Flow‐Injection Spectrophotometric Determination of N‐acetylcysteine in Pharmaceutical Formulations with On‐Line Solid‐Phase Reactor Containing Zn(II) Phosphate Immobilized in a Polyester Resin

Application of novel Ni(II) complex and ZrO2 nanoparticle as mediators for electrocatalytic determination of N-acetylcysteine in drug samples

The electrooxidation of N-acetylcysteine (N-AC) was studied by a novel Ni(II) complex modified ZrO₂ nanoparticle carbon paste electrode [Ni(II)/ZrO₂/NPs/CPE] using voltammetric methods. The results showed that Ni(II)/ZrO₂/NPs/CPE had high electrocatalytic activity for the electrooxidation of N-AC in aqueous buffer solution (pH = 7.0). The electrocatalytic oxidation peak currents increase linearly with N-AC concentrations over the concentration ranges of 0.05-600μM using square wave voltammetric methods. The detection limit for N-AC was equal to 0.009μM. The catalytic reaction rate constant, k_h, was calculated (7.01 × 10² M^-1 s^-1) using the chronoamperometry method. Finally, Ni(II)/ZrO₂/NPs/CPE was also examined as an ultrasensitive electrochemical sensor for the determination of N-AC in real samples such as tablet and urine.

New voltammetric strategy for simultaneous determination of N-acetylcysteine and folic acid using a carbon nanotube modified glassy carbon electrode

A novel 1-benzyl-4-ferrocenyl-1H-[1,2,3]-triazole (BFT)/carbon nanotube modified glassy carbon electrode (BFT-CNT-GCE) was prepared for the simultaneous determination of N-acetylcysteine (NAC) and folic acid (FA). Cyclic voltammetry (CV), chronoamperometry (CHA), and square wave voltammetry (SWV) methods were used to investigate the modified electrode for the electrocatalytic oxidation of NAC and FA in aqueous solutions. The separation of the oxidation peak potentials for NAC-FA was about 280 mV. The calibration curve obtained for NAC was in the range of 0.1-600.0 μM. The detection limit (S/N=3) was 62.0±2.0 nM for NAC. The diffusion coefficient and the catalytic rate constant for the oxidation of NAC at the modified electrode were calculated as (3.5±0.2)×10(-5) cm(2) s(-1) and (9.85±0.4)×10(-4) M(-1) s(-1), respectively. The method was employed for the determination of NAC and FA in some real samples.

Flow-injection spectrophotometric determination of captopril in pharmaceutical formulations using a new solid-phase reactor containing AgSCN immobilized in a polyurethane resin

A simple flow-injection analysis procedure was developed for determining captopril in pharmaceutical formulations employing a novel solid-phase reactor containing silver thiocyanate immobilized in a castor oil derivative polyurethane resin. The method was based on silver mercaptide formation between the captopril and Ag(I) in the solid-phase reactor. During such a reaction, the SCN- anion was released and reacted with Fe3+, which generated the FeSCN2+ complex that was continuously monitored at 480 nm. The analytical curve was linear in the captopril concentration range from 3.0 × 10-4 mol L-1 to 1.1 × 10-3 mol L-1 with a detection limit of 8.0 × 10-5 mol L-1. Recoveries between 97.5% and 103% and a relative standard deviation of 2% for a solution containing 6.0 × 10-4 mol L-1 captopril (n = 12) were obtained. The sample throughput was 40 h-1 and the results obtained for captopril in pharmaceutical formulations using this procedure and those obtained using a pharmacopoeia procedure were in agreement at a 95% confidence level.

Spectrophotometric determination of N-acetyl-L-cysteine and N-(2-mercaptopropionyl)-glycine in pharmaceutical preparations

A simple spectrophotometric method for the determination of N-acetyl-L-cysteine (NAC) and N-(2-mercaptopropionyl)glycine (MPG) in pharmaceutical preparations was developed, validated, and used. The proposed equilibrium method is based on a coupled two-step redox and complexation reaction. In the first step, Fe(III) is reduced to Fe(II) by NAC or MPG. Subsequently, Fe(II) is complexed with 2,4,6-tripyridyl-s-triazine (TPTZ). Several analytical parameters of the method were optimized for NAC and MPG analysis in the concentration range from 1.0 μM to 100.0 μM. Regression analysis of the calibration data showed a good correlation coefficient (0.9999). The detection limit of the method was 0.14 μM for NAC and 0.13 μM for MPG. The method was successfully applied to quantify NAC and MPG in pharmaceutical preparations. No interferences were observed from common pharmaceutical excipients.