which had been placed in this genomic species from DNA:DNA hybridization data, varied considerably to each other and to the type strain. Little similarity was seen when relationships between these strains based on these patterns were compared to those using DNA:DNA hybridization data. Often these patterns could be used to question earlier identification of strains using phenotypic characters. Thus, strain AB82 thought to belong to genomic species 5 gave an identical pattern to A. bouvetii(T) (DSM 14964). In some cases this pattern analysis suggested that novel species of Acinetobacter might exist among the strains examined.

The rapid identification of Acinetobacter species using Fourier transform infrared spectroscopy

AIMS

Fourier transform infrared (FT-IR) was used to analyse a selection of Acinetobacter isolates in order to determine if this approach could discriminate readily between the known genomic species of this genus and environmental isolates from activated sludge.

METHODS AND RESULTS

FT-IR spectroscopy is a rapid whole-organism fingerprinting method, typically taking only 10 s per sample, and generates 'holistic' biochemical profiles (or 'fingerprints') from biological materials. The cluster analysis produced by FT-IR was compared with previous polyphasic taxonomic studies on these isolates and with 16S-23S rDNA intergenic spacer region (ISR) fingerprinting presented in this paper. FT-IR and 16S-23S rDNA ISR analyses together indicate that some of the Acinetobacter genomic species are particularly heterogeneous and poorly defined, making characterization of the unknown environmental isolates with the genomic species difficult.

CONCLUSIONS

Whilst the characterization of the isolates from activated sludge revealed by FT-IR and 16S-23S rDNA ISR were not directly comparable, the dendrogram produced from FT-IR data did correlate well with the outcomes of the other polyphasic taxonomic work.

SIGNIFICANCE AND IMPACT OF THE STUDY

We believe it would be advantageous to pursue this approach further and establish a comprehensive database of taxonomically well-defined Acinetobacter species to aid the identification of unknown strains. In this instance, FT-IR may provide the rapid identification method eagerly sought for the routine identification of Acinetobacter isolates from a wide range of environmental sources.

Seven novel species of Acinetobacter isolated from activated sludge

Thirteen isolates of Acinetobacter were obtained from activated sludge plants in Victoria, Australia. Earlier 16S-23S rDNA genomic fingerprinting and partial 16S rDNA sequence data had suggested that these isolates might contain previously undescribed species. This view was confirmed here. A polyphasic taxonomic approach involving phenotypic characterization, near-complete 16S rDNA sequence data and DNA-DNA hybridization analyses support the view that seven novel genomic species can be differentiated in this group of isolates. However, when fluorescence in situ hybridization (FISH) studies were performed with a 16S-rRNA-targeted probe specific for the genus Acinetobacter, used to identify Acinetobacter in activated sludge plants, all these strains responded positively. This suggests that these isolates would not have been missed in earlier FISH studies where their role as polyphosphate-accumulating bacteria has been questioned. This report describes these isolates and proposes that they be named Acinetobacter baylyi (type strain B2T = DSM 14961T = CIP 107474T), Acinetobacter bouvetii (type strain 4B02T = DSM 14964T = CIP 107468T), Acinetobacter grimontii (type strain 17A04T = DSM 14968T = CIP 107470T), Acinetobacter tjernbergiae (type strain 7N16T = DSM 14971T = CIP 107465T), Acinetobacter towneri (type strain AB1110T = DSM 14962T = CIP 107472T), Acinetobacter tandoii (type strain 4N13T = DSM 14670T = CIP 107469T) and Acinetobacter gerneri (type strain 9A01T = DSM 14967T = CIP 107464T).

The microbiology of biological phosphorus removal in activated sludge systems

Activated sludge systems are designed and operated globally to remove phosphorus microbiologically, a process called enhanced biological phosphorus removal (EBPR). Yet little is still known about the ecology of EBPR processes, the microbes involved, their functions there and the possible reasons why they often perform unreliably. The application of rRNA-based methods to analyze EBPR community structure has changed dramatically our understanding of the microbial populations responsible for EBPR, but many substantial gaps in our knowledge of the population dynamics of EBPR and its underlying mechanisms remain. This review critically examines what we once thought we knew about the microbial ecology of EBPR, what we think we now know, and what still needs to be elucidated before these processes can be operated and controlled more reliably than is currently possible. It looks at the history of EBPR, the currently available biochemical models, the structure of the microbial communities found in EBPR systems, possible identities of the bacteria responsible, and the evidence why these systems might operate suboptimally. The review stresses the need to extend what have been predominantly laboratory-based studies to full-scale operating plants. It aims to encourage microbiologists and process engineers to collaborate more closely and to bring an interdisciplinary approach to bear on this complex ecosystem.