Thin film gauges for fluctuating velocity measurements in blood

Velocity field studies at surgically imposed arterial stenoses on the abdominal aorta in pigs

In order to describe velocity profiles and the size of deterministic and non-deterministic velocity disturbances at arterial stenoses, symmetrical and asymmetrical stenoses with intended area reductions of 50% ('moderate') and 85% ('severe') were applied on the abdominal aorta in six pigs. Blood velocities were registered by hot-film anemometry in 21 measuring points distributed across the vessel cross-sectional area in one pre-stenotic and three post-stenotic positions. Signal analysis included ensemble averaging, the high-pass filtering technique, and three-dimensional visualization. None of the stenoses affected the pre-stenotic velocity field. Downstream moderate stenoses flow separation and vortex formation were present. Moderate asymmetric stenoses induced turbulence in the post-stenotic velocity field. Immediately downstream of severe stenoses a prominent post-stenotic jet was present. Farther downstream, a multitude of coherent vortices and turbulence dominated the flow field. The transverse distribution of turbulence intensity paralleled with the peak systolic velocity profile, whereas transverse profiles of the relative turbulence intensity (turbulence intensity/mean velocity) revealed peak values in flow field locations with high velocity gradients. Velocity parameters for symmetric and asymmetric severe stenoses were highly comparable. However, the exact degree of stenosis was significantly higher for symmetrical (85%) than for asymmetrical (76%) stenoses. Therefore, recalling that stenosis severity strongly influences the development of velocity disturbances, this indicates that asymmetry of a stenosis is a predictor for blood velocity disturbances.

Cardiac output measurements. A review of current techniques and research

Cardiac output is the volume of blood ejected by the heart per unit time. It is a useful measurement in that it can be used to evaluate overall cardiac status in both critically ill patients and patients with suspected cardiovascular disease. An ideal cardiac output measurement system would have automated continuous output capability, be minimally invasive, accurate, fast, small, low cost and clinically adaptable. This paper presents a theoretical and practical description of the variety of clinical techniques in use today and lists their advantages and shortcomings with respect to the ideal system. Included are the Fick method, indicator dilution techniques, velocity measurements and transthoracic impedance and combined Doppler ultrasound as noninvasive techniques. In addition, several experimental methods are described along with their desirable features and possible constraints. These include intravascular heating/recording, thermistor tracking of cardiac output, ejection fraction measurements and magnetic susceptibility plethysmography.

Turbulent blood flow in the ascending aorta of humans with normal and diseased aortic valves

Turbulent blood flow may contribute to a variety of pathophysiological effects. Because of its postulated importance, this study was undertaken to determine whether turbulent flow does in fact occur in the human body. In 15 persons (seven normal, seven aortic valvular disease, one prosthetic aortic valve), point velocity was measured in the ascending aorta with a hot-film anemometer probe. In one normal individual with a high cardiac output, turbulent flow occurred above the aortic valve during peak flow which corresponded to a peak Reynolds number of 10,000. In the other six normal subjects (peak Reynolds numbers of 5,700-8,900), flow was highly disturbed during peak ejection. Each of the subjects with aortic valvular disease and the subject with a prosthetic aortic valve showed turbulent flow during nearly the entire period of ejection, with Fourier components of velocity of significant magnitude up to 320 Hz (the maximum frequency we could evaluate with the equipment available). The turbulence energy density was higher in subjects with abnormal valves (3.2-14.6 ergs/cm3), than in normal subjects (0.6-2.9 ergs/cm3). In subjects with aortic stenosis, turbulence was observed throughout the ascending aorta and in the innominate artery. In others, the turbulence dissipated more proximally. The results of this study indicate that turbulent flow can occur in the ascending aorta of subjects with normal cardiac function; and it occurs consistently in the ascending aorta of individuals with abnormal aortic valves.

Turbulent blood flow in humans: its primary role in the production of ejection murmurs

To clarify the postulate that turbulence may produce ejection murmurs, point velocity and sound were measured in the ascending aorta of 13 subjects: six with normal aortic valves, six with aortic valvular disease, and one with a Bjork-Shiley prosthetic aortic valve. Velocity was measured with a catheter-tip hot film anemometer probe, and sound was measured with a catheter-tip micromanometer. Ejection murmurs detected intra-arterially were always found to be associated with turbulent or highly disturbed flow. Conversely, in the absence of intra-arterial sound during ejection, only minor disturbances of flow were detected. A linear relation between the sound energy density and turbulent energy density was shown (r = 0.92) and a linear relation between the acoustic power output (sound intensity) and turbulent power supply (r = 0.87) also was shown. Studies in vitro of sound and point velocity distal to a porcine valve inserted within a cast of the aorta, which permitted precise centering of the transducers along the axis of flow, confirmed these observations. When the power generated by the turbulence exceeded 3 ergs/sec per cm2, the murmurs were audible at the chest wall. The clinical gradation of the intensity of the murmurs increased as the power of turbulence increased. In conclusion, in this study we have demonstrated a clear association between turbulent blood flow and systolic ejection murmurs.