Properties and Preparation of Chitosan/Silanol Quaternary Ammonium Modified Silica Hybrids Using Sol–Gel Process

Mechanical, Structural, and Biological Properties of Chitosan/Hydroxyapatite/Silica Composites for Bone Tissue Engineering

The aim of this work was to fabricate novel bioactive composites based on chitosan and non-organic silica, reinforced with calcium β-glycerophosphate (Ca-GP), sodium β-glycerophosphate pentahydrate (Na-GP), and hydroxyapatite powder (HAp) in a range of concentrations using the sol–gel method. The effect of HAp, Na-GP, and Ca-GP contents on the mechanical properties, i.e., Young’s modulus, compressive strength, and yield strain, of hybrid composites was analyzed. The microstructure of the materials obtained was visualized by SEM. Moreover, the molecular interactions according to FTIR analysis and biocompatibility of composites obtained were examined. The CS/Si/HAp/Ca-GP developed from all composites analyzed was characterized by the well-developed surface of pores of two sizes: large ones of 100 μm and many smaller pores below 10 µm, the behavior of which positively influenced cell proliferation and growth, as well as compressive strength in a range of 0.3 to 10 MPa, Young’s modulus from 5.2 to 100 MPa, and volumetric shrinkage below 60%. This proved to be a promising composite for applications in tissue engineering, e.g., filling small bone defects.

Optimizing the design and synthesis of supported silver nanoparticles for low cost water disinfection

Silver nanoparticles (AgNPs) were successfully synthesized and impregnated on silica using chemical reduction methods. XPS and Ag K-edge XANES analysis revealed that the impregnation of AgNPs onto silica using a chitosan + sodium borohydride (NaBH4) method results in higher silver loading and Ag(0)/Ag(I) ratio compared to that obtained using NH3 + NaBH4/glucose methods. The effects of the dosage of chitosan on silver loading, Ag(I) release, and bactericidal activities of AgNP-impregnated silica were investigated, with results showing that, at high dosages of chitosan, Ag(I) released from AgNP-impregnated silica plays an important role in disinfection, while AgNP-mediated bactericidal action dominates at low dosages of chitosan. To further decrease the manufacturing cost, partially oxidized "black rice husk ash" containing substantial residual carbon was applied as AgNP support and found to lead to a greater degree of silver impregnation and to exhibit a longer disinfection lifetime than that of lower carbon content silica supports. On the basis of these findings, it is clear that considerable scope exists for careful optimization in the design and production of AgNP-based bactericidal materials for water treatment purposes.