The effect of horizontal forces from a Smart Walker on gait and perceived exertion

Users' adaptations to the proportional speed control of a motorised walker

PURPOSE

Speed control is commonly used to regulate the forces applied by motorised walkers (MW) and there are often situations where the speed targeted deviates from the preferred walking speed of its users, such as when encouraging higher walking speeds and due to safety consideration. This study investigates the effects of different MW's target speeds on the selected walking speeds, force applied, perceived exertion, and gait of MW users during steady-state walking.

MATERIALS AND METHODS

The spatiotemporal gait parameters and perceived exertion of twenty young healthy participants were measured as they walked at a comfortable, self-selected speed using a MW as it was controlled to target forward speeds of 0.6, 0.8, 1.0, 1.2, and 1.4 m s-1 as well as when no assistive force was applied by the MW.

RESULTS

On average, users would walk slower when their "No Assist" walking speed is higher than the MW's speed target and vice versa. Additionally, the force applied to the MW is proportional to the difference in speed, either faster or slower, when compared to "No Assist".

CONCLUSION

The user's exertion and the energy used by the MW are both minimised when target speed is close to the preferred walking speed of the user. Additionally, these findings suggest that the speed target can be used to change the walking speed of users but only to a certain extend and at the cost of higher perceived exertion.Implications for rehabilitationThe larger the difference between the target speed of the MW and the preferred walking speed of the user, the more likely the user is to push or pull on the MW.Users would push or pull on the MW with a force proportional to the difference from their preferred walking speed even when matching the MW's target speed.Users can be encouraged to walk at higher than preferred speeds, even though this would come at the cost of higher perceived exertion.

Evaluation of Physical Interaction during Walker-Assisted Gait with the AGoRA Walker: Strategies Based on Virtual Mechanical Stiffness

Smart walkers are commonly used as potential gait assistance devices, to provide physical and cognitive assistance within rehabilitation and clinical scenarios. To understand such rehabilitation processes, several biomechanical studies have been conducted to assess human gait with passive and active walkers. Several sessions were conducted with 11 healthy volunteers to assess three interaction strategies based on passive, low and high mechanical stiffness values on the AGoRA Smart Walker. The trials were carried out in a motion analysis laboratory. Kinematic data were also collected from the smart walker sensory interface. The interaction force between users and the device was recorded. The force required under passive and low stiffness modes was 56.66% and 67.48% smaller than the high stiffness mode, respectively. An increase of 17.03% for the hip range of motion, as well as the highest trunk’s inclination, were obtained under the resistive mode, suggesting a compensating motion to exert a higher impulse force on the device. Kinematic and physical interaction data suggested that the high stiffness mode significantly affected the users’ gait pattern. Results suggested that users compensated their kinematics, tilting their trunk and lower limbs to exert higher impulse forces on the device.