Simultaneous Analysis of New Antidepressants by Densitometric Thin-Layer Chromatography

A facile on-off fluorescence approach for fluvoxamine determination in pharmaceutical tablets; application to content uniformity testing

A green-complied spectrofluorimetric approach for quantification of the antidepressant, fluvoxamine, has been established. The method that has been suggested relies on the development of an association complex between fluvoxamine and erythrosine B in an acetate buffer solution. After being excited at 530 nm, the quenching in erythrosine B's native fluorescence caused by complex formation with fluvoxamine was detected at a wavelength of 552 nm. The values of fluorescence quenching at the most optimal reaction conditions were rectilinear at the concentration range of 0.2-2.0 μg mL-1, with a good correlation coefficient (r = 0.9998). The detection limit for the method was 0.03 μg mL-1 while the quantitation limit was 0.09 μg mL-1. The suggested approach has been validated according to the ICH. The established approach was effectively used to determine the drug under study in its dosage form with an average percent recovery of 98.92 ± 0.87 (n = 5), with no effect caused by the existing excipients. The proposed approach was also successfully used for the content uniformity test.

Influence of Chromatographic Conditions on LOD and LOQ of Fluoxetine and Sertraline Analyzed by TLC-Densitometric Method

This research introduces the analysis of fluoxetine and sertraline by means of the TLC-densitometric method. They provide information on LOD and LOQ under various chromatographic conditions. The study used adsorption (NPTLC) and partition (RPTLC) thin-layer chromatography in combination with a densitometric analysis. Four types of chromatographic plates precoated with: silica gel 60 F254, silica gel 60, silanized silica gel 60 F254 (RP-2), and a mixture of silica gel 60 and kieselguhr F254, as well as three mobile phases: chloroform + methanol + ammonia (9:1:0.4, v/v/v), chloroform + methanol + glacial acetic acid (5:4:1, v/v/v), and acetone + toluene + ammonia (10:9:1, v/v/v), were used in NPTLC. RP-18F254 and silanized silica gel 60 F254 (RP-2) plates and four mobile phases: methanol + water (10:0 and 9:1, v/v), acetone + water (10:0 and 9:1, v/v), were used in RPTLC. The lowest LOD and LOQ values for fluoxetine were obtained using a silanized silica gel 60 F254 (RP-2) with acetone + toluene + ammonia (10:9:1, v/v/v) in NPTLC, and with a silanized silica gel 60 F254 (RP-2) in combination with methanol + water (10:0, v/v) in RPTLC. The lowest LOD and LOQ values of sertraline were obtained using a silica gel 60 with acetone + toluene + ammonia (10:9:1; v/v/v) in NPTLC. The smallest amount of sertraline was detected on the silanized silica gel 60 F254 plate in combination with methanol + water (9:1, v/v) in RPTLC. The obtained results provide important information that can give a good basis and set the direction for further, more detailed research; the results can also benefit other researchers who analyze fluoxetine and sertraline with the TLC technique in model systems (testing standards) as well as in drug and biological samples.

Determination of selective serotonin reuptake inhibitors in biological samples via magnetic stirring-assisted dispersive liquid–liquid microextraction followed by high performance liquid chromatography

This work reports an efficient, quick and low-cost procedure for the determination of serotonin reuptake inhibitors (SSRIs) in low concentration levels in biological fluids.

Paroxetine hydrochloride

Paroxetine hydrochloride (3S-trans)-3-[(1,3-benzodioxol-5-yloxy)methyl]-4-(4-fluorophenyl)-piperidine hydrochloride (or (-)-(3S,4R)-(4-(p-fluorophenyl)-3-[[3,4-(methylenedioxy)-phenoxy]methyl]piperidine hydrochloride), a phenylpiperidine derivative, is a selective serotonin reuptake inhibitor. Paroxetine is indicated for the treatment of depression, generalized anxiety disorder, obsessive-compulsive disorder, panic disorder, posttraumatic stress disorder, and social anxiety disorder. The physicochemical properties, spectroscopic data (1D and 2D NMR, UV, FT-IR, MS, PXRD), stability, methods of preparation and chromatographic methods of analysis of pharmaceutical, and biological samples of paroxetine are documented in this review. Pharmacokinetics, metabolism, and pharmacological effects are also discussed.

Surfactant to dye binding degree method for the determination of fluvoxamine maleate and citalopram hydrobromide in pharmaceuticals

The surfactant to dye binding degree (SBDB) methodology was used to determine fluvoxamine maleate and citalopram hydrobromide. Neutral red and sodium dodecyl sulfate (SDS) were used as the dye and surfactant, respectively, to form dye-surfactant aggregates. When a cationic drug is added to dye-surfactant mixture, it interacts with the surfactant and decreases the dye-surfactant binding degree. This decrease is proportional to the drug concentration. This was measured by monitoring the absorbance changes of the dye at 532 nm. Under the optimum conditions, the calibration graphs were linear over the range of 1.2–15 μg mL−1 and 1.1–15 μg mL−1 for fluvoxamine maleate and citalopram hydrobromide, respectively. The detection limits (signal to noise ratio = 3) were found to be 0.37 and 0.35 μg mL−1, for fluvoxamine maleate and citalopram hydrobromide, respectively.

Rapid HPLC method for the simultaneous monitoring of duloxetine, venlaflaxine, fluoxetine and paroxetine in biofluids

A simple and rapid HPLC method is developed for the determination of two serotonin–norepinephrine-reuptake inhibitors (duloxetine and venlaflaxine) and two selective serotonin-reuptake inhibitors (fluoxetine and paroxetine) in human biofluids. Separation was performed on an Inertsil ODS-3 column (250 x 4.0 mm, 5 µm) with acetonitrile–ammonium acetate (0.05 M, 41:59 v/v) at 235 nm, within 7 min. SPE on Oasis® HLB cartridges was applied for the isolation of analytes from biofluids. The developed methodology was validated in terms of sensitivity, linearity, accuracy, precision, stability and selectivity. Relative standard deviation was less than 10.4%. Limit of detection was 0.2–0.6 ng/µl in blood plasma and 0.1–0.8 ng/µl in urine. The method was successfully applied to biofluids from a patient under duloxetine treatment.

Modern bioanalytical methods for the rapid detection of antidepressants: SNRIs and SSRIs in human biological samples

Serotonin–norepinephrine-reuptake inhibitors (SNRIs) and selective serotonin-reuptake inhibitors (SSRIs) belong to a new generation of antidepressants used in the treatment of depression and other mood disorders. SSRIs act as reuptake inhibitors primarily via the inhibition of the neuronal reuptake of serotonin (5-HT) in the CNS. SNRIs have additional inhibitory activity at noradrenaline-reuptake sites. Different analytical methods for the routine monitoring and toxicological screening of SNRIs and SSRIs have been developed. Rapid quantification is a necessity for clinical use, allowing the possibility of diagnostics. This review focuses on recent advances of the methods that concern the determination of SSRIs and SNRIs in human biological samples. Sample preparation methodologies are discussed, because sample pretreatment is the most limiting and crucial step in analysis of biological matrices. Furthermore, information concerning the mechanism of action, side effects and toxicity are also given.