A chemometric approach for the quantification of free fatty acids in cottonseed oil by Fourier transform infrared spectroscopy

Chemical Composition and Thermogravimetric Behaviors of Glanded and Glandless Cottonseed Kernels

Common “glanded” (Gd) cottonseeds contain the toxic compound gossypol that restricts human consumption of the derived products. The “glandless” (Gl) cottonseeds of a new cotton variety, in contrast, show a trace gossypol content, indicating the great potential of cottonseed for agro-food applications. This work comparatively evaluated the chemical composition and thermogravimetric behaviors of the two types of cottonseed kernels. In contrast to the high gossypol content (3.75 g kg⁻¹) observed in Gd kernels, the gossypol level detected in Gl kernels was only 0.06 g kg⁻¹, meeting the FDA’s criteria as human food. While the gossypol gland dots in Gd kernels were visually observed, scanning electron microcopy was not able to distinguish the microstructural difference between ground Gd and Gl samples. Chemical analysis and Fourier transform infrared (FTIR) spectroscopy showed that Gl kernels and Gd kernels had similar chemical components and mineral contents, but the former was slightly higher in protein, starch, and phosphorus contents. Thermogravimetric (TG) processes of both kernels and their residues after hexane and ethanol extraction were based on three stages of drying, de-volatilization, and char formation. TG-FTIR analysis revealed apparent spectral differences between Gd and Gl samples, as well as between raw and extracted cottonseed kernel samples, indicating that some components in Gd kernels were more susceptible to thermal decomposition than Gl kernels. The TG and TG-FTIR observations suggested that the Gl kernels could be heat treated (e.g., frying and roasting) at an optimal temperature of 140–150 °C for food applications. On the other hand, optimal pyrolysis temperatures would be much higher (350–500 °C) for Gd cottonseed and its defatted residues for non-food bio-oil and biochar production. The findings from this research enhance the potential utilization of Gd and Gl cottonseed kernels for food applications.

Monitoring Enzymatic Hydroesterification of Low-Cost Feedstocks by Fourier Transform InfraRed Spectroscopy

Enzymatic hydroesterification is a heterogeneous catalyzed process suitable for the conversion of low-cost feedstocks in biodiesel production, namely, because of its tolerance to high free fatty acid contents. The current study describes the use of Fourier transform infrared spectroscopy (FTIR) to monitor biodiesel production using enzymatic hydroesterification and, as raw materials, acid oil from soapstock and olive pomace oil. Acid oil (~34 wt.% FFA) and olive pomace oil (~50 wt.% FFA) were first hydrolyzed (35 °C, 24 h, 200 rpm, 3 wt.% of lipase from Thermomyces lanuginosus, and 1:0.5 water:oil ratio, w:w), and then enzymatic esterification was performed (35 °C, 7 h, 200 rpm, 2 wt.% of lipase from Thermomyces lanuginosus, and 2:1 molar ratio of methanol to acid). FTIR analyses were conducted on the products using a Jasco FT/IR-4100 with a scanning range of 4000–650 cm−1 at 4 cm−1 spectral resolution and 54 scans. For free fatty acid (FFA) quantification, the C=O band at 1708 cm–1 was used, corresponding to the carboxylic acid, whereas for fatty acid methyl ester (FAME) quantification, the peak corresponding to C=O at 1746 cm−1 was considered, which corresponded to the ester. The results were calibrated using volumetric titration and gas chromatography analyses, concerning FFA and FAME quantification, respectively. The best conditions for analysis were determined, and a calibration method was established. FTIR has shown to be a simple, fast, and clean technique suitable to monitor hydroesterification of low-cost feedstocks.