Anharmonic effects in the thermodynamic properties of solids I. An adiabatic calorimeter for the temperature range 25-500 $deg$C: the heat capacities of Al2O3, Al and Pb

Beam heating from a fourth-generation synchrotron source

The high levels of flux available at a fourth-generation synchrotron are shown to have significant beam heating effects for high-energy X-rays and radiation hard samples, leading to temperature increases of over 400 K with a monochromatic beam. These effects have been investigated at the ID11 beamline at the recently upgraded ESRF Extremely Brilliant Source, using thermal lattice expansion to perform in situ measurements of beam heating. Results showed significant increases in temperature for metal and ceria samples, which are compared with a lumped thermodynamic model, providing a tool for estimating beam heating effects. These temperature increases may have a drastic effect on samples and measurements, such as the rapid recrystallization of a copper wire shown here. These results demonstrate the importance of beam heating and provide information needed to consider, predict and mitigate these effects.

Invited article: micron resolution spatially resolved measurement of heat capacity using dual-frequency time-domain thermoreflectance

A pump-probe photothermal technique - dual-frequency time-domain thermoreflectance - was developed for measuring heat capacity with a spatial resolution on the order of 10 μm. The method was validated by measuring several common materials with known heat capacity. Rapid measurement of composition-phase-property relationships was demonstrated on Ti-TiSi2 and Ni-Zr diffusion couples; experimental values of heat capacity of the intermetallic compounds in these diffusion couples were compared with literature values and CALPHAD (CALculation of PHAse Diagram) calculations. The combination of this method and diffusion multiples provides an efficient way to generate thermodynamic data for CALPHAD modeling and database construction. The limitation of this method in measuring low thermal diffusivity materials is also discussed.