Assessment of a Monte-Carlo simulation of SPECT recordings from a new-generation heart-centric semiconductor camera: from point sources to human images

Development and validation of a full model of a four-headed neuroimaging single-photon emission computed tomography scanner

Objective

The Nucline X-Ring 4R is a four-headed gamma camera dedicated to neuroimaging. In this paper, we describe and validate a GATE (Geant4 Application for Tomographic Emission) model of the Nucline X-Ring 4R.

Materials and methods

Images produced during model simulations were compared with those acquired experimentally to confirm the model was an accurate representation of the scanner. The most commonly reported measurements used to validate a GATE model include energy resolution, spatial resolution and sensitivity. In addition to the commonly reported static imaging measures, single-photon emission computed tomography (SPECT) spatial resolution was investigated to confirm that the model produces similar SPECT images to the experimental output.

Results

The experimental full-width at half-maximum was calculated to be 12.3 keV, which corresponds to an energy resolution of 8.8%. The simulated full-width at half-maximum was measured to be 12 keV, giving an energy resolution of 8.6%. The average spatial resolutions were found to be well matched (5.69 mm – simulated and 5.64 mm – experimental). However, the sensitivity was overestimated using the GATE model (47.8 and 54.3 cps/MBq) compared with the values obtained experimentally (42.7 and 44.3 cps/MBq). Finally, the simulated SPECT spatial resolution images were found to produce qualitatively comparable results.

Conclusion

The model developed has been shown to produce similar results and images to those obtained experimentally. This model has the potential to simulate patient scans with the aim of improving patient care by optimizing scanner protocols.

Performance of cardiac cadmium-zinc-telluride gamma camera imaging in coronary artery disease: a review from the cardiovascular committee of the European Association of Nuclear Medicine (EANM)

The trade-off between resolution and count sensitivity dominates the performance of standard gamma cameras and dictates the need for relatively high doses of radioactivity of the used radiopharmaceuticals in order to limit image acquisition duration. The introduction of cadmium-zinc-telluride (CZT)-based cameras may overcome some of the limitations against conventional gamma cameras. CZT cameras used for the evaluation of myocardial perfusion have been shown to have a higher count sensitivity compared to conventional single photon emission computed tomography (SPECT) techniques. CZT image quality is further improved by the development of a dedicated three-dimensional iterative reconstruction algorithm, based on maximum likelihood expectation maximization (MLEM), which corrects for the loss in spatial resolution due to line response function of the collimator. All these innovations significantly reduce imaging time and result in a lower patient's radiation exposure compared with standard SPECT. To guide current and possible future users of the CZT technique for myocardial perfusion imaging, the Cardiovascular Committee of the European Association of Nuclear Medicine, starting from the experience of its members, has decided to examine the current literature regarding procedures and clinical data on CZT cameras. The committee hereby aims 1) to identify the main acquisitions protocols; 2) to evaluate the diagnostic and prognostic value of CZT derived myocardial perfusion, and finally 3) to determine the impact of CZT on radiation exposure.