Viscoelastic Polyurethane Foams for Use in Seals of Respiratory Protective Devices

A key factor in effective protection against airborne hazards, i.e., biological and nonbiological aerosols, vapors, and gases, is a good face fit of respiratory protective devices (RPDs). Equally important is the comfort of use, which may encourage or discourage users from donning RPDs. The objective of the work was to develop viscoelastic polyurethane foams for use in RPD seals. The obtained foams were characterized using scanning electron microscopy, infrared spectroscopy, thermogravimetry, and differential scanning calorimetry. Measurements also involved gel fraction, apparent density, air permeability, elastic recovery time, compression set, rebound resilience, and sweat uptake. The results were discussed in the context of modifications to the foam formulation: the isocyanate index (I_NCO) in the range of 0.6–0.9 and the blowing agent content in the range of 1.2–3.0 php. FTIR analysis revealed a higher level of urea groups with increasing water content in the formulation. Higher I_NCO and water content levels also led to lower onset temperatures of thermal degradation and higher glass-transition temperatures of the soft phase. A decrease in apparent density and an increase in mean pore sizes of the foams with increasing I_NCO and water content levels was observed. Functional parameters (air permeability, elastic recovery time, compression set, rebound resilience, and sweat uptake) were also found to be satisfactory at lower I_NCO and water content levels.

Deformation mechanisms of sub-micrometer thermoplastic vulcanizates obtained by reaction-induced phase separation of miscible poly(ε-caprolactone)/dimethacrylate systems

The micromechanical deformation mechanisms of sub-μm thermoplastic vulcanizates (TPVs) based on poly(ε-caprolactone) (PCL) and cross-linked methacrylate rubbers were studied by time-resolved small-angle X-ray scattering (SAXS) and wide-angle X-ray diffraction (WAXD) measurements in order to better understand the underlying deformation mechanisms responsible for the high elongation at break and good elastic recovery of sub-μm TPVs. It is demonstrated that, in contrast to neat PCL, the interlamellar void formation in the PCL matrix and subsequent coalescence of voids is suppressed by the presence of the rubber (nano)particles in these TPVs. The deformation of the TPVs under tensile conditions is dominated by yielding of the PCL matrix, which is initially localized at the equatorial regions of the rubber particles and progresses towards the polar regions at higher strains. Re-ordering of the crystal structures is both time and stress dependent, and stress relaxation of the TPV under tension is primarily governed by the break-up of the crystal lamellae at the equatorial regions of the rubber particles. This study demonstrates that the rubber particle size as well as chemical grafting of thermoplastic polymer chains onto the surface of cross-linked rubber particles are important parameters to control the mechanical deformation behavior of TPVs.