Effective preparation of magnetic molecularly imprinted polymer nanoparticle for the rapid and selective extraction of cyfluthrin from honeysuckle

Simultaneous determination of pesticides, mycotoxins and ferulic acid in Angelica sinensis by GC/LC-Q-TOF/MS

In this study, a strong applicable method that could determine a total of 33 pesticides (54 compounds), 11 mycotoxins and functional components (ferulic acid) simultaneously in Angelica sinensis was developed. The compatibility of the sample pretreatment method for pesticides, mycotoxins, and functional components was improved by optimizing the acidity of extraction solvents, the sequence of ice bath and oscillation, the volumetric solution, and so on. The PRiME HLB SPE pretreatment method was chosen as the optimal one when comparing four pretreatment methods. Among the 65 contaminants, 38 of those determined by liquid chromatography and 41 of those by gas chromatography, which showed good linearity (R2 > 0.9801), 97 % of them had a limit of quantitation (LOQ) of lower than 0.02 mg kg-1. The recovery of all compounds were suited between 70 % to 120 % and the RSD were all lower than 20 % at the spiked levels of LOQ, 2 × LOQ, and 10 × LOQ. For ferulic acid, the LOQ was 50 ng/mL, and it showed good linearity (R2=0.9988) within the range of 0.5 to 10 μg/mL. The recovery and RSD were 98.1 %, and 3.2 % (n = 6), respectively. The simultaneous determination of cross-category compounds in a single sample preparation was obtained by the combination of SPE and GC/LC-Q-TOF/MS. Therefore, this study could not only shorten the time for data acquisition and data analysis, but also improve the experimental efficiency.

Characterization and optimization of magnetic molecularly imprinted nanofibers for determination of sunitinib in human serum and capsule samples

This article reports a spectrofluorometric method for the determination of sunitinib (STB) drug based on molecularly imprinted nanofibers fabricated by the electrospinning method and modified by magnetic nanoparticles as sorbent. The characterization of magnetic molecularly imprinted nanofibers (MMINs) was carried out using X-ray diffraction (XRD), scanning electron microscope (SEM), and transmission electron microscopy (TEM), which confirmed the successful synthesis of MMINs with well-distributed magnetite nanoparticles. Drug adsorption and desorption were optimized and important parameters such as sample pH, nanofiber mass, adsorption and desorption time, eluent solvent and sample volume were analyzed. The results demonstrated that the MMINs act as a selective sorbent for STB and can be readily collected through an external magnetic field. Methanol was used as the best eluent solvent for STB desorption from MNIN. A linear correlation was observed between the STB concentrations and fluorescence intensities in the range of 0.01-15.0 mg L-1. The detection limit for this method was 0.002 mg L-1. The relative standard deviation (RSD) of 2.6 % for 1.0 mg L-1 and 1.1 % for 10 mg L-1 of STB (n = 3) were obtained, which indicates that the developed method is precise in determining STB. Human serum and capsule analysis show the applicability of the proposed sensor for real samples.

Off-line magnetic Fe3O4@SiO2@MIPs-based solid phase dispersion extraction coupling with HPLC for the simultaneous determination of olaquindox and its metabolite in fish muscle and milk samples

An innovative core-shell magnetic molecularly imprinted polymers, Fe₃O₄@SiO₂@MIPs, was elaborately tailored for specific separation and enrichment of olaquindox (OLA) and its metabolic marker methyl-3-quinoxaline-2carboxylic acid (MQCA). Herein, benefiting from the combination of functionalized magnetic nanoparticles (Fe₃O₄@SiO₂) and MIPs, Fe₃O₄@SiO₂@MIPs not only possessed favorable magnetic properties and stability, avoiding tedious sample pretreatment process, but also demonstrated exceptional selective recognition ability and adsorption capacity, suppressing influence of coexisting interfering substances. Encouraged by prominent merits, Fe₃O₄@SiO₂@MIPs-based magnetic solid phase extraction with HPLC method was developed, realizing simultaneous measurement of OLA and MQCA. Under optimal conditions, excellent linear ranges of 0-100 μg/L with detection limit of 0.175-0.271 μg/L were obtained. The proposed method was finally utilized for determination of OLA and MQCA in fish muscle and milk samples with satisfactory recoveries (80.56-95.26%) and relative standard deviation below 8.1%, furnishing a reliable and sensitive strategy for enrichment and detection residual veterinary drugs in food samples.

Applications of Molecular Imprinting Technology in the Study of Traditional Chinese Medicine

Traditional Chinese medicine (TCM) is one of the most internationally competitive industries. In the context of TCM modernization and internationalization, TCM-related research studies have entered a fast track of development. At the same time, research of TCM is also faced with challenges, such as matrix complexity, component diversity and low level of active components. As an interdisciplinary technology, molecular imprinting technology (MIT) has gained popularity in TCM study, owing to the produced molecularly imprinted polymers (MIPs) possessing the unique features of structure predictability, recognition specificity and application universality, as well as physical robustness, thermal stability, low cost and easy preparation. Herein, we comprehensively review the recent advances of MIT for TCM studies since 2017, focusing on two main aspects including extraction/separation and purification and detection of active components, and identification analysis of hazardous components. The fundamentals of MIT are briefly outlined and emerging preparation techniques for MIPs applied in TCM are highlighted, such as surface imprinting, nanoimprinting and multitemplate and multifunctional monomer imprinting. Then, applications of MIPs in common active components research including flavonoids, alkaloids, terpenoids, glycosides and polyphenols, etc. are respectively summarized, followed by screening and enantioseparation. Related identification detection of hazardous components from TCM itself, illegal addition, or pollution residues (e.g., heavy metals, pesticides) are discussed. Moreover, the applications of MIT in new formulation of TCM, chiral drug resolution and detection of growing environment are summarized. Finally, we propose some issues still to be solved and future research directions to be expected of MIT for TCM studies.

Development of a time-resolved fluorescence microsphere Eu lateral flow test strip based on a molecularly imprinted electrospun nanofiber membrane for determination of fenvalerate in vegetables

Fenvalerate residues in fruits and vegetables may result in biological immune system disorders. Current sensor detection methods are harsh due to the shortcomings of antibody preparation and preservation conditions. Therefore, developing a recognition material with strong specificity, good stability, and low cost is of practical significance in designing a sensitive, simple, and rapid method. This study used precipitation polymerization to synthesize molecularly imprinted polymers (MIPs). The MIP was prepared into a fiber membrane using the electrostatic spinning method. After that, the fenvalerate hapten-mouse IgG-Eu fluorescent probe was synthesized, and the side flow chromatography strip was constructed to determine fenvalerate in vegetables using the immunocompetition method. The results showed that the adsorption capacity of MIP to fenvalerate was 3.65, and the adsorption capacity on MIPFM (an electrospinning membrane containing the fenvalerate MIPs) was five times that of free MIP. The test strip showed good linearity with R 2 = 0.9761 within the range of 50 μg/L-1,000 μg/L. In conclusion, substituting fenvalerate monoclonal antibodies with a molecularly imprinted electrospinning membrane is ideal for rapid onsite detection of pyrethroids.

Recent Advances in the Recognition Elements of Sensors to Detect Pyrethroids in Food: A Review

The presence of pyrethroids in food and the environment due to their excessive use and extensive application in the agriculture industry represents a significant threat to public health. Therefore, the determination of the presence of pyrethroids in foods by simple, rapid, and sensitive methods is warranted. Herein, recognition methods for pyrethroids based on electrochemical and optical biosensors from the last five years are reviewed, including surface-enhanced Raman scattering (SERS), surface plasmon resonance (SPR), chemiluminescence, biochemical, fluorescence, and colorimetric methods. In addition, recognition elements used for pyrethroid detection, including enzymes, antigens/antibodies, aptamers, and molecular-imprinted polymers, are classified and discussed based on the bioreceptor types. The current research status, the advantages and disadvantages of existing methods, and future development trends are discussed. The research progress of rapid pyrethroid detection in our laboratory is also presented.

Magnetic Molecularly Imprinted Polymer for the Selective Enrichment of Glyphosate, Glufosinate, and Aminomethylphosphonic Acid Prior to High-Performance Liquid Chromatography

A novel mixed iron hydroxide molecularly imprinted polymer (MIH-MIP) was synthesized via polymerization using mixed-valence iron hydroxide as a magnetic supporter, glyphosate as a template, acrylamide as a functional monomer, and ethylene glycol dimethacrylate as a cross-linker. The resulting material was characterized and applied as a sorbent for the selective enrichment of glyphosate, aminomethylphosphonic acid, and glufosinate by magnetic solid-phase extraction (MSPE) prior to high-performance liquid chromatography. MIH-MIP possessed a high adsorption capacity in the range of 2.31-5.40 mg g^-1 with good imprinting factors ranging from 1.52 to 7.59. The Langmuir model proved that the recognition sites were distributed as a monolayer on the surface of MIH-MIP. Scatchard analysis showed two types of binding sites on MIH-MIP. The kinetic characteristics of MIH-MIP suggested that the binding process of all analytes fit well with the pseudosecond-order model. The developed methodology provides good linearity in the range of 72.0-2000.0 μg L^-1. Low detection limits of 21.0-22.5 μg L^-1 and enrichment factors of up to 18 were achieved. The precision in terms of relative standard deviations of the intra- and interday experiments was better than 7 and 9%, respectively. The applicability of the developed MSPE facilitates the accurate and efficient determination of water, soil, and vegetable samples with satisfactory recoveries in the range of 86-118%. The results confirmed the suitability of the MIH-MIP sorbent for selective extraction and quantification of glyphosate, aminomethylphosphonic acid, and glufosinate.

Point-of-Care Diagnostics: Molecularly Imprinted Polymers and Nanomaterials for Enhanced Biosensor Selectivity and Transduction

Significant healthcare disparities resulting from personal wealth, circumstances of birth, education level, and more are internationally prevalent. As such, advances in biomedical science overwhelmingly benefit a minority of the global population. Point-of-Care Testing (POCT) can contribute to societal equilibrium by making medical diagnostics affordable, convenient, and fast. Unfortunately, conventional POCT appears stagnant in terms of achieving significant advances. This is attributed to the high cost and instability associated with conventional biorecognition: primarily antibodies, but nucleic acids, cells, enzymes, and aptamers have also been used. Instead, state-of-the-art biosensor researchers are increasingly leveraging molecularly imprinted polymers (MIPs) for their high selectivity, excellent stability, and amenability to a variety of physical and chemical manipulations. Besides the elimination of conventional bioreceptors, the incorporation of nanomaterials has further improved the sensitivity of biosensors. Herein, modern nanobiosensors employing MIPs for selectivity and nanomaterials for improved transduction are systematically reviewed. First, a brief synopsis of fabrication and wide-spread challenges with selectivity demonstration are presented. Afterward, the discussion turns to an analysis of relevant case studies published in the last five years. The analysis is given through two lenses: MIP-based biosensors employing specific nanomaterials and those adopting particular transduction strategies. Finally, conclusions are presented along with a look to the future through recommendations for advancing the field. It is hoped that this work will accelerate successful efforts in the field, orient new researchers, and contribute to equitable health care for all.

Developments of Smart Drug-Delivery Systems Based on Magnetic Molecularly Imprinted Polymers for Targeted Cancer Therapy: A Short Review

Cancer therapy is still a huge challenge, as especially chemotherapy shows several drawbacks like low specificity to tumor cells, rapid elimination of drugs, high toxicity and lack of aqueous solubility. The combination of molecular imprinting technology with magnetic nanoparticles provides a new class of smart hybrids, i.e., magnetic molecularly imprinted polymers (MMIPs) to overcome limitations in current cancer therapy. The application of these complexes is gaining more interest in therapy, due to their favorable properties, namely, the ability to be guided and to generate slight hyperthermia with an appropriate external magnetic field, alongside the high selectivity and loading capacity of imprinted polymers toward a template molecule. In cancer therapy, using the MMIPs as smart-drug-delivery robots can be a promising alternative to conventional direct administered chemotherapy, aiming to enhance drug accumulation/penetration into the tumors while fewer side effects on the other organs. Overview: In this review, we state the necessity of further studies to translate the anticancer drug-delivery systems into clinical applications with high efficiency. This work relates to the latest state of MMIPs as smart-drug-delivery systems aiming to be used in chemotherapy. The application of computational modeling toward selecting the optimum imprinting interaction partners is stated. The preparation methods employed in these works are summarized and their attainment in drug-loading capacity, release behavior and cytotoxicity toward cancer cells in the manner of in vitro and in vivo studies are stated. As an essential issue toward the development of a body-friendly system, the biocompatibility and toxicity of the developed drug-delivery systems are discussed. We conclude with the promising perspectives in this emerging field. Areas covered: Last ten years of publications (till June 2020) in magnetic molecularly imprinted polymeric nanoparticles for application as smart-drug-delivery systems in chemotherapy.