Evaluation of tire derived rubber (TDR) fixed biofilm reactor (FBR) for remediation of Methylene blue dye from wastewater

Assessment of Potential Use of a Composite Based on Polyester Textile Waste as Packing Elements of a Trickle Bed Bioreactor

Biological wastewater treatment using trickle bed reactors is a commonly known and used solution. One of the key elements of the proper operation of the trickle bed bioreactor is the appropriate selection of biofilm support elements. The respective properties of the bioreactor packing media used can influence, among other things, the efficiency of the treatment process. In this study, the possibility of polyester waste material usage for the preparation of the biofilm support elements was tested. The following properties were checked: adsorption capacity, swelling, surface morphology, microbicidal properties, as well as the possibility of their use in biological wastewater treatment. The tested elements did not adsorb copper nor showed microbicidal properties for bacterial strains Escherichia coli and Staphylococcus aureus as well as fungal strains Aspergillus niger and Chaetomium globosum. The hydrophilic and rough nature of the element surface was found to provide a friendly support for biofilm formation. The durability of the elements before and after their application in the biological treatment process was confirmed by performing tests such as compressive strength, FTIR analysis, hardness analysis and specific surface area measurement. The research confirmed the applicability of the packing elements based on polyester textile waste to the treatment of textile wastewater. The treatment efficiency of the model wastewater stream was above 90%, while in the case of a stream containing 60% actual industrial wastewater it was above 80%. The proposed solution enables the simultaneous management of textile waste and wastewater treatment, which is consistent with the principles of a circular economy. The selected waste raw material is a cheap and easily available material, and the use of the developed packing elements will reduce the amount of polyester materials ending up in landfills.

Assessment of the aerobic glass beads fixed biofilm reactor (GBs-FBR) for the treatment of simulated methylene blue wastewater

The present research is focused on the application of glass beads (GBs) in fixed biofilm reactor (FBR) for the treatment of simulated methylene blue (MB) wastewater for 9 weeks under aerobic conditions. The COD of MB wastewater showed a reduction of 86.48% from 2000 to 270.4 mg/L, and BOD was declined up to 97.7% from 1095.5 to 25.03 mg/L. A drastic increase in the pH was observed until the 3rd week (8.5 to 8.28), and later, marginal changes between 8.30 ± 0.02 were noticed. A dramatic fluctuation was observed in ammonia concentration which increased (74.25 mg/L) up till the 2nd week, and from the 3rd week it started declining. In the 9th week, the ammonia concentration dropped to 16.5 mg/L. The color intensity increased significantly up till the 2nd week (259,237.46 Pt/Co) of the experiment and started decreasing slowly thereafter. The SEM-EDX analysis has shown the maximum quantity of carbon content in the GBs without biofilm, and then in the GB samples of 1st, and 9th-week old aerobic biofilms. Furthermore, Raman spectroscopy results revealed that the 9th-week GBs has a fine and strong MB peak and matched with that of the MB stock solution. Overall, the results have shown that the GBs filter media were suitable for the development of active biofilm communities for the treatment of dye wastewater. Thus, GBs-FBR system can be used for wastewater treatment to solve the current problem of industrial pollution in many countries and to protect the aquatic environment from dye pollution caused by the textile industry.