Solvent-mediated repair and patterning of surfaces by AFM

Prediction of Nanoscale Water Meniscus Shape between Deliquescent KDP Crystal Optics and AFM Probe for Water-Dissolution Repairing

KDP (KH2PO4) crystal optics are the key elements for megajoule laser facilities. Nanoscale surface defects would cause laser-induced damage when the optics are irradiated by a high-fluence laser (over 10 J/cm2). Dip-pen nanolithography (DPN) could be used to repair the nanoscale surface defects in the KDP optics by the water meniscus. The high humidity required for high-efficiency and soft KDP surfaces penetrated by the AFM probe brings challenges for accurately predicting the water meniscus shape to evaluate the effectiveness of the DPN water-dissolution repairing. The multisolutions of the Young-Laplace and Kelvin equations also lead to the wrong water meniscus shape. A theoretical model that takes the high humidity and the penetration of the AFM probes into account is developed. The parametrization Young-Laplace equations are adopted for the zero contact angle of the water films, and the AFM probe is treated as the combination of the cone and sphere for the water meniscus whose size is larger than the AFM tip radius under high humidity. The penetration of the AFM probe is modeled by Hertz theory. Both the water films (3.3 nm thickness at 99% relative humidity) and indentations (1.46 nm depth at 300 nN contact force) are non-negligible for the nanoscale water meniscus between the KDP surface and the AFM probe. Moreover, the rough-fine two-step method is proposed to lock the correct solution of the Young-Laplace and Kelvin equations. The effectiveness of the proposed model is verified by comparison with reported ESEM images and pull-off forces. In addition, the overgrowth dots on the KDP surface are compared with the water meniscus. The linear growth of the water meniscus would cause the linear growth of the overgrowth dot, which proves the proposed model could be used to guide the DPN water-dissolution repairing for the nanoscale surface defects in the KDP optics.

Reduction of selenite to selenium nanospheres by Se(IV)-resistant Lactobacillus paralimentarius JZ07

Elemental selenium nanosphere is considered to exhibit high bioavailability compared to its salts. In this study, a Se(IV)-resistant Lactobacillus paralimentarius strain JZ07 with great selenium biotransformation ability was screened and the red elemental selenium biosynthesized by it was characterized. The results indicated that Se(0) occurred as major accumulated species and the S atom content of the cells increased significantly in the presence of selenite. The reduced amorphous selenium nanospheres (150 to 300 nm in diameter) deposited in the extracellular space of JZ07 and the cells exhibited altered morphology under selenium stress. The macromolecules containing carboxylate bands and amide groups played an important role in Se(IV) bioaccumulation. The findings of present study indicate that JZ07 can be a promising SeNPs producing probiotic LAB and has the potential to be explored as an alternative source of Se supplements for human or animal consumption.

Scalable process for mitigation of laser-damaged potassium dihydrogen phosphate crystal optic surfaces with removal of damaged antireflective coating

We investigate an approach for the recycling of laser-damaged large-aperture deuterated potassium dihydrogen phosphate (DKDP) crystals used for optical switching (KDP) and for frequency conversion (DKDP) in megajoule-class high-power laser systems. The approach consists of micromachining the surface laser damage sites (mitigation), combined with multiple soaks and ultrasonication steps in a coating solvent to remove, synergistically, both the highly adherent machining debris and the laser-damage-affected antireflection coating. We identify features of the laser-damage-affected coating, such as the "solvent-persistent" coating and the "burned-in" coating, that are difficult to remove by conventional approaches without damaging the surface. We also provide a solution to the erosion problem identified in this work when colloidal coatings are processed during ultrasonication. Finally, we provide a proof of principle of the approach by testing the full process that includes laser damage mitigation of DKDP test parts, coat stripping, reapplication of a new antireflective coat, and a laser damage test demonstrating performance up to at least 12  J/cm² at UV wavelengths, which is well above current requirements. This approach ultimately provides a potential path to a scalable recycling loop for the management of optics in large, high-power laser systems that can reduce cost and extend lifetime of highly valuable and difficult to grow large DKDP crystals.

Insights into selenite reduction and biogenesis of elemental selenium nanoparticles by two environmental isolates of Burkholderia fungorum

Microorganisms capable of transforming toxic selenium oxyanions into non-toxic elemental selenium (Se°) may be considered as biocatalysts for the production of selenium nanoparticles (SeNPs), eventually exploitable in different biotechnological applications. Two Burkholderia fungorum strains (B. fungorum DBT1 and B. fungorum 95) were monitored during their growth for both capacity and efficiency of selenite (SeO₃^2-) reduction and elemental selenium formation. Both strains are environmental isolates in origin: B. fungorum DBT1 was previously isolated from an oil refinery drainage, while B. fungorum 95 has been enriched from inner tissues of hybrid poplars grown in a soil contaminated by polycyclic aromatic hydrocarbons. Our results showed that B. fungorum DBT1 is able to reduce 0.5mM SeO₃^2- to Se° when cultured aerobically in liquid medium at 27°C, while B. fungorum 95 can reduce more than 1mM SeO₃^2- to Se° within 96h under the same growth conditions, with the appearance of SeNPs in cultures of both bacterial strains. Biogenic SeNPs were spherical, with pH-dependent charge and an average hydrodynamic diameter of 170nm and 200nm depending on whether they were produced by B. fungorum 95 or B. fungorum DBT1, respectively. Electron microscopy analyses evidenced that Se nanoparticles occurred intracellularly and extracellularly. The mechanism of SeNPs formation can be tentatively attributed to cytoplasmic enzymatic activation mediated by electron donors. Biogenic nanoparticles were then probably released outside the bacterial cells as a consequence of a secretory process or cell lysis. Nevertheless, formation of elemental selenium nanoparticles under aerobic conditions by B. fungorum DBT1 and B. fungorum 95 is likely due to intracellular reduction mechanisms. Biomedical and other high tech sectors might exploit these biogenic nanoparticles in the near future, once fully characterized and tested for their multiple properties.

Impact of microwave irradiation on cyclo-octeno-1,2,3-selenadiazole: formation of selenium nanoparticles and their polymorphs

In this work a one-pot microwave assisted synthesis of selenium nanoparticles and their different forms, by decomposition of cyclo-octeno-1,2,3-selenadiazole is described first ever time.

Delayed formation of zero-valent selenium nanoparticles by Bacillus mycoides SeITE01 as a consequence of selenite reduction under aerobic conditions

BACKGROUND

Selenite (SeO32-) oxyanion shows severe toxicity to biota. Different bacterial strains exist that are capable of reducing SeO32- to non-toxic elemental selenium (Se0), with the formation of Se nanoparticles (SeNPs). These SeNPs might be exploited for technological applications due to their physico-chemical and biological characteristics. The present paper discusses the reduction of selenite to SeNPs by a strain of Bacillus sp., SeITE01, isolated from the rhizosphere of the Se-hyperaccumulator legume Astragalus bisulcatus.

RESULTS

Use of 16S rRNA and GyrB gene sequence analysis positioned SeITE01 phylogenetically close to B. mycoides. On agarized medium, this strain showed rhizoid growth whilst, in liquid cultures, it was capable of reducing 0.5 and 2.0 mM SeO32- within 12 and 24 hours, respectively. The resultant Se0 aggregated to form nanoparticles and the amount of Se0 measured was equivalent to the amount of selenium originally added as selenite to the growth medium. A delay of more than 24 hours was observed between the depletion of SeO32 and the detection of SeNPs. Nearly spherical-shaped SeNPs were mostly found in the extracellular environment whilst rarely in the cytoplasmic compartment. Size of SeNPs ranged from 50 to 400 nm in diameter, with dimensions greatly influenced by the incubation times. Different SeITE01 protein fractions were assayed for SeO32- reductase capability, revealing that enzymatic activity was mainly associated with the membrane fraction. Reduction of SeO32- was also detected in the supernatant of bacterial cultures upon NADH addition.

CONCLUSIONS

The selenite reducing bacterial strain SeITE01 was attributed to the species Bacillus mycoides on the basis of phenotypic and molecular traits. Under aerobic conditions, the formation of SeNPs were observed both extracellularly or intracellularly. Possible mechanisms of Se0 precipitation and SeNPs assembly are suggested. SeO32- is proposed to be enzymatically reduced to Se0 through redox reactions by proteins released from bacterial cells. Sulfhydryl groups on peptides excreted outside the cells may also react directly with selenite. Furthermore, membrane reductases and the intracellular synthesis of low molecular weight thiols such as bacillithiols may also play a role in SeO32- reduction. Formation of SeNPs seems to be the result of an Ostwald ripening mechanism.

Surface decoration by Spirulina polysaccharide enhances the cellular uptake and anticancer efficacy of selenium nanoparticles

A simple and solution-phase method for functionalization of selenium nanoparticles (SeNPs) with Spirulina polysaccharides (SPS) has been developed in the present study. The cellular uptake and anticancer activity of SPS-SeNPs were also evaluated. Monodisperse and homogeneous spherical SPS-SeNPs with diameters ranging from 20 nm to 50 nm were achieved under optimized conditions, which were stable in the solution phase for at least 3 months. SPS surface decoration significantly enhanced the cellular uptake and cytotoxicity of SeNPs toward several human cancer cell lines. A375 human melanoma cells were found extremely susceptible to SPS-SeNPs with half maximal (50%) inhibitory concentration value of 7.94 μM. Investigation of the underlying mechanisms revealed that SPS-SeNPs inhibited cancer cell growth through induction of apoptosis, as evidenced by an increase in sub-G(1) cell population, deoxyribonucleic acid fragmentation, chromatin condensation, and phosphatidylserine translocation. Results suggest that the strategy to use SPS as a surface decorator could be an effective way to enhance the cellular uptake and anticancer efficacy of nanomaterials. SPS-SeNPs may be a potential candidate for further evaluation as a chemopreventive and chemotherapeutic agent against human cancers.