Synthesis, Structural and Photophysical Evaluations of Urea Based Fluorescent PET Sensors for Anions

Novel Discrete and Imprinted Fluoride-Selective Sensors: Bridging the Gap from DMSO to Aqueous Samples

Fluoride in drinking water has beneficial or harmful health effects depending on its concentration. This highlights the need for new low-cost and portable sensors capable of in situ monitoring of F- ions. Unfortunately, achieving high levels of water compatibility and fluoride specificity remains a challenge. Here, four new urea-based discrete sensors are prepared and characterized. The sensors containing anthracenyl- (5) and 9H-fluorenyl- (7) signaling units exhibit intense luminescent emissions in dimethyl sulfoxide, the former being particularly sensitive and selective to fluoride. In water, 5 displays a superior sensitivity (871 M-1) and a detection limit (8 µm) below international guidelines, albeit with cross-sensitivity to H2PO4‾. To enhance the performance, 5 and 7 are embedded into a fluoride-imprinted polymeric matrix to give solid-state sensors (5P and 7P, respectively). 5P shows good sensitivity (360 M-1) and specificity in water. Besides, it has a low detection limit (35 µm) and a response linear range (118-6300 µm) encompassing the limit established by the Environmental Protection Agency (211 µm). Furthermore, 5P also displays good reusability and adequate recovery values in real-sample testing (102 ± 2%), constituting the first example of a low-cost anion-imprinted polymeric probe tailored for the selective sensing of fluoride in aqueous samples.

The two-pronged approach of heteroatoms and substituents to achieve a synergistic regulation of the ESIPT process in amino 2-(2'-hydroxyphenyl)benzoxazole derivatives

Amino 2-(2'-hydroxyphenyl)benzazole derivatives are a class of molecules with excellent photophysical properties. Most of them can be applied as a fluorescent probe via the excited-state intramolecular proton transfer (ESIPT) process. In this work, we focus on the effects of heteroatoms (O, S) and substituents (acetylacetone, hydrogen) in the derivatives. Using DFT/TDDFT methods with the B3LYP-D3BJ functionals, the absorption and emission peaks are in good agreement with the experimental data. Results of optimized structures, infrared vibrational spectra, and reduced density gradient present the existence of the ESIPT process in the S₁ state in these molecules, it also indirectly shows that the heteroatom S is more than O, and the substituent acetylacetone is more than hydrogen has stronger hydrogen bonds. The proton transfer (PT) potential energy curves (PECs) qualitatively show that it is easier for the heteroatom S to induce ESIPT than that of O. The same for the substituent acetylacetone than that of hydrogen. Under the joint influence of the simultaneous stacking of heteroatom S and acetylacetone substituent, the energy barrier of the PT process can be effectively lowered, realizing a synergistic strategy, which can provide some guidance for the design of fluorescent materials.

Substituent effect on ESIPT and hydrogen bond mechanism of N-(8-Quinolyl) salicylaldimine: A detailed theoretical exploration

The effects of substituent on excited-state intramolecular proton transfer (ESIPT) and hydrogen bonding of N-(8-Quinolyl) salicylaldimine (QS) have been studied by theoretical calculation with DFT and TDDFT. The representative electron-withdrawing nitryl and electron-donating methoxyl were selected to analyze the effects on geometries, intramolecular hydrogen bond interaction, absorption/fluorescence spectra, and the ESIPT process. The configurations of the three molecules (QS, QS-OMe and QS-NO₂) were optimized in the ground and excited states. The structure parameters, infrared spectra, hydrogen bond interactions, frontier molecular orbitals, absorption/fluorescence spectra, and potential curves have cross-validated the current results. The results show that the introduction of substituent results in a bathochromic-shift of the absorption and fluorescence spectra with large Stokes shift, and is more beneficial to the ESIPT process. The current work will be beneficial to the improvement of ESIPT properties and deepen understanding of the mechanism of ESIPT process.

N-Confused Porphyrin - A Unique "Turn-On" Chemosensor for CN- and F- ions and "Turn-Off" Sensor for ClO4 - ions

N-Confused meso-tetrakis(4-carbomethoxyphenyl)porphyrin (1) and its Ni(II) complex (1 a) have been synthesized and utilized for anion sensing studies, and the results are compared with N-confused meso-tetraphenylporphyrin (NCTPP). Anion susceptibilities of 1 and 1 a were investigated using spectroscopic, electrochemical, and DFT studies. Porphyrins 1 and 1 a were able to detect CN^- , F^- , and ClO₄ ^- ions selectively over the tested set of anions even at ppm level. Interestingly, the addition of ClO₄ ^- ions resulted in fluorescence quenching (turn off) whereas the addition of F^- or CN^- resulted in fluorescence enhancement (turn on). Notably, the TFA addition resulted in fluorescence quenching, whereas the fluorescence enhancement was observed while adding TBAOH. The higher association constant (K_a ) values with anions, lower detection limit, and shifts in redox potentials are due to the electron-withdrawing effect of the -COOCH₃ group at the para-position of the meso-phenyl ring. This electron-withdrawing nature is crucial for the higher affinity towards anions. The anion sensing description in this article may not only unveil the built-in nature of N-confused porphyrins, but may also provide a general proposal for the development of novel anion sensors based on porphyrinoids. The electron-deficient porphyrin framework, large polarisable π-system, and anion binding through the outer NH or a combination of the above factors serve as a foundation for N-confused porphyrin to act as an anion sensor.

Highly selective fluorescence sensors for the fluoride anion based on carboxylate-bridged diiron complexes

The diiron–sulfur clusters bearing urea and anthracene units showed rapid and selective recognition for the fluoride ion.

Colorimetric and luminescent sensors for chloride: hydrogen bonding vs deprotonation

The synthesis and photophysical properties of four squaramide based fluorescent anion sensors (1-4) are described. These luminescent compounds showed selectivity for Cl(-) over various other anions with concomitant changes in both their UV/visible and fluorescence properties upon Cl(-) addition, attributed to initial H-bonding followed by NH deprotonation in the presence of excess Cl(-), signaled by a color change. The nature of the electron withdrawing aryl substituents is directly related to the H-bonding ability/acidity of the squaramide protons and can be used to tune the deprotonation behavior.

Enhanced anion binding from unusual coordination modes of bis(thiourea) ligands in platinum group metal complexes

Treatment of a range of bis(thiourea) ligands with inert organometallic transition-metal ions gives a number of novel complexes that exhibit unusual ligand binding modes and significantly enhanced anion binding ability. The ruthenium(II) complex [Ru(η(6)-p-cymene)(κS,S',N-L(3)-H)](+) (2b) possesses juxtaposed four- and seven-membered chelate rings and binds anions as both 1:1 and 2:1 host guest complexes. The pyridyl bis(thiourea) complex [Ru(η(6)-p-cymeme)(κS,S',N(py)-L(4))](2+) (4) binds anions in both 1:1 and 1:2 species, whereas the free ligand is ineffective because of intramolecular NH⋅⋅⋅N hydrogen bonding. Novel palladium(II) complexes with nine- and ten-membered chelate rings are also reported.

Metal ion and anion-based "tuning" of a supramolecular metallogel

A bis(pyridylurea) ligand (1) forms metallogels in methanol in the presence of up to 0.5 equiv of copper(II) chloride. The metallogel has been characterized using powder X-ray diffraction, SEM, and MAS NMR spectroscopic techniques. The addition of further copper(II) chloride gives the unusual crystalline 4:3 coordination polymer [Cu3(1)4Cl4]Cl2 x nH2O (2). In the presence of 0.5 equiv of copper(II) nitrate, the 2:1 crystalline coordination polymer [Cu(1)2](NO3)2 x H2O x MeOH (5) is isolated. Both 2 and 5 have been characterized by single-crystal X-ray diffraction. Complex 5 represents a possible model for the gelator and highlights key interactions with counteranions that suggest a means to tune gel properties using anion binding. The influence of chloride and acetate anions (as their NBu4+ salts) on the rheological properties of the copper(II) chloride metallogels of 1 are investigated. The rheology of the anion-containing mixtures shows complex behavior with the gel structure apparently evolving over time.