Effect of dentifrice containing fTCP, CPP-ACP and fluoride in the prevention of enamel demineralization

Influence of calcium-based desensitizing toothpastes on the bonding performance of universal adhesive

The study evaluated the effect of calcium-based desensitizing toothpastes on the dentinal tubule occlusion and its influence on the dentin bond strength of universal adhesive. Mid-coronal dentin samples were prepared for hypersensitivity model and treated by the following calcium-based desensitizing toothpastes: no treatment (Control), Clinpro (fTCP), Pro-Relief (Pro-Argin), and Repair & Protect (Novamin). Single Bond Universal adhesive was applied in self-etch or etch-and-rinse mode. The dentinal tubule occlusion and adhesion interface were evaluated under scanning electron microscope (SEM). A double-fluorescence technique was used to examine interfacial permeability under confocal laser scanning microscopy (CLSM). The micro-tensile bond strength (μTBS) was employed, followed by the fracture interface observation. SEM showed the toothpastes occluded dentinal tubules, and the occlusion exhibited stability against acid and abrasion. Hindered resin infiltration was observed in the adhesion interface after desensitization. CLSM showed more water permeation within or under the adhesion interface in etch-and-rinse mode than self-etch mode. Desensitization decreased the μTBS in self-etch mode. When using etch-and-rinse mode, the desensitized samples presented similar μTBS to the control group. No difference in μTBS was found between the two bonding modes, except for the control group. Calcium-based desensitizing toothpastes can effectively occlude the exposed dentinal tubules with acid-resistant and abrasion-resistant stability. The desensitization reduced the dentin bond strength of the universal adhesive system in self-etch mode but did not affect the bond strength of etch-and-rinse mode.

Effectiveness of CPP-ACP and Fluoride Products in Tooth Remineralization

OBJECTIVES

To compare the effectiveness of the casein phosphopeptide-stabilized amorphous calcium phosphate (CPP-ACP) in the in situ remineralization of enamel exposed to two different degrees of preformed enamel lesions.

METHODS

One hundred and sixty 3x3x2 mm human enamel slabs were demineralized and divided into two subgroups according to baseline surface hardness (SH=B1≤150 and B2 >150). During each of four 10-day experimental periods, 10 participants wore intraoral removable acrylic palatal expanders with four human enamel slabs with preformed lesions (B1 and B2): CO1 and CO2 - Control: silica dentifrice without fluoride; MP1 and MP2: MI Paste; MPP1 and MPP2: MI Paste Plus; and FD1 and FD2: Fluoride dentifrice. The Knoop hardness test (50/15s Micromet 2001, Buehler, IL, USA) was performed after demineralization (B1 and B2) and after treatment (T1 and T2).

RESULTS

SH was higher in all treatment groups when compared with the controls, except for CO2 (Mann Whitney Wilcoxon Test; p <0.05). %SH was similar between MPP2 and FD2 and between MPP2 and MP2; however, FD2 and MPP2 products were more effective in microhardness recovery. In B1, all treatment groups were similar.

CONCLUSION

MPP and FD are more effective in preventing demineralization in enamel subsurface lesions.

Remineralization of enamel subsurface lesions using toothpaste containing tricalcium phosphate and fluoride: an in vitro µCT analysis

Background

This study aimed to compare the efficacies of experimental toothpastes containing functionalized tricalcium phosphate (fTCP) with and without fluoride for in vitro enamel remineralization under pH-cycling conditions.

Methods

To create artificial white spot lesions, 36 bovine enamel specimens were immersed in a demineralization solution for 10 days. During pH-cycling for 12 days, the specimens were divided into four groups based on the experimental toothpaste type used: (a) fTCP-free, fluoride-free (fTCP − F −); (b) fTCP-containing, fluoride-free (fTCP + F −); (c) fTCP-free, fluoride-containing (fTCP − F +); and (d) fTCP-containing, fluoride-containing (fTCP + F +). Micro-focus X-ray computed tomography (μCT) scans of all specimens were obtained before demineralization, after demineralization, and after pH-cycling. The mineral density and mineral loss (ΔZ) in the enamel subsurface lesions were measured and the percentage of remineralization (%R) was calculated from ΔZ after demineralization and pH-cycling. One-way ANOVA with Tukey’s test was used for statistical analysis of the %R values. The treated enamel surface was investigated via scanning electron microscopy (SEM).

Results

The fTCP − F − group presented with the lowest amount of mineral gain after pH-cycling. In contrast, the fTCP + F + group showed the highest degree of remineralization within all lesion parts. The %R was highest in the fTCP + F + group (38.2 ± 7.8, all P < 0.01). SEM revealed the presence of small crystals on the enamel rods in the fTCP + F − and fTCP + F + groups.

Conclusions

The experimental toothpaste containing fTCP and fluoride increased remineralization of the artificial enamel subsurface lesions during pH-cycling. Furthermore, fTCP and fluoride appear to act independently on the remineralization of enamel subsurface lesions, although they coexisted in one toothpaste type.

Trial registration: This is not a human subject research.

Effect of CPP-ACP on remineralization of artificial caries-like lesion: an in situ study

The purpose of this double-blind, randomized, crossover in situ study is to compare remineralization of preformed enamel lesions by casein phosphopeptide-stabilized amorphous calcium phosphate (CPP-ACP) and fluoride dentifrice products. During each of four 10-day experimental legs, 10 participants wore intraoral removable palatal acrylic appliances with four human enamel slabs with preformed lesions. A 0.03-mL treatment paste was dripped extraorally onto the enamel blocks once a day for 3 min. The four randomly allocated treatments were as follows: CO- Control: silica dentifrice without fluoride; MP: MI Paste; MPP: MI Paste Plus and FD: Fluoride dentifrice - 1100 ppm F as NaF). Knoop surface hardness (SH) test was performed in three stages (T0 - sound enamel, T1 - after preformed lesion, and T2 - after treatment) and the cross-sectional hardness (CSH) test was performed after treatment using a 50-gram Knoop load for 15 s. Knoop hardness number (KHN) was similar between treatments. %SHr was significantly higher in the MP, FD, and MPP when compared to CO group (Kruskal-Wallis and Mann-Whitney tests, p < 0.05). Harder enamel was found in MP (75 μm) and FD groups at 75 to 175 μm. Treatment with DF, MP, and MPP promoted an increase of 20.27%, 19.24%, and 14.71%, respectively, in Integral Hardness Change (ΔIHC) when compared to CO (p<0.05). Remineralizing agents (MP, MPP, and DF) were able to inhibit demineralization of human enamel subjected to high cariogenic challenge in situ. DF had the greatest preventive potential against the progression of carious lesions.

In Vitro Comparison of Fluoride, Magnesium, and Calcium Phosphate Materials on Prevention of White Spot Lesions around Orthodontic Brackets

One common negative side effect of orthodontic treatment with fixed appliances is the development of white spot lesions (WSLs) around brackets. This study is aimed at comparing the efficacy of various oral hygiene practices in preventing enamel demineralization around orthodontic brackets under similar in vitro conditions. The study included 90 extracted bovine incisors, which were randomized into six groups: fluoride toothpaste (FT), nonfluoride toothpaste (NFT), fluoride varnish plus fluoride toothpaste (FV+FT), CPP-ACP varnish plus fluoride toothpaste (CPP-ACP+FT), medical minerals gel plus nonfluoride toothpaste (MMG+NFT), and no intervention (control). All groups were subjected to demineralization and remineralization cycles. Visual appraisals were used to evaluate the changes in the enamel surface appearance at the beginning and end of the experiment. The changes in the demineralization degree were evaluated by measuring the Ca⁺² concentration in the demineralization solution at different time points. The majority of teeth in the CPP-ACP+FT group exhibited no shift in appearance, whereas in the other groups, a slight change in enamel translucency was observed. At all the time points, the Ca⁺² concentration in the demineralization solution in the CPP-ACP+FT group was the least among all other groups. At day 5, MMG+NFT's preventive efficacy was significantly higher than FV+FT's, but at days 10, 15, and 19, their efficacy was similar. However, at all the time points, MMG+NFT's efficacy was significantly higher than that of control, whereas FV+FT's efficacy was decreased at days 10, 15, and 19 and was close to the efficacy of control. To fight WSLs, early diagnosis was of great importance and examination of the tooth surface after air-drying for 5 s was recommended.

The Effect of Remineralizing Agents With/Without CO2 Laser Irradiation on Structural and Mechanical Properties of Enamel and its Shear Bond Strength to Orthodontic Brackets

Introduction: Remineralizing agents may be used for the treatment of white spot lesions (WSLs) prior to bracket bonding. However, some concerns exist regarding their possible interference with the etching and bonding process, negatively affecting the bond strength. This study aimed to assess the effect of two remineralizing agents with/without CO₂ laser irradiation on the mechanical properties and shear bond strength (SBS) of demineralized enamel to the orthodontic bracket. Methods: This study evaluated 60 premolar teeth in 6 groups (n=10) as follows: (I) sound enamel, (II) demineralized enamel, (III) Nupro remineralizing agent (N), (IV) Nupro and CO₂ laser (N/L), (V) Teethmate remineralizing agent (T), and (VI) Teethmate and CO₂ laser (T/L). The remineralizing agents were applied to the enamel surfaces after their immersion in a demineralizing solution for 5 days. In groups IV and VI, the CO₂ laser with a 10.6 μm wavelength, 10 ms pulse duration, a 50 Hz repetition rate, 0.3 mm beam diameter and 0.7 W power was irradiated after applying the remineralizing agents. Brackets were bonded to the enamel surfaces and SBS was measured by a universal testing machine. For the assessment of enamel microhardness, 20 sections of molar teeth were divided into 4 groups (n=5; N, N/L, T, T/L) and their microhardness was measured before demineralization, after demineralization and after remineralization. X-ray diffraction (XRD) analysis, field-emission scanning electron microscopy (FESEM) and energy-dispersive spectrometry (EDS) were carried out to assess the formation of hydroxyapatite. The atomic percentages of the C, O, P, Ca, Na, Si, F and Ca/P ratio were determined by EDS analysis. Results: The SBS significantly decreased in group II (P<0.001). There was no significant difference among the groups I, III, IV, V and VI (P<0.05). This finding was similar to the microhardness results, which showed an increase in microhardness after remineralization (P<0.05), with no difference among the remineralizing agents. The Ca/P ratio was the highest in the Nupro group and the lowest in the demineralized group. Conclusion: Remineralizing agents can significantly improve the microhardness and structural properties of demineralized enamel to a level similar to that of sound enamel with no adverse effect on SBS to orthodontic brackets.