Preparation of a Hybrid Cation-Exchange Monolith and Its Application for the Separation of Proteins by High Performance Liquid Chromatography

Montmorillonite-based polymethacrylate composite monoliths as stationary phase materials for food and pharmaceutical analysis in capillary liquid and gas chromatography

This work relates to the preparation of novel and promising stationary phases containing inorganic-organic composites for capillary liquid and gas chromatography. A naturally occurring montmorillonite was introduced to polymethacrylate monoliths, then used under different conditions of GC and HPLC at the same time. The performance of the columns was evaluated for the separation of alkane and alkylbenzene series in GC and capillary HPLC, respectively. While the bare monoliths failed to separate the model analytes, montmorillonite-based polymethacrylate allowed a full separation of the mixtures with R_s≥1.42. The columns were applied for the determination of myrcene and limonene isomers in the peel extracts of some fruits using GC, and for the analysis of active ingredients including aspirin, vitamin-C, caffeine, and ibuprofen extracted from common drugs using capillary HPLC. In GC, fast separation was achieved in 1.0 min with R_s of 6.53. The columns exhibited the best efficiency for myrcene with 20,900 plates/m. Using the capillary HPLC columns, the active ingredients were resolved in 10 min with R_s≥5.72. The efficiency values located between 12,800-21,700 plates/m in all cases. The developed methods were found to be linear in the range of 0.10-10.0 and 0.20-180 μg/mL for GC and HPLC, respectively. In comparison with commercial columns, the results in GC methods reveal that, despite their much shorter length, the prepared columns proved a faster separation with higher efficiency and comparable detection limits and chromatographic resolution. The prepared HPLC capillaries exposed lower run times and detection limits with comparable efficiency and resolution, and consume fewer samples and mobile phase solvents. The results demonstrate that the montmorillonite-based polymethacrylate composites are applicable as stationary phases for routine analysis and quality control of important fields such as food and pharmaceutical samples.

Naturally Occurring Montmorillonite-Based Polymer Monolith Composites as Stationary Phases for Capillary Liquid and Gas Chromatography

This work is associated with the preparation of capillary chromatographic columns containing inorganic-organic composites comprised of naturally occurring montmorillonite (MMT) clay mineral and polymethacrylate monolithic material. The prepared composites combine the best qualities of both constituents, offering desirable properties for use under the disparate conditions of both GC and HPLC at the same time. The stationary phases were investigated by scanning electron microscopy (SEM), the specific surface area, and thermogravimetric analysis (TGA) and examined in terms of various conditions utilized for GC and HPLC methods. The prepared columns demonstrated an excellent permeability and stability against common chromatographic conditions, such as the eluent type, flow rate, pressure, and temperature. The results confirmed that the addition of small amounts of MMT into the monolith induced significant improvement in the specific surface area, which contributed to the formation of more active sites and enhanced the retention of analytes. The registered column backpressures did not exceed 980 kPa and 16,500 kPa for the prepared GC and HPLC columns, respectively. The prepared columns were subjected to the separation of various interesting compounds possessing different chemistries and polarities, including alkanes, alkylbenzenes, polycyclic aromatic hydrocarbons (PAHs), alcohols, ketones, phenols, some common organic solvents, and isomeric mixtures. Under the optimal conditions, the efficiency of the columns fell between 4900–38,500 plates m−1 for GC and 3400–58,800 plates m−1 for capillary HPLC applications. In all cases, the measured chromatographic resolution was more than 1.38, with excellent an peak symmetry and low tailing factors. In comparison with the most commonly used commercial columns, the polysiloxane open tubular column for GC and silica-based C18 packed column for HPLC, the prepared GC columns demonstrated a faster separation with a higher efficiency, comparable resolution and tailing factors, and lower consumption of carrier gas. Regarding the capillary columns prepared for HPLC, the chromatographic experiments exposed a much lower run time with a comparable efficiency and resolution and drastically lower consumption of mobile phase solvents and samples. The results demonstrate that the MMT-based polymethacrylate monolith composites are applicable as novel and promising separation media for analyzing various mixtures of interest in different fields, such as petrochemical and environmental samples.

Functional Interfaces Constructed by Controlled/Living Radical Polymerization for Analytical Chemistry

The high-value applications of functional polymers in analytical science generally require well-defined interfaces, including precisely synthesized molecular architectures and compositions. Controlled/living radical polymerization (CRP) has been developed as a versatile and powerful tool for the preparation of polymers with narrow molecular weight distributions and predetermined molecular weights. Among the CRP system, atom transfer radical polymerization (ATRP) and reversible addition-fragmentation chain transfer (RAFT) are well-used to develop new materials for analytical science, such as surface-modified core-shell particles, monoliths, MIP micro- or nanospheres, fluorescent nanoparticles, and multifunctional materials. In this review, we summarize the emerging functional interfaces constructed by RAFT and ATRP for applications in analytical science. Various polymers with precisely controlled architectures including homopolymers, block copolymers, molecular imprinted copolymers, and grafted copolymers were synthesized by CRP methods for molecular separation, retention, or sensing. We expect that the CRP methods will become the most popular technique for preparing functional polymers that can be broadly applied in analytical chemistry.

Ionic liquids as buffer additives in ionic liquid-polyacrylamide gel electrophoresis separation of mixtures of low and high molecular weight proteins

Three novel ionic liquids (ILs) [C_nPBr] (n= 4, 6, 8) have been synthesized and were used as buffer additives in IL-PAGE separation of mixture of acidic proteins.