Conductimetric Assay of a Bacterial Lipase, Using Triacetin as a Substrate

Simple impedimetric sensor for rapid lipase activity quantification

A simple and rapid impedimetric sensor applicable for industrial lipase activity quantification was developed and characterized. It is based on the lipase catalyzed degradation by hydrolysis of a thin nanocomposite substrate sensitive layer deposited on a PCB stick electrode usable as disposable or regenerable. The sensitive layer degradation rate was evaluated by the impedance changes registration along time resulting from its thickness diminution applying a small amplitude AC voltage with a constant frequency. The AC current phase shift variations along the time caused by the impedance changes were registered as s sensor response. The sensor was characterized in terms of linear quantification range, LOD, precision and quantification time. The response time was found to be from 80 to 6 s for the linear concentration range from 0.99x10^-2 to 1.68 U.S.P. U mL^-1 with relative errors from 3.75% to 1.24% respectively and a LOD of 8x10^-3 U.S.P. U mL^-1. Finally, lipase spiked whey samples taken from milk industry were quantified and the results were validated by a titrimetric method revealing a good agreement (relative error less than 4.5%).

Methods for detection and characterization of lipases: A comprehensive review

Microbial lipases are very prominent biocatalysts because of their ability to catalyze a wide variety of reactions in aqueous and non-aqueous media. The chemo-, regio- and enantio-specific behaviour of these enzymes has caused tremendous interest among scientists and industrialists. Lipases from a large number of bacterial, fungal and a few plant and animal sources have been purified to homogeneity. This article presents a critical review of different strategies which have been employed for the detection, purification and characterization of microbial lipases.

[The characterization of microbial lipases. 1. The determination of lipase activity]

In the selection of an appropriate method for activity determination of lipases existing technical equipment, kind of enzymes, number of samples investigated (e.g. in routine analysis), and expected sensitivity range have to be taken into account. Titrimetric methods and above all copper salt methods with their high detection sensitivity are the most suitable procedures for activity determination of lipases used in laboratories and institutions without equipment for radiochemical analysis.

Lipase assay in duodenal juice using a conductimetric method

Lipase activity in duodenal juice is known to undergo important variations in pathologic states, especially in cases of chronic pancreatitis. Almost all of the current assay methods are based on the measurement of hydrolysis of olive oil or triolein, mainly by potentiometry. As we have developed a conductimetric method for enzyme activity measurements, we have applied it to lipase assay. A higher experimental conductimetric sensitivity is obtained when liberated acids have a short chain (higher limiting equivalent conductivity). We have therefore used triacetin as a substrate and compared out method with potentiometry (pH-stat) and spectrophotometry. The correlation coefficients of both methods with conductimetry were 0.94 and 0.97, respectively, indicating that the conductimetric method may be used for lipase assay in duodenal juice, using triacetin as a substrate.