Wealth from poultry waste: an overview

Simultaneous analysis of antimicrobial residues and contaminants in poultry droppings by HPLC-MS/MS: a tool for environmental and food safety monitoring

Animal waste is a potential pollution hazard as it can harbour contaminants, such as antimicrobial residues, mycotoxins, and pesticides, becoming a risk to the public, animal, and environmental health. To assess this risk, 15 experimental broiler chickens orally received contaminants to evaluate excretion levels. An analytical method was previously developed to detect 18 substances in poultry droppings using high-performance liquid chromatography coupled to a tandem mass spectrometer (HPLC-MS/MS). Contaminants including tetracycline, 4-epi-tetracycline, oxytetracycline, 4-epi-oxytetracycline, chlortetracycline, 4-epi-chlortetracycline, tylosin, erythromycin, enrofloxacin, ciprofloxacin, flumequine, florfenicol, sulfachloropyridazine, sulfadiazine, 2,4-dichlorophenoxyacetic acid, zearalenone, alpha- and beta-zearalenol, were extracted with EDTA-McIlvain and acetonitrile. This method showed a p-value < 0.05, RSD < 25%, and R2 > 0.95 in the calibration curves linearity for all analytes. The limit of quantification, selectivity, decision limit for confirmation, matrix effect, precision, and recovery parameters were validated according to European Union document 2021/808/EC, technical report CEN/TR 16059, SANTE/11813/2017 and according to the Veterinary International Conference on Harmonization: VICH GL2 and GL49. This method confirmed the detection of most analytes 12-36 h post-administration and simultaneously detected and quantified mixed contaminants. Thereby, poultry droppings are a potential matrix for spreading contaminants in animal production before slaughter and their control will minimize environmental impacts and mitigate antimicrobial resistance.

Oxidation of chlortetracycline and its isomers by Botrytis aclada laccase in the absence of mediators: pH dependence and identification of transformation products by LC-MS

Tetracyclines are antibiotics considered emerging pollutants and currently, wastewater treatment plants are not able to remove them efficiently. Laccases are promising enzymes for bioremediation because they can oxidize a wide variety of substrates. The aim of this study was to evaluate the Botrytis aclada laccase for the oxidation of chlortetracycline and its isomers in the absence of a mediator molecule, at a pH range between 3.0 to 7.0, and to characterize the transformation products by LC-MS. Chlortetracycline and three isomers were detected in both, controls and reaction mixtures at 0 h and in controls after 48 h of incubation but in different proportions depending on pH. An additional isomer was also detected, but only in the presence of BaLac. Based on the transformation products identified in the enzymatic reactions and information from literature, we assembled a network of transformation pathways starting from chlortetracycline and its isomers. The spectrometric analysis of the products indicated the probable occurrence of oxygen insertion, dehydrogenation, demethylation and deamination reactions. Four new products were identified, and we also described a novel transformation product without the chloro group. We observed that increasing pH led to higher diversity of main products. This is the first study using the laccase from fungi Botrytis aclada to oxidate chlortetracycline and its isomers and it can be considered as an ecological alternative to be used in bioremediation processes such as wastewater.

Fuel properties and incineration behavior of poultry litter blended with sweet sorghum bagasse and pyrolysis oil

The incineration of poultry litter (PL) effectively reduces the volume of waste in line with the United Nations Sustainable Development Goal of "affordable and clean energy". However, mono-incineration is associated with considerable challenges due to the varying moisture, structural and chemical composition and low energy yield. The aim of the present work was to investigate the influence of sweet sorghum bagasse (SS) and pyrolysis oil (PO) on improving the fuel properties of PL and mitigating ash related burdens during incineration. The different biomass feedstocks were produced by combining PL with SS at 0.0% (T0), 25% (T1), 50% (T2), 75% (T3) and compared with 100% SS (T4). In order to achieve high energy potential and low ash deposition, the parallel samples were additionally mixed with 10% PO to improve the energy value. The experimental results show that increasing the proportion of SS and adding PO to the mixtures increases the volatile matter and decreases the moisture and ash content. The addition of PO also increases the carbon and hydrogen content. The use of SS and PO thus increased the values of the ignitability index and apparently also the flammability by 30.0%-49.4% compared to pure PL. SS and PO shifted the HHV of the starting material from 16.90 to 18.78 MJ kg-1. In addition, SS + PO improved the flame volume and red color intensity of the PL blends based on the image analysis method. However, the presence of SS and PO did not sufficiently improve the ash-related index values, which requires further investigation.

Artificial Humic Substances as Biomimetics of Natural Analogues: Production, Characteristics and Preferences Regarding Their Use

Various processes designed for the humification (HF) of animal husbandry wastes, primarily bird droppings, reduce their volumes, solve environmental problems, and make it possible to obtain products with artificially formed humic substances (HSs) as analogues of natural HSs, usually extracted from fossil sources (coal and peat). This review studies the main characteristics of various biological and physicochemical methods of the HF of animal wastes (composting, anaerobic digestion, pyrolysis, hydrothermal carbonation, acid or alkaline hydrolysis, and subcritical water extraction). A comparative analysis of the HF rates and HS yields in these processes, the characteristics of the resulting artificial HSs (humification index, polymerization index, degree of aromaticity, etc.) was carried out. The main factors (additives, process conditions, waste pretreatment, etc.) that can increase the efficiency of HF and affect the properties of HSs are highlighted. Based on the results of chemical composition analysis, the main trends and preferences with regard to the use of HF products as complex biomimetics are discussed.