Evaluation of the simultaneous removal of recalcitrant drugs (bezafibrate, gemfibrozil, indomethacin and sulfamethoxazole) and biodegradable organic matter from synthetic wastewater by electro-oxidation coupled with a biological system

A review of hybrid enzymatic-chemical treatment for wastewater containing antiepileptic drugs

Epilepsy is one of the most common neurological diseases worldwide and requires treatment with antiepileptic drugs for many years or for life. This fact leads to the need for constant production and use of these compounds, placing them among the four pharmaceutical classes most found in wastewater. Even at low concentrations, antiepileptics pose risks to human and environmental health and are considered organic contaminants of emerging concern. Conventional treatments have shown low removal of these drugs, requiring advanced and innovative approaches. In this context, this review covers the results and perspectives on (1) consumption and occurrence of antiepileptics in water, (2) toxicological effects in aquatic ecosystems, (3) enzymatic and advanced oxidation processes for degrading antiepileptics drugs from a molecular point of view (biochemical and chemical phenomena), (4) improvements in treatment efficiency by hybridization, and (5) technical aspects of the enzymatic-AOP reactors.

Biodegradation of emerging organic pollutant gemfibrozil: Mechanism, kinetics and pathway modelling

The increasing population has raised the demand for pharmaceutical and personal care products to maintain a good health. Gemfibrozil (GEM), is extensively used as a lipid regulator and is frequently detected in wastewater treatment systems and poses deleterious health and ecological effects. Hence, the current study employing Bacillus sp. N2 reports the degradation of gemfibrozil via co-metabolism in 15 days. The study reported 86 % degradation with GEM (20 mgL^-1) using sucrose (150 mgL^-1) as a co-substrate; as compared to 42 % without a co-substrate. Further, time-profiling studies of metabolites revealed significant demethylation and decarboxylation reactions during degradation that leads to formation of six (M1, M2, M3, M4, M5, M6) metabolites as by-products. Based on the LC-MS analysis a potential degradation pathway for GEM by Bacillus sp. N2 was proposed. The degradation of GEM has not been reported so far and the study envisages eco-friendly approach to tackle pharmaceutical- active- compounds.

A novel molecularly imprinted electrochemical sensor based on a nitrogen-doped graphene oxide quantum dot and molybdenum carbide nanocomposite for indometacin determination

In this work, nitrogen-doped graphene oxide quantum dots (N-GOQDs) were embedded into Mo₂C to prepare a nanocomposite with great electrical conductivity and a large specific surface area. We manufactured an innovative electrochemical sensor based on N-GOQDs-Mo₂C and a molecularly imprinted polymer (MIP) for the highly sensitive detection of indometacin (IDMC). The MIP was synthesized by electropolymerization using acrylamide as the functional monomer and IDMC as the template molecule. N-GOQDs-Mo₂C was organized by an elementary hydrothermal approach and characterized by SEM, TEM, XRD and FT-IR. In the first-rank experimental conditions, the MIP electrochemical sensor shows a wide linear range from 10^-15 M to 10^-5 M for IDMC detection and the detection limit is as low as 9.508 × 10^-16 M. Additionally, the manufactured sensor shows great selectivity for indometacin, excellent repeatability and stableness. The sensor can be applied to the detection of indometacin in tablets and water samples with fulfilling consequence.

Screening and Seasonal Behavior of Analgesics, Non-steroidal Anti-inflammatory Drugs, and Antibiotics in Two Urban Wastewater Treatment Plants

Pharmaceutical active compounds (PhACs) belonging to analgesics, antibiotics, and non-steroidal anti-inflammatory drugs (NSAIDs) therapeutic classes were monitored in wastewater influents and effluents from two Portuguese urban wastewater treatment plants (UWWTPs) for 24 months. Both facilities were chosen due to their effluents are discharged in highly touristic and sensitive areas, Tagus river and Ria Formosa coastal lagoon, respectively. Target PhACs, acetaminophen, diclofenac, ibuprofen, naproxen, sulfadiazine, and sulfamethoxazole were measured using solid-phase extraction (SPE) coupled to liquid chromatography tandem mass spectrometry (LC-MS/MS). PhACs occurrence in the influents was higher than 98%, with acetaminophen presenting the highest concentrations, with values between 16.3 µg/L and 124 µg/L. In the effluents, distinct behavior was observed with diclofenac and sulfamethoxazole showing recalcitrant characteristics, whereas acetaminophen, ibuprofen, and naproxen showed removal efficiencies above 95%. Acetaminophen and ibuprofen amount in influents showed consistently higher concentration levels in autumn (in Beirolas and Faro Nw UWWTPs) and winter (only in Beirolas UWWTP) seasons. These seasonal trends were observed to a greater extent in Beirolas UWWTP than in Faro Nw UWWTP. This study enabled the comprehensive definition of a behavior pattern for these target contaminants, contributing to better characterization and build-up a library of PhACs occurrence. It also allowed a robust seasonal profiling of the target compounds due to the high number of samples analyzed by each season and a longer monitoring campaign, making the obtained results more significant.

Recent Trends in Pharmaceuticals Removal from Water Using Electrochemical Oxidation Processes

Nowadays, the research on the environmental applications of electrochemistry to remove recalcitrant and priority pollutants and, in particular, drugs from the aqueous phase has increased dramatically. This literature review summarizes the applications of electrochemical oxidation in recent years to decompose pharmaceuticals that are often detected in environmental samples such as carbamazapine, sulfamethoxazole, tetracycline, diclofenac, ibuprofen, ceftazidime, ciprofloxacin, etc. Similar to most physicochemical processes, efficiency depends on many operating parameters, while the combination with either biological or other physicochemical methods seems particularly attractive. In addition, various strategies such as using three-dimensional electrodes or the electrosynthesis of hydrogen peroxide have been proposed to overcome the disadvantages of electrochemical oxidation. Finally, some guidelines are proposed for future research into the applications of environmental electrochemistry for the degradation of xenobiotic compounds and micropollutants from environmental matrices. The main goal of the present review paper is to facilitate future researchers to design their experiments concerning the electrochemical oxidation processes for the degradation of micropollutants/emerging contaminants, especially, some specific drugs considering, also, the existing limitations of each process.

Recent Trends in Removal Pharmaceuticals and Personal Care Products by Electrochemical Oxidation and Combined Systems

Due to various potential toxicological threats to living organisms even at low concentrations, pharmaceuticals and personal care products in natural water are seen as an emerging environmental issue. The low efficiency of removal of pharmaceuticals and personal care products by conventional wastewater treatment plants calls for more efficient technology. Research on advanced oxidation processes has recently become a hot topic as it has been shown that these technologies can effectively oxidize most organic contaminants to inorganic carbon through mineralization. Among the advanced oxidation processes, the electrochemical advanced oxidation processes and, in general, electrochemical oxidation or anodic oxidation have shown good prospects at the lab-scale for the elimination of contamination caused by the presence of residual pharmaceuticals and personal care products in aqueous systems. This paper reviewed the effectiveness of electrochemical oxidation in removing pharmaceuticals and personal care products from liquid solutions, alone or in combination with other treatment processes, in the last 10 years. Reactor designs and configurations, electrode materials, operational factors (initial concentration, supporting electrolytes, current density, temperature, pH, stirring rate, electrode spacing, and fluid velocity) were also investigated.