Are occlusal contact area asymmetry and masticatory muscle activity asymmetry related in adults with normal dentition?

Reference values and reliability of occlusal force distribution and occlusal time measured by the T-Scan system in adults with healthy dentition

PURPOSE

Reference values of occlusal characteristics are needed to interpret the data obtained using the T-Scan System. This study aimed to establish reference values for and to assess the reliability of, occlusal force distribution in the maximal intercuspal position and the occlusion time in young adults with healthy dentition.

MATERIALS AND METHODS

In total 178 adults with natural dentition participated in this retrospective cross-sectional study, of whom 76 performed a retest session. Several occlusal recordings were obtained from each participant using the T-Scan system while asking them to bite two or three consecutive times (multi-bite) or only once (single-bite) at the maximal intercuspal position. The lateral and anteroposterior occlusal force distribution were determined as percentages in the right and posterior teeth . Occlusion time was measured in seconds. After the occlusal force distribution and occlusion time percentiles were calculated, reliability was assessed by the intraclass correlation coefficient.

RESULTS

The 5th-95th percentiles for occlusal force distribution were 34%-67% on the right teeth and 55%-94% on the posterior teeth. The 90th percentile for multi-bite occlusion time was 0.17 s and for single-bite occlusion time was 0.27 s. The intraclass correlation coefficients for lateral occlusal force distribution, anteroposterior occlusal force distribution, multi-bite occlusion time, and single-bite occlusion time were 0.70, 0.68, 0.58, and 0.67, respectively.

CONCLUSIONS

This study generated reference values for key occlusal characteristics (occlusal force distribution and occlusion time) when using the T-Scan system. These values showed moderate reliability.

The Effect of Asymmetrical Occlusion on Surface Electromyographic Activity in Subjects with a Chewing Side Preference: A Preliminary Study

The relationship between asymmetrical occlusion and surface electromyographic activity (sEMG) in people with different chewing preferences is not clear. In this study, the 5 s sEMG changes in the masseter muscle (MM), sternocleidomastoid (SCM), lateral (LGA), and medial (MGA) gastrocnemius muscles were recorded in controls, and subjects with chewing side preference (CSP) during clench with bilateral (BCR), left (LCR), and right (RCR) posterior teeth placement of cotton rolls. The images of the middle 3 s were selected and expressed as the root mean square (unit: μV/s). The EMG waves of bilateral muscles were compared by computing the percentage overlapping coefficient (POC). Only the POCMM of the CSP showed gender differences at BCR and RCR. Between the control group and the CSP group, there were significant differences in the POCMM and the POCLGA at BCR. In addition, there was a significant difference in POCMM and POCSCM between the two populations in different occlusal positions. The change in the POCSCM correlated with the change in the POCMM (r = 0.415, p = 0.018). The experiment-induced asymmetrical occlusion showed that the altered symmetry of the MM correlated with the altered symmetry of the SCM. Long-term asymmetrical occlusion (i.e., CSP) not only affects MM but also has potential effects on other superficial muscles (e.g., LGA).

Effects of anterior bite planes fabricated from acrylic resin and thermoplastic material on masticatory muscle responses and maximum bite force in children with a deep bite: a 6-month randomized controlled trial

BACKGROUND

Anterior bite planes are bite-raising appliances used for deep bite correction. However, muscle responses to anterior bite planes of different hardnesses may vary.

OBJECTIVES

To prospectively evaluate masticatory muscle activity, muscle balance, and maximum bite force (MBF) responses to anterior bite planes fabricated from acrylic resin (ABP) or bi-laminate thermoplastic (TBP) over 6 months in children with a deep bite.

METHODS

Sixty-six children were randomly assigned to the ABP, TBP, or untreated control groups. Masticatory muscle activity, activity index (AC), and percentage overlapping coefficient (POC) were assessed by surface electromyography; MBF, using a custom-made bite force sensor. Data were collected before, immediately after appliance insertion, and after 2 weeks and 1, 3, and 6 months of treatment. Within- and between-group differences were analyzed using one-way ANOVA/Kruskal-Wallis and Mann Whitney U-tests (α=0.05); Friedman's tests were used to assess within-group differences over time (α=0.08).

RESULTS

At rest, no dependent variables changed throughout the study. At maximum clenching, masticatory muscle activity immediately dropped significantly but returned to baseline values and was equal to the control group at 1-3 months. The ABP group had significantly lower masseter activity and AC than the TBP group after insertion. Neither POC nor MBF were significantly different within or between groups.

CONCLUSION

Masticatory muscle activity reduced after anterior bite plane insertion but returned to baseline after 1-3 months. Masseter activity decreased significantly more in the ABP group than TBP group. Neither appliance significantly affected POC or MBF.

Novel Functional Indices of Masticatory Muscle Activity

The aim of the present study was to analyze novel functional indices of masticatory muscle activity and compare them to existing and commonly used indices in patients with temporomandibular disorders (TMDs) and healthy adults. Based on the Research Diagnostic Criteria for Temporomandibular Disorders, 78 adult women qualified for the study. Subjects were divided into two groups: diagnosed TMDs (n = 36; mean age: 23.4 ± 2.6 years) and healthy adults (n = 42; mean age: 22.4 ± 2.3 years). Measurements of the bioelectric activity of the temporalis anterior (TA), superficial masseter (MM), and anterior bellies of the digastric muscle (DA) were carried out using the BioEMG III ™. Functional Clenching (FCI) and Functional Opening (FOI) indices were obtained as the ratio of the difference between the mean muscle root mean square (RMS) potentials during functional activity, including clenching (CL) and opening (MMO), and mean muscle resting (REST) potentials. Next, based on FCI and FOI indices, the Functional Clenching Activity Index (FCAI), Functional Clenching Symmetry Index (FCSI), and Functional Opening Symmetry Index (FOSI) were obtained. The statistical analysis showed significant differences in activity index left-sided (AcI_L) and Activity index both-sided (AcI_tot) between TMDs and healthy women during rest measurements. The significant differences between both groups were noted in terms of all Functional Clenching Indices except Functional Clenching Index for MM right-sided (FCI_MM-R). In all analyzed FCI indices, the control group showed higher values compared to the TMDs. Moreover, a significant difference between TMDs and controls was observed within Functional Clenching Activity Index left-sided (FCAI_L) (14.56 vs. −0.45, p = 0.01). Both functional indices, and asymmetry (AsI) and activity (AcI) indices seem to be reliable in assessing symmetry and activity within masticatory muscles. Further studies should be performed to verify the effectiveness and suitability of the assessment of masticatory muscles using functional indices.

Masticatory performance is influenced by masticatory muscle activity balance and the cumulative occlusal contact area

OBJECTIVE

To investigate the influence of masticatory muscle activity balance, occlusal contact area balance and the area of occlusal contact on masticatory performance in healthy dentate adults.

DESIGN

This cross-sectional study included ninety-three healthy subjects with complete dentition. Surface electromyography (sEMG) was used to record bilateral anterior temporalis activity and masseter muscle activity during maximum voluntary clenching and while chewing a test food. Seven levels of area of occlusal contact and near contact (ACNC) were registered and calculated cumulatively. The percentage overlapping coefficients were calculated for both muscle groups at maximum voluntary clenching and chewing and all levels of ACNC. Masticatory performance was measured by determining the median particle size of frankfurter sausage after 15 chewing cycles. Pearson's correlation and stepwise multiple linear regression analyses were used to assess the correlations between variables and the influence of the variables on masticatory performance, respectively, at the 0.05 level of significance.

RESULTS

Muscle balance during clenching and chewing, all near contact levels of cumulative ACNC and ACNC balance correlated negatively with median particle size (P <  0.05). The model based on stepwise multiple linear regression analysis showed muscle balance during clenching and cumulative ACNC at < 250 μm influenced median particle size.

CONCLUSION

Masticatory muscle activity balance during maximum voluntary clenching and the cumulative amount of near contact area were associated with masticatory performance, suggesting the amount of occlusal contact area-as well the balance of masticatory muscle activity-play a role in masticatory performance.