Floc formation and growth mechanism during magnesium hydroxide and polyacrylamide coagulation process for reactive orange removal

Coagulation properties of magnetic magnesium hydroxide for removal of microplastics in the presence of kaolin and humic acid

Microplastics (MPs) is one of the most concerned emerging pollutants in recent years. Its widespread distribution has been shown to have potentially adverse effects on human health and ecosystems. Therefore, in this study, magnetic magnesium hydroxide coagulant (MMHC) was prepared by adding Fe3O4 magnetic micron particles in the Mg(OH)2 generation process, and it was used with PAM, a polymer flocculant, to remove polyethylene microplastics (≤270 μm) from water by coagulation. The removal efficiency of microplastics by MMHC reached 87.1%, which was 14.7% higher than that of traditional magnesium hydroxide coagulant (MHC). However, the Zeta potential of MMHC was lower than that of MHC, only 17.3 mV. In addition, the surface morphology of MMHC showed bubble-like clusters. The effect of PAM adding time on the microplastic removal efficiency was investigated. The best adding time of non-ionic PAM was 15s before the slow mixing started. The removal efficiency of organic matter and suspended particles in water by MMHC was determined by turbidity, ultraviolet spectrophotometry and three-dimensional fluorescence. The maximum removal efficiency was 98.5% and 93.3%, respectively. With the increase of the concentration of humic acid and kaolin in water, the removal efficiency of microplastics was basically not affected. MMHC can be reused after recycle, but it was found that the electrical neutralization mechanism was affected due to the transformation of its Zeta potential, and the adsorption effect of humic acid and kaolin particles in water became worse, the removal efficiency of microplastics, turbidity and UV254 decreased to 20.2%, 17.5% and 30%, respectively.

Evaluation of the coagulation properties of magnesium hydroxide for removal combined contamination of reactive dyes and microfibers

Microfibers are a new type of pollutants that are widely distributed in water bodies. And the simultaneous removal of pollutants in water is popular research in the field of water treatment. In this study, magnesium hydroxide was used as coagulant to investigate the performance and mechanism of coagulation and removal of dyes (reactive orange) and microfibers (MFs). The presence of dyestuff in the composite system promoted the removal of microfibers, and the maximum removal efficiency of both could reach 95.55% and 95.35%. The coagulation mechanism was explored by scanning electron microscopy (SEM), Fourier transform infrared spectroscopy (FTIR), and zeta potential. The removal of reactive orange and microfibers relied on electrical neutralization, sweep flocculation, and adsorption mechanisms. Turbidity can enhance the removal efficiency of both. Boosting the rotational speed can increase the removal efficiency of microfibers. This study provides an important theoretical support for an in-depth understanding of the characteristics and mechanisms of coagulation for the removal of complex pollutants from printing and dyeing wastewater.