Some Aspects of the Reaction between Chitosan and Formaldehyde

Formation of Nanofibrous Structure in Biopolymer Aerogel during Supercritical CO2 Processing: The Case of Chitosan Aerogel

Supercritical drying is widely considered as the gold standard to produce aerogels that preserve the microstructure of the gels, but we have found this is not always the case. Chitosan aerogel, one of the emerging biopolymer aerogels, was prepared by chemical cross-linking gelation, followed by solvent exchange with methanol and supercritical drying using CO₂. Small-angle X-ray scattering analysis shows that the structure of the wet gel, which consists of Gaussian chains of individual molecular strands, converts into a nanofibrous network during CO₂ processing. In situ observation reveals a drastic shrinkage of the gel in CO₂, demonstrating that physical coagulation caused by the low affinity between chitosan and CO₂ is the main structure-forming step. These results challenge the common perception of supercritical drying: it is no longer an inactive drying method, but rather an active nanostructure forming a tool to produce porous biopolymer materials with tailored structure and properties.

Controlled formation of chitosan particles by a clock reaction

Clock reactions allow precise control of chemical composition in the time domain. Such nonlinear chemical systems have recently been introduced to mimic the self-assembly pathways common in living organisms. Here, we demonstrate the use of a clock reaction to trigger the formation of polymeric nanoparticles. By adjusting the delay of a formaldehyde clock reaction, we controlled the precipitation of chitosan to form particles with sizes tunable in a wide range (from about 200 to 600 nm diameter). The chemical structure of chitosan was not significantly perturbed by the clock reagents.

Chitosan-Coated Fibers for Use in Papermaking

Chitosan was precipitated onto wood pulp, glass and polypropylene fibers suitable for papermaking. The coating which formed on the fibers was characterized by photomicrography after the formation of colored derivatives, and by scanning electron microscopy. The most uniform and adherent coatings were formed on the wood pulp fibers and the least were formed on the polypropylene fibers. Paper handsheets were readily formed from the chitosan-coated wood pulp and glass fibers, but not from the chitosan-coated polypropylene fibers.