Activation of peroxymonosulfate into amoxicillin degradation using cobalt ferrite nanoparticles anchored on graphene (CoFe2O4@Gr)

Cellulose beads supported CoFe2O4: A novel heterogeneous catalyst for efficient rhodamine B degradation via advanced oxidation processes

In this study, a novel mechanical process was used to produce cellulose beads (CB). These beads were then doped with cobalt ferrite nanoparticles (CoFe2O4 NPs) to serve as catalysts for the degradation of rhodamine B (RhB) through peroxymonosulfate (PMS) activation. The physical and chemical properties of CoFe2O4 and CoFe2O4@CB catalysts were characterized using X-ray diffraction (XRD), Fourier-transform infrared spectroscopy (FT-IR), scanning electron microscopy (SEM) combined with energy dispersive X-ray spectrometer (EDX), scanning transmission electron microscopy (STEM) techniques, and thermogravimetric analysis (TGA). To optimize RhB degradation efficiency, Response Surface Methodology (RSM) was employed, utilizing the Box-Behnken design (BBD). Under the optimized conditions of a catalyst dosage of 0.40 g/L, PMS dosage of 0.98 mM, RhB concentration of 40 mg/L, pH of 5.27, and reaction time of 60 min, a remarkable degradation efficiency of 98.51 % was achieved at a temperature of 25 °C. In quenching experiments, 1O2, SO4•-, and HO• species are produced in the CoFe2O4@CB/PMS system, with 1O2, and SO4•- species dominating RhB degradation. Remarkably, the new CoFe2O4@CB catalyst has demonstrated exceptional stability and reusability, validated by recycling tests (up to 78 % of RhB degradation efficiency after a 5-cycle experiment) and subsequent characterizations (FTIR, SEM, and EDX) emphasizing unchanged bands, uniform distribution, and consistent composition after reuse cycles. These results demonstrate the effectiveness of mechanically produced CoFe2O4@CB catalysts for advanced oxidation processes (AOPs), with promising applications in wastewater treatment.

Perovskite and Spinel Catalysts for Sulfate Radical-Based Advanced Oxidation of Organic Pollutants in Water and Wastewater Systems

Since environmental pollution by emerging organic contaminants is one of the most important problems, gaining ground year after year, the development of decontamination technologies of water systems is now imperative. Advanced oxidation processes (AOPs) with the formation of highly reactive radicals can provide attractive technologies for the degradation of organic pollutants in water systems. Among several AOPs that can be applied for the formation of active radicals, this review study focus on sulfate radical based-AOPs (SR-AOPs) through the heterogeneous catalytic activation of persulfate (PS) or peroxymonosulfate (PMS) using perovskite and spinel oxides as catalysts. Perovskites and spinels are currently receiving high attention and being used in substantial applications in the above research area. The widespread use of these materials is based mainly in the possibilities offered by their structure as it is possible to introduce into their structures different metal cations or to partially substitute them, without however destroying their structure. In this way a battery of catalysts with variable catalytic activities can be obtained. Due to the fact that Co ions have been reported to be one of the best activators of PMS, special emphasis has been placed on perovskite/spinel catalysts containing cobalt in their structure for the degradation of organic pollutants through heterogeneous catalysis. Among spinel materials, spinel ferrites (MFe2O4) are the most used catalysts for heterogeneous activation of PMS. Specifically, catalysts with cobalt ion in the A position were reported to be more efficient as PMS activators for the degradation of most organic pollutants compared with other transition metal catalysts. Substituted or immobilized catalysts show high rates of degradation, stability over a wider pH area and also address better the phenomena of secondary contamination by metal leaching, thus an effective method to upgrade catalytic performance.

Rapid sunlight-driven mineralisation of dyes and fungicide in water by novel sulphur-doped graphene oxide/Ag3VO4 nanocomposite

A semiconductor photocatalyst was prepared in facile, standard conditions by integrating 1% metal-free, sulphur-doped graphene oxide (sGO) as cocatalyst and Ag₃VO₄ as photocatalyst and characterised via spectroscopic, microscopic and voltammetric techniques. The catalytic activity was performed on notable water pollutants like textile dyes and fungicide employing various techniques. Cationic dyes such as methylene blue and rhodamine B were degraded > 99% with above 90% organic carbon content removal indicating total mineralisation while anionic dyes were degraded 75-80% in 1 h. For the first time, a dithiocarbamate fungicide thiram is degraded to give thiourea as a product in 1 h. Photocatalysis follows pseudo-first order kinetics with rate 3.67, 49.50 and 3.19 times higher than Ag₃VO₄, sGO and GO-Ag₃VO₄ respectively with excellent stability and recyclability. One percent sGO aided excellent carrier separation boosted by electrons and surface defects from sGO, morphology and n-n heterojunction formation. The catalyst efficiently removed 82.8% of the total organic carbon content of a real water sample from the textile mill under 2-h sunlight irradiation.

Synthesis and Properties of Ferrite-Based Nanoparticles

The work is dedicated to the study of the structural and optical characteristics, as well as the phase transformations, of ferrite nanoparticles of CeO₂-Fe₂O₃. To characterize the results obtained, the methods of scanning and transmission microscopy, X-ray diffraction (XRD) spectroscopy, and Mössbauer spectroscopy were applied. It was found that the initial nanoparticles are polycrystalline structures based on cerium oxide with the presence of X-ray amorphous inclusions in the structure, which are characteristic of iron oxide. The study determined the dynamics of phase and structural transformations, as well as the appearance of a magnetic texture depending on the annealing temperature. According to the Mossbauer spectroscopy data, it has been established that a rise in the annealing temperature gives rise to an ordering of the magnetic properties and a decrease in the concentration of cationic and vacancy defects in the structure. During the life test of synthesized nanoparticles as cathode materials for lithium-ion batteries, the dependences of the cathode lifetime on the phase composition of nanoparticles were established. It is established that the appearance of a magnetic component in the structure result in a growth in the resource lifetime and the number of operating cycles. The results show the prospects of using these nanoparticles as the basis for lithium-ion batteries, and the simplicity of synthesis and the ability to control phase transformations opens up the possibility of scalable production of these nanoparticles for cathode materials.