Optimization on conditions of podophyllotoxin-loaded liposomes using response surface methodology and its activity on PC3 cells

Paeoniflorin loaded liposomes modified with glycyrrhetinic acid for liver-targeting: preparation, characterization, and pharmacokinetic study

OBJECTIVE

To enhance the retention times and therapeutic efficacy of paeoniflorin (PF), a liver-targeted drug delivery system has been developed using glycyrrhetinic acid (GA) as a ligand.

SIGNIFICANCE

The development and optimization of GA-modified PF liposomes (GPLs) have shown promising potential for targeted delivery to the liver, opening up new possibilities for liver disease treatment.

METHODS

This study aimed to identify the best prescriptions using single-factor experiments and response surface methodology. The formulation morphology was determined using transmission electron microscopy. Tissue distribution was observed through in vivo imaging, and pharmacokinetic studies were conducted.

RESULTS

The results indicated that GPLs, prepared using the thin film dispersion method and response surface optimization, exhibited well-dispersed and uniformly sized particles. The in vitro release rate of GPLs was slower compared to PF monomers, suggesting a sustained release effect. The liver-targeting ability of GA resulted in stronger fluorescence signals in the liver for targeted liposomes compared to non-targeted liposomes. Furthermore, pharmacokinetic studies demonstrated that GPLs significantly prolonged the residence time of PF in the bloodstream, thereby contributing to prolonged efficacy.

CONCLUSION

These findings suggest that GPLs are more effective than PF monomers in terms of controlling drug release and delivering drugs to specific targets, highlighting the potential of PF as a liver-protective drug.

Carboxymethyl chitosan and octadecylamine-coated liposome-containing WPTS: design, optimization, and evaluation

Liposomes (LPs) are a delivery system for stabilizing pharmaceuticals with limited use due to their propensity to congregate and fuse. A proposed method of addressing these problems is polymer coating. In this study, the potential of octadecylamine (ODA)-coated liposomes and carboxymethyl chitosan (CMCS/ODA-LPs) for enhancing Wacao pentacyclic triterpene saponin (WPTS) transport capacity was investigated. CMCS/ODA-LPs were produced by electrostatic adsorption and thin-film hydration. Response surface methodology (RSM) was employed to enhance the process and encapsulation efficiency (EE) for optimum drug encapsulation efficiency. The synthesized WPTS-CMCS/ODA-LPs were uniformly dispersed in a circular shape, and during 14 days of storage at 4 °C, the particle size and morphology did not significantly change. Vesicle size, zeta potential, polydispersity index (PDI), and entrapment efficiency (%) were 179.1 ± 7.31 nm, -29.6 ± 1.35 mV, 0.188 ± 0.052, and 75.62 ± 0.43, respectively. The hemolysis test revealed that WPTS-CMCS/ODA-LPs were sufficiently biocompatible. Compared to WPTS-LPs, WPTS-CMCS/ODA-LPs consistently showed a much more significant cytotoxic effect on cancer cells. Early and WPTS-CMCS/ODA-LPs-induced apoptosis resulted in almost seven times more cell death than the control. Compared to physiological pH 7.3, the pH-sensitive CMCS coupled LPs increased drug release at acidic pH 6.5. These findings suggest the efficacy of pH-sensitive CMCS/ODA-LPs as a medication delivery method for WPTS.

Evaluation of physico-chemical properties of tomato powder produced by an optimized freeze drying process

In this study, the physico-chemical properties of tomato powder produced by an optimized freeze drying process (FDP) were evaluated. With the lycopene content as the dependent variable, the optimum FDP conditions (i.e., thermal cracking time of 62 s, ascorbic acid addition amount [0.13%], and particle size [Dv90] of 163 μm) were obtained through response surface methodology (RSM). The results showed that the content of lycopene in the prepared tomato powder was higher than that in two commercial products. Aldehydes were the main components among 25 kinds of aromatic substances detected in tomato powder. The values of a * and a */b *, the hydration properties including water holding capacity (WHC) and oil binding capacity (OBC), and the content of total acid, ascorbic acid, and soluble solids were improved compared to commercial spray dried and freeze dried samples. All the above results suggested that FDP was an adequate procedure for the production of high-quality tomato powder.

Synthetic dimeric-drug phospholipid: a versatile liposomal platform for cancer therapy

An amphiphilic dimeric-podophyllotoxin (PODO) phospholipid was synthesized to assemble into liposomes as a combination of prodrug and nanocarrier. The results have demonstrated that the cell membrane-like delivery system possessed an improved cellular uptake and favorable antitumor efficacy with reduced side-effects. This strategy provides a new effective platform in drug delivery for cancer chemotherapy.

Delivery of phytochemicals by liposome cargos: recent progress, challenges and opportunities

Bio-availability is a major concern in delivery of dietary phytochemicals for better bio-efficacy. The reduced bio-availability of food bioactive compounds is evident due to degradation during human digestion process which involves liberation, absorption, distribution, metabolism and elimination. The bio-efficacy of any nutrient can be increased by increasing bio-availability. Different technologies are available for engineered efficient delivery systems; still many challenges remain with advancement of delivery systems. The ease of preparedness and adaptability of liposomes has resulted in wide-range of applicability and acceptability in scientific field, especially as delivery vehicles. In view, of properties like biocompatibility and biodegradability, liposomes have been modified with different usable methodologies for delivery of phytochemicals. The aim of this review is to abridge liposomes, methods of preparation, their application as delivery cargo in dietary phytochemicals, result of using different preparation techniques on properties.