Ion-Exchange Method for Analysis of Four Arsenic Species and its Application to Tap Water Analysis

Effects of pH and competing anions on the speciation of arsenic in fixed ionic strength solutions by solid phase extraction cartridges

Anion exchange resins (AERs) separate As(V) and As(III) in solution by retaining As(V) and allowing As(III) to pass through. Anion exchange resins offer several advantages including cost, portability, and ease of use. The use of AERs for the instantaneous speciation of As minimizes the effects of preservatives on As species analysis. The aims of this study were to: (1) Examine the effects of pH and competing anions on the efficacy of solid phase extraction cartridges (SPECs) for speciation of As in a 0.01 molL(-1) NaNO(3) background electrolyte. (2) Identify optimal conditions (e.g. flow rates) for As speciation. (3) Calculate method detection limits (MDLs) from spiked background electrolyte and percent recoveries of As species from spiked extracts of mine wastes. The most effective SPEC retained As(V) through a range of environmentally relevant pH values (4-8). The mass loading capacity for As(V) was reduced in the background electrolyte (0.006 mg) compared with As(V) in deionized H(2)O (0.75 mg). Some retention (10-20%) of As(III) occurred on pre-wetted cartridges. Approximately 98% of spiked As(III) passed through dry cartridges. The recommended flow rate (0.5 mL min(-1)) was increased to 5 mL min(-1) without significant effect on As(V) retention. The presence of anions decreased the retention of As(V) with sulfate and phosphate having the greatest impact. MDLs were 0.004 mg L(-1) for both inorganic species. Spike recoveries in 0.01 M NaNO(3) mine waste extracts averaged 94% for As(III) and 107% for As(V).

Ion chromatographic separation and determination of phosphate and arsenate in water and hair

A simple and sensitive method for the sequential determination of phosphate and arsenate was developed based on initial ion chromatographic separation followed by detection as the ion-association complex formed by heteropolymolybdophosphate and arsenate with bismuth. With 200 microl sample injection and separation on a AS4A-SC column using an eluent of 3.5 mM sodium hydrogen carbonate-10.0 mM sodium hydroxide, the detection limits which are calculated as the concentration equivalent to twice the baseline noise, were found to be 0.8 microg/l and 4.2 microg/l for P and As, respectively. Spiked samples were analyzed and recoveries were found to be satisfactory in the range of 95-105% for phosphate and 90-105% for arsenate. Samples of water and hair were analyzed by the proposed method.

Determination of inorganic and organic anionic arsenic species in water by ion chromatography coupled to hydride generation-inductively coupled plasma atomic emission spectrometry

The development of an analytical methodology for the specific determination of arsenite, arsenate and the organic species monomethylarsonic acid (MMA) and dimethylarsinic acid (DMA), is described. The method is based on an ion chromatographic separation, coupled on-line to post-column generation of the gaseous hydrides by reaction with sodium tetrahydroborate in acidic medium. Detection and measurement were performed by inductively coupled plasma spectrometry operated in the atomic emission mode. Arsenic emission was monitored at 193.7 nm. Different types and sizes of anion-exchange columns, silica and polymeric, were tested using EDTA as eluent. Composition, acidity and flow-rate of the mobile phase were optimized in order to obtain the required resolution. Complete elution and resolution of the four species was achieved in about 6 min. Linear calibration curves were obtained in the 0.05-2 microg ml(-1) range for As(III), As(V) and MMA, and between 0.1 and 2.0 microg ml(-1) for DMA. The absolute limits of detection for 200-microl sample injections were in the ng range, with DMA the compound measured with less sensitivity. Results of the analyses of natural samples, such as river and ground waters spiked with the studied species, suggested that analyte recoveries might be dependent on the sample composition.