Morphology Controlled Magnesium Ethoxide: Influence of Reaction Parameters and Magnesium Characteristics

Porous Organic Polymers-Supported Zeigler-Natta Catalysts for Preparing Highly Isotactic Polypropylene with Broad Molecular Weight Distribution

Porous organic polymers (POPs) have attracted much attention in numerous areas, including catalysis, adsorption and separation. Herein, POP supported Ziegler-Natta catalysts were designed for preparation of isotactic polypropylene (iPP). The POPs-based Ziegler-Natta catalysts exhibited the characteristic of broad molecular weight distribution (MWD > 11) with or without adding an extra internal electron donor. The added internal electron donor 3-methyl-5-tert-butyl-1,2-phenylene dibenzoate (ID-2) used in cat-2 showed good propylene polymerization activity of 15.3 × 10⁶ g·PP/mol·Ti·h, high stereoregularity with 98.2% of isotacticity index and broad molecular weight distribution (MWD) of 12.3. Compared to the MgCl₂-supported Ziegler-Natta catalysts (cat-4) with the same ID-2, cat-2 showed higher chain stereoregularity for propylene polymerization. As seen in the TREF results, the elution peak of PP-2 (124.0 °C, 91.7%) is 1.5 °C higher than the isotactic fraction from PP-4 (122.5 °C, 87.2%), and even 1.2 °C higher than PP-5 prepared from ID-3 with the characteristics of high stereoregularity. Moreover, the pentad methyl sequence mmmm of PP-2 (93.0%) from cat-2 is 0.5% higher than that of PP-4 from cat-4. XPS analysis revealed that the minute difference in binding energy of Ti, Mg, C and O atoms exist between the inorganic MgCl₂ and the organic polymer based Z-N catalysts. The plausible interaction mechanism of active sites of Mg and Ti with the functional groups in the POP support and the added ID was proposed, which could be explained by their high stereoregularity and the broad molecular weight distribution of the POP-based Z-N catalysts.

Application of a magnesium/co-solvent system for the degradation of polycyclic aromatic hydrocarbons and their oxygenated derivatives in a spiked soil

This study evaluates the capability, efficacy and practicality of a combined approach based on solvent extraction and chemical reduction to simultaneously degrade polycyclic aromatic hydrocarbons (PAHs) and their oxygenated derivatives (OPAHs) in spiked soil. The spiked soil was washed using a composite organic solvent consisting of ethanol and ethyl lactate (1:1, v/v) and then degradation of the extracted contaminants using zero-valent magnesium. The extraction conditions were optimized at 25 °C with solvent-soil ratio of 2:1 (v/w) and the ensuing degradation efficiency ranged from 79% to 88% for the OPAHs, and 66% to 87% for the PAHs after 24 h of reaction at pH of 6.1. The reductive degradation of the spiked contaminants followed pseudo-first-order kinetics; however, comparing the kinetic results of this study to soil-free studies, the degradation rates are significantly reduced. It can be inferred that extracted organic or inorganic components from the soil medium hinder the degradation process, possibly by reducing the reactivity of the activated metal. Furthermore, to our understanding, this study is the first report on the simultaneous degradation of these priority pollutants and their oxygenated derivatives. The experimental results encourage the application of this magnesium/co-solvent system for future pilot-scale remediation studies.

Reductive degradation of oxygenated polycyclic aromatic hydrocarbons using an activated magnesium/co-solvent system

This study evaluates the capability of zero-valent magnesium and a protic co-solvent to promote the degradation of oxygenated polycyclic aromatic hydrocarbons compounds, specifically 9-fluorenone, 9,10-anthraquinone, 7,12-benz(a)anthraquionone, and 7H-benz(de)anthracene-7-one. At room temperature conditions, greater than 86% degradation efficiency is observed after 24h of reaction time for a mixture containing 0.05 g of magnesium and four selected oxygenated aromatic hydrocarbons with 250 mg L(-1) concentrations. It is noted that glacial acetic acid is needed as an activator for the degradation reaction to proceed. It is also presumed that the acid removes oxide and hydroxide species from the magnesium surface. With the GC-MS analysis of the reaction products, possible reductive pathways are suggested. Furthermore, this study is the first report on the degradation of these emerging contaminants and it is proposed that the magnesium-powder/protic-solvent system is a promising low-cost reagent and may allow for the future development of an economic and environmentally-friendly remediation application.

Multivariate evaluation and optimization of an activated-magnesium/co-solvent system for the reductive degradation of polycyclic aromatic hydrocarbons

The present study evaluates the capability of an activated-magnesium metal and protic co-solvents to promote the reductive degradation of three different polycyclic aromatic hydrocarbons, specifically pyrene, benzo[k]fluoranthene and benzo[g,h,i]perylene. Multivariate analyses demonstrated that the kinetics of degradation was affected by several experimental factors such as magnesium loading, acid addition and solubility of the compounds. It was determined that an acid activator is needed for the degradation reaction to proceed and it is also noted that the use of a 1:1 ethanol/ethyl lactate co-solvent is ideal for the complete dissolution of all three compounds with concentrations varying from 200 to 275mgL(-1). The experimental results also indicate that, at room temperature conditions, only 0.05-0.1g of magnesium is required in order to achieve greater than 93% degradation efficiency after 24h of reaction. This methodology is attractive and may allow for the development of an economic and environmentally friendly field application for the remediation of other polycyclic aromatic hydrocarbons.

Reduction of benzo[a]pyrene with acid-activated magnesium metal in ethanol: a possible application for environmental remediation

Persistent organic pollutants (POPs) are a well-known threat to the environment. Substances such as polycyclic aromatic hydrocarbons (PAHs) in contaminated soils and sediments can have severe and long-term effects on human and environmental health. There is an urgent need for the development of safe technologies for their effective degradation. Here we present a new technique using ball-milled magnesium powder and ethanol solvent as a convenient electron transfer/proton source for the partial reduction of PAHs under ambient conditions. The rates of degradation were determined while evaluating the influences of acetic acid and type of ball-milled magnesium added to the reaction mixture. The results of these triplicate studies indicate that with the use of acetic acid as an activator and ball-milled magnesium carbon (Mg/C), this reducing system (Mg-EtOH) is able to achieve a 94% conversion of 250 μg/mL of toxic benzo[a]pyrene into a mixture of less toxic and partially hydrogenated polycyclic compounds within 24h. This methodology can be used as a combined process involving ethanol washing followed by reduction reaction and it can also be considered as an easy handling and efficient alternative process to the catalytic hydrogenation of PAHs.