Solid solubility limit in alloying nanoparticles

Differences in physicochemical properties to consider in the design, evaluation and choice between microparticles and nanoparticles for drug delivery

INTRODUCTION

The increase in the development of novel nanoparticle drug delivery systems makes the choice between micro- and nanoscale drug delivery systems ubiquitous. Changes in physical and chemical properties between micro- to nanosized particles give them different properties that influence their physiological, anatomical and clinical behavior and therefore potential application.

AREAS COVERED

This review focuses on the effect changes in the surface-to-volume ratio have on the thermal properties, solubility, dissolution and crystallization of micro- versus nanosized drug delivery systems. With these changes in the physicochemical properties in mind, the review covers computational and biophysical approaches to the design and evaluation of micro- and nanodelivery systems. The emphasis of the review is on the effect these properties have on clinical performance in terms of drug release, tissue retention, biodistribution, efficacy, toxicity and therefore choice of delivery system.

EXPERT OPINION

Ultimately, the choice between micro- and nanometer-sized delivery systems is not straightforward. However, if the fundamental differences in physical and chemical properties are considered, it can be much easier to make a rational choice of the appropriate drug delivery system size.

Bandgap engineering of colloidal zinc oxysulfide via lattice substitution with sulfur

Zinc oxysulfide nanocrystals with zinc blende phase are synthesized through a wet-chemical method. An affirmation of the crystal structure, elemental homogeneity and phase transformation is obtained by X-ray diffraction and authenticated by electron micrographic studies. Theoretical observations have strongly supported the thermodynamic solubility limit for its (30%) formation. An anomalous bandgap bowing with modulation in bandgap from 3.74 eV (ZnO) to 3.93 eV (ZnS) was observed with a minimum bandgap of 2.7 eV. Tunable bandgap and a wide range of visible emission ascertain it as a potential material for optoelectronic and solar cell applications due to its large bandgap offsets.