Aqueous-Based Cellulose Acetate Butyrate Dispersion: Screening of Process and Formulation Variables to Obtain Verapamil HCl-Controlled Release Beads

Effect of Eudragit RS 30D and talc powder on verapamil hydrochloride release from beads coated with drug layered matrices

The aim of this study was to investigate the effect of Eudragit RS 30D, talc, and verapamil hydrochloride on dissolution and mechanical properties of beads coated with "drug-layered matrices". This was accomplished with the aid of a three-factor multiple-level factorial design using percent drug release in 1 and 2 h, T(50), tensile strength, brittleness, stiffness and toughness as the responses. Beads were coated in a fluidized-bed coating unit. Surface morphology and mechanical properties were evaluated by surface profilometry and texture analysis, respectively. No cracks, flaws and fissures were observed on the surfaces. The mechanical properties were dependent on the talc/polymer ratio. The release of verapamil from the beads was influenced by matrix components. Increasing the level of both talc and Eudragit decreased the percent drug released from 67% to 4.8% and from 80.7% to 6.7% in 1 and 2 h, respectively, and increased T(50) from 0.8 to 25.7 h. It was concluded that beads could be efficiently coated with "drug-layered matrices". The release of drug, however, depends on a balance between the levels of drug, talc, and polymer, whereby desired dissolution and mechanical properties could be controlled by the talc/polymer ratio and the level of drug loading.

Preparation and characterization of a customized cellulose acetate butyrate dispersion for controlled drug delivery

The purpose of the present experiment was to prepare and characterize the aqueous-based pseudolatex system of cellulose acetate butyrate (CAB) for controlled drug delivery. Aqueous pseudolatex systems are advantageous over organic-based coating systems because these systems are devoid of criteria pollutants such as carbon monoxide, nitrogen oxides, nonmethane volatile organic compounds, and sulfur dioxide. Pseudolatex was prepared with CAB and polyvinyl alcohol (stabilizer) by a polymer emulsification technique. The stability of pseudolatex was evaluated. Particle size was measured and rheological experiments were conducted. The glass transition temperature, microscopic free volume, permeation coefficient, and mechanical properties of plasticized pseudolatex films were estimated. Surface roughness of coating on inert Nu-Pareil beads (Ingredient Technology Corp., Mahwah, NJ) was measured as a function of coating weight gain. The CAB Pseudolatex was found to be stabilized by steric forces. From intrinsic viscosity, the thickness of the stabilization layer was estimated. An increase in polymeric particles proportionately decreased the thickness of the stabilization layer. All the essential properties of a coating membrane such as microscopic free-volume fraction, permeability coefficient, mechanical properties, and glass transition temperature were fairly controllable as a function of plasticizer concentration. The pseudolatex dispersion of CAB was stable with negligible sedimentation volume and a particle size of 300 nm. Because CAB is water insoluble and non-ionizable, this pseudolatex can be used for pH-independent coating. The films obtained were strong and flexible for controlled drug delivery applications. Coating with the CAB dispersion reduced the surface roughness of beads but it remained stable as a function of increase in coating weight gain.