Performance evaluation of microbial fuel cell using a radiation synthesized low density polyethylene-grafted-poly (glycidyl methacrylate-co-vinyl acetate) as a proton exchange membrane

Sequential anaerobic-aerobic treatment of rice mill wastewater and simultaneous power generation in microbial fuel cell

Microbial fuel cells (MFCs) have attracted widespread interest due to their capability to generate power while treating wastewater. In the present investigation, rice mill wastewater (RMW) was treated in a dual-chamber MFC with a biological cathode (MFCB), in which anaerobic treatment was provided in the anode compartment, and aerobic treatment was enployed in the cathode compartment. The performance was compared with an identical MFC with an abiotic cathode (MFCA). During continuous operation, the hydraulic retention time (HRT) of the anode compartments of both MFCs was kept at 12 h. The maximum volumetric power density obtained in MFCB (379.53 mW/m3) was lower than MFCA (791.72 mW/m3). Similarly, the maximum open-circuit voltage (OCV) and operating voltages were 0.519 V and 0.170 V for MFCB, while for the MFCA, they were 0.774 V and 0.251 V, respectively. The internal resistance of MFCA was 372.34 Ω while the MFCB showed a higher internal resistance of 533.89 Ω. The linear sweep voltammetry and cyclic voltammetry also demonstrated high electrochemical activity in MFCA compared to MFCB. However, MFCB has shown a higher chemical oxygen demand (COD) removal efficiency (96.8%) than MFCA (88.4%) under steady-state conditions. Both anaerobic and aerobic degradation of organic substrates significantly reduced the COD of RMW. Furthermore, the absence of an expensive catalyst in the cathode substantially reduces the cost of the system. The electrical performance of the system can be enhanced by employing novel cathode material with surface modification.